- 您現在的位置：買賣IC網 > PDF目錄362742 > EP7211 (Cirrus Logic, Inc.) HIGH-PERFORMANCE ULTRA-LOW-POWER SYSTEM-ON-CHIP WITH LCD CONTROLLER PDF資料下載
參數資料
| 型號： | EP7211 |
| 廠商： | Cirrus Logic, Inc. |
| 英文描述： | HIGH-PERFORMANCE ULTRA-LOW-POWER SYSTEM-ON-CHIP WITH LCD CONTROLLER |
| 中文描述： | 高性能超低功耗系統與LCD控制器芯片 |
| 文件頁數： | 60/166頁 |
| 文件大?。?/td> | 2623K |
| 代理商： | EP7211 |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁第42頁第43頁第44頁第45頁第46頁第47頁第48頁第49頁第50頁第51頁第52頁第53頁第54頁第55頁第56頁第57頁第58頁第59頁當前第60頁第61頁第62頁第63頁第64頁第65頁第66頁第67頁第68頁第69頁第70頁第71頁第72頁第73頁第74頁第75頁第76頁第77頁第78頁第79頁第80頁第81頁第82頁第83頁第84頁第85頁第86頁第87頁第88頁第89頁第90頁第91頁第92頁第93頁第94頁第95頁第96頁第97頁第98頁第99頁第100頁第101頁第102頁第103頁第104頁第105頁第106頁第107頁第108頁第109頁第110頁第111頁第112頁第113頁第114頁第115頁第116頁第117頁第118頁第119頁第120頁第121頁第122頁第123頁第124頁第125頁第126頁第127頁第128頁第129頁第130頁第131頁第132頁第133頁第134頁第135頁第136頁第137頁第138頁第139頁第140頁第141頁第142頁第143頁第144頁第145頁第146頁第147頁第148頁第149頁第150頁第151頁第152頁第153頁第154頁第155頁第156頁第157頁第158頁第159頁第160頁第161頁第162頁第163頁第164頁第165頁第166頁
EP7211
High-Performance Ultra-Low-Power System-on-Chip with LCD Controller
60
Functional Description
DS352PP3
JUL 2001
This interface has no local buffering capability and is only intended to be used with low bandwidth
interfaces, such as for a touch-screen ADC interface.
3.8.4
Master/Slave SSI2 (Synchronous Serial Interface 2)
A second SPI/Microwire interface with full master/slave capability is provided by the EP7211. Data
rates in slave mode are theoretically up to 512 kbps, full duplex, although continuous operation at
this data rate will give an interrupt rate of 2 kHz, which is too fast for many operating systems. This
would require a worst case interrupt response time of less than 0.5 ms and would cause loss of data
through TX underruns and RX overruns.
The interface is fully capable of being clocked at 512 kHz when in slave mode. However, it is
anticipated that external hardware will be used to frame the data into packets. Therefore, although
the data would be transmitted at a rate of 512 kbps, the sustained data rate would in fact only be 85.3
kbps (i.e., 1 byte every 750
μ
s). At this data rate, the required interrupt rate will be greater than the
1 ms, which is acceptable.
There are separate half-word-wide RX and TX FIFOs (16 half-words each) and corresponding
interrupts which are generated when the FIFO
’
s are half-full or half-empty as appropriate. The
interrupts are called SS2RX and SS2TX, respectively. Register SS2DR is used to access the FIFOs.
There are five pins to support this SSI port:
SSIRXDA
,
SSITXFR
,
SSICLK
,
SSITXDA
, and
SSIRXFR
. The
SSICLK
,
SSIRXDA
,
SSIRXFR
, and
SSITXFR
signals are inputs and the
SSITXDA
signal is an output in slave mode. In the master mode,
SSICLK
,
SSITXDA
,
SSITXFR
,
and
SSIRXFR
are outputs and
SSIRXDA
is an input. Master mode is enabled by writing a one to
the
SS2MAEN
bit (SYSCON2[9]). When the master/slave SSI is not required, to save power it can
be disabled by writing a zero to the SS2TXEN and the SS2RXEN bits also within the system control
register 2 (SYSCON2[4] [7]). When set, these two bits independently enable the transmit and receive
sides of the interface.
The master/slave SSI is synchronous, full duplex, and capable of supporting serial data transfers
between two nodes. Although the interface is byte-oriented, data is loaded in blocks of two bytes at
a time. Each data byte to be transferred is marked by a frame sync pulse, lasting one clock period,
and located one clock prior to the first bit being transferred. Direction of the SSI2 ports, in slave
mode, is shown in
Figure 3-7. SSI2 Port Directions in Slave and Master Mode
.
Figure 3-7. SSI2 Port Directions in Slave and Master Mode
Slave 7211
SSIRXFR
SSITXFR
SSICLK
SSIRXDA
SSITXDA
Master 7211
SSIRXFR
SSITXFR
SSICLK
SSITXDA
SSIRXDA
相關PDF資料 |
PDF描述 |
|---|---|
| EP7211-CP-A | HIGH-PERFORMANCE ULTRA-LOW-POWER SYSTEM-ON-CHIP WITH LCD CONTROLLER |
| EP7211-CV-A | HIGH-PERFORMANCE ULTRA-LOW-POWER SYSTEM-ON-CHIP WITH LCD CONTROLLER |
| EP7212 | HIGH-PERFORMANCE, LOW-POWER SYSTEM-ON-CHIP WITH LCD CONTROLLER AND DIGITAL AUDIO INTERFACE(DAI) |
| EP7212-CB-A | HIGH-PERFORMANCE, LOW-POWER SYSTEM-ON-CHIP WITH LCD CONTROLLER AND DIGITAL AUDIO INTERFACE(DAI) |
| EP7212-CV-A | HIGH-PERFORMANCE, LOW-POWER SYSTEM-ON-CHIP WITH LCD CONTROLLER AND DIGITAL AUDIO INTERFACE(DAI) |
相關代理商/技術參數 |
參數描述 |
|---|---|
| EP7211(208LQFP) | 制造商:未知廠家 制造商全稱:未知廠家 功能描述:Logic IC |
| EP7211(256PBGA) | 制造商:未知廠家 制造商全稱:未知廠家 功能描述:Logic IC |
| EP7211-CB-D | 制造商:Rochester Electronics LLC 功能描述:- Bulk |
| EP7211-CP-A | 制造商:CIRRUS 制造商全稱:Cirrus Logic 功能描述:HIGH-PERFORMANCE ULTRA-LOW-POWER SYSTEM-ON-CHIP WITH LCD CONTROLLER |
| EP7211-CV-A | 制造商:CIRRUS 制造商全稱:Cirrus Logic 功能描述:HIGH-PERFORMANCE ULTRA-LOW-POWER SYSTEM-ON-CHIP WITH LCD CONTROLLER |
發布緊急采購，3分鐘左右您將得到回復。