參數資料
型號: ASDX100A24R-DO
廠商: HONEYWELL SENSING AND CONTROL
元件分類: 壓力傳感器
英文描述: ABSOLUTE, PEIZORESISTIVE PRESSURE SENSOR, 0-100Psi, 2%, 19A-E66, RECTANGULAR, THROUGH HOLE MOUNT
封裝: DIP-8
文件頁數: 1/6頁
文件大小: 296K
代理商: ASDX100A24R-DO
Microstructure Pressure Sensors
0 psi to 1 psi through 0 psi to 100 psi
ASDX DO Series
Sensing and Control
FEATURES
Available in Absolute,
Differential and Gage types
Calibrated and temperature
compensated output
Pressure ranges from
0 psi to 1 psi through
0 psi to 100 psi
Response time 8 ms
Standard DIP package
ASIC Enhanced Output
I2C Compatible Protocol
Temperature Compensated
TYPICAL APPLICATIONS
Flow calibrators
Ventilation and air flow
monitors
Gas flow instrumentation
Dialysis equipment
Sleep apnea monitoring and
therapy equipment
HVAC Controls
Barometry
Pneumatic Controls
WARNING
PERSONAL INJURY
DO NOT USE these
products as safety or
emergency stop devices or
in any other application
where failure of the product
could result in personal
injury.
Failure to comply with
these instructions could
result in death or serious
injury.
The ASDX DO series pressure sensors are fully calibrated and temperature
compensated with on-board Application Specific Integrated Circuitry (ASIC).
This ASDX DO device is in a standard DIP package and provides digital
correction of sensor offset, sensitivity, temperature coefficients and non-
linearity. The ASDX family uses I
2C compatible protocol, which allows easy
interfacing to most commonly used microcontrollers and microprocessors
without additional components or electronic circuitry.
The 2-wire I
2C interface has a Serial Clock Line (SCL) input and serial digital
output data line. The output of the device is a corrected pressure value in
hexadecimal format with 12-bit accuracy. Devices are available to measure
absolute, differential, and gage pressures. The absolute devices have an
internal vacuum reference and an output proportional to absolute pressure.
Differential devices allow application of pressure to either side of the sensing
diaphragm and can be used for gage or differential measurements.
All ASDX DO devices are accurate to within
± 2.0 % full scale. The devices
are characterized for operation from a single 5 Vdc supply. The sensor is
designed and manufactured according to standards laid down in ISO 9001.
These devices are intended for use with non-corrosive, non-ionic working
fluids such as air and dry gases.
Contact your local Honeywell representative, or got to the Honeywell website
at www.honeywell.com/sensing for additional product information.
WARNING
MISUSE OF DOCUMENTATION
The information presented in this product sheet is for reference only. Do
not use this document as a product installation guide.
Complete installation, operation, and maintenance information is
provided in the instructions supplied with each product.
Failure to comply with these instructions could result in death or
serious injury.
相關PDF資料
PDF描述
ASDXL05D44D-DO DIFFERENTIAL, PEIZORESISTIVE PRESSURE SENSOR, 0-0.18Psi, 2.5%, RECTANGULAR, THROUGH HOLE MOUNT
ASI10807 UHF BAND, Si, NPN, RF SMALL SIGNAL TRANSISTOR
ASL670 YAGI ANTENNA
ASL2010 YAGI ANTENNA
ASP-1495 150 MHz - 512 MHz MOBILE STATION ANTENNA, 2.15 dBi GAIN
相關代理商/技術參數
參數描述
ASDX100D24D 制造商:未知廠家 制造商全稱:未知廠家 功能描述:0 TO 1 PSI THROUGH 0 TO 100 PSI PRESSURE TRANSDUCERS SenSym ICT
ASDX100D24H 制造商:未知廠家 制造商全稱:未知廠家 功能描述:0 TO 1 PSI THROUGH 0 TO 100 PSI PRESSURE TRANSDUCERS SenSym ICT
ASDX100D24M 制造商:未知廠家 制造商全稱:未知廠家 功能描述:0 TO 1 PSI THROUGH 0 TO 100 PSI PRESSURE TRANSDUCERS SenSym ICT
ASDX100D24R 制造商:未知廠家 制造商全稱:未知廠家 功能描述:0 TO 1 PSI THROUGH 0 TO 100 PSI PRESSURE TRANSDUCERS SenSym ICT
ASDX100D44D 功能描述:板上安裝壓力/力傳感器 ASDX RoHS:否 制造商:Honeywell 工作壓力:0 bar to 4 bar 壓力類型:Gage 準確性:+ / - 0.25 % 輸出類型:Digital 安裝風格:Through Hole 工作電源電壓:5 V 封裝 / 箱體:SIP 端口類型:Dual Radial Barbed, Same sides