參數資料
型號： EP7212
廠商： Cirrus Logic, Inc.
英文描述： HIGH-PERFORMANCE, LOW-POWER SYSTEM-ON-CHIP WITH LCD CONTROLLER AND DIGITAL AUDIO INTERFACE(DAI)
中文描述： 高性能，低功耗系統與LCD控制器和數字音頻接口（DAI芯片）
文件頁數： 49/136頁
文件大小： 2289K
代理商： EP7212
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁第42頁第43頁第44頁第45頁第46頁第47頁第48頁當前第49頁第50頁第51頁第52頁第53頁第54頁第55頁第56頁第57頁第58頁第59頁第60頁第61頁第62頁第63頁第64頁第65頁第66頁第67頁第68頁第69頁第70頁第71頁第72頁第73頁第74頁第75頁第76頁第77頁第78頁第79頁第80頁第81頁第82頁第83頁第84頁第85頁第86頁第87頁第88頁第89頁第90頁第91頁第92頁第93頁第94頁第95頁第96頁第97頁第98頁第99頁第100頁第101頁第102頁第103頁第104頁第105頁第106頁第107頁第108頁第109頁第110頁第111頁第112頁第113頁第114頁第115頁第116頁第117頁第118頁第119頁第120頁第121頁第122頁第123頁第124頁第125頁第126頁第127頁第128頁第129頁第130頁第131頁第132頁第133頁第134頁第135頁第136頁
EP7212
DS474PP1
49
3.16
The EP7212 contains a 32-bit Real Time Clock
(RTC). This can be written to and read from in the
same way as the timer counters, but it is 32 bits
wide. The RTC is always clocked at 1 Hz, generat-
ed from the 32.768 kHz oscillator. It also contains
a 32-bit output match register, this can be pro-
grammed to generate an interrupt when the time in
the RTC matches a specific time written to this reg-
ister. The RTC can only be reset by an nPOR cold
reset. Because the RTC data register is updated
from the 1 Hz clock derived from the 32 kHz
source, which is asynchronous to the main memory
system clock, the data register should always be
read twice to ensure a valid and stable reading. This
also applies when reading back the RTCDIV field
of the SYSCON1 register, which reflects the status
of the six LSBs of the RTC counter.
3.16.1
Characteristics of the Real Time
Clock Interface
Real Time Clock
When connecting a crystal to the RTC interface
pins (i.e., RTCIN and RTCOUT), the crystal and
circuit should conform to the following require-
ments:
The 32.768 kHz frequency should be created
by the crystals fundamental tone (i.e., it should
be a fundamental mode crystal)
A start-up resistor is not necessary, since one is
provided internally.
Start-up loading capacitors may be placed on
each side of the external crystal and ground.
Their value should be in the range of 10 pF.
However, their values should be selected based
upon the crystal specifications. The total sum of
the capacitance of the traces between the
EP7212’s clock pins, the capacitors, and the
crystal leads should be subtracted from the
crystal’s specifications when determining the
values for the loading capacitors.
The crystal should have a maximum 5 ppm fre-
quency drift over the chip’s operating tempera-
ture range.
The voltage for the crystal must be 2.5 V + 0.2 V.
Alternatively, a digital clock source can be used to
drive the RTCIN pin of the EP7212. With this ap-
proach, the voltage levels of the clock source
should match that of the V
DD
supply for the
EP7212’s pads (i.e., the supply voltage level used
to drive all of the non-V
DD
core pins on the
EP7212) (i.e., RTCOUT). The output clock pin
should be left floating.
3.17
The LED flasher feature enables an external pin
(PD[0] / LEDFLSH) to be toggled at a programma-
ble rate and duty ratio, with the intention that the
external pin is connected to an LED. This module
is driven from the RTCs 32.768 kHz oscillator and
works in all running modes because no CPU inter-
vention is needed once its rate and duty ratio have
been configured (via the LEDFLSH register). The
LED flash rate period can be programmed for 1, 2,
3, or 4 seconds. The duty ratio can be programmed
such that the mark portion can be 1/16, 2/16…
16/16 of the full cycle. The external pin can provide
up to 4 mA of drive current.
Dedicated LED Flasher
3.18
Two Pulse Width Modulator (PWM) duty ratio
clock outputs are provided by the EP7212. When
the device is operating from the internal PLL, the
PWM will run at a frequency of 96 kHz. These sig-
nals are intended for use as drives for external DC-
to-DC converters in the Power Supply Unit (PSU)
subsystem. External input pins that would normally
be connected to the output from comparators mon-
itoring the external DC-to-DC converter output are
also used to enable these clocks. These are the
FB[0:1] pins. The duty ratio (and hence PWMs on
time) can be programmed from 1 in 16 to 15 in 16.
The sense of the PWM drive signal (active high or
Two PWM Interfaces
相關PDF資料
PDF描述
EP7212-CB-A HIGH-PERFORMANCE, LOW-POWER SYSTEM-ON-CHIP WITH LCD CONTROLLER AND DIGITAL AUDIO INTERFACE(DAI)
EP7212-CV-A HIGH-PERFORMANCE, LOW-POWER SYSTEM-ON-CHIP WITH LCD CONTROLLER AND DIGITAL AUDIO INTERFACE(DAI)
EP7309 HIGH PERFORMANCE LOW POWER SYSTEM ON CHIP ENHANCED DIGITAL AUDIO INTERFACE
EP7309-CB-C CONN MODULAR JACK 8-8 R/A UNSHLD
EP7309-CR-C HIGH PERFORMANCE LOW POWER SYSTEM ON CHIP ENHANCED DIGITAL AUDIO INTERFACE
相關代理商/技術參數
參數描述
EP7212-CB-A 制造商:CIRRUS 制造商全稱:Cirrus Logic 功能描述:HIGH-PERFORMANCE, LOW-POWER SYSTEM-ON-CHIP WITH LCD CONTROLLER AND DIGITAL AUDIO INTERFACE(DAI)
EP7212-CV-A 制造商:CIRRUS 制造商全稱:Cirrus Logic 功能描述:HIGH-PERFORMANCE, LOW-POWER SYSTEM-ON-CHIP WITH LCD CONTROLLER AND DIGITAL AUDIO INTERFACE(DAI)
EP7212-CV-D 制造商:Rochester Electronics LLC 功能描述:- Bulk
EP7230 功能描述:電氣外殼配件 E-PANEL FITS 72 X 30 RoHS:否 制造商:Hammond Manufacturing 產品:Rack Accessories 類型: 面板寬度: 面板高度: 外部寬度: 外部高度: 外部深度: 顏色:Black
EP7236 功能描述:電氣外殼配件 E-PANEL FITS 72 X 36 RoHS:否 制造商:Hammond Manufacturing 產品:Rack Accessories 類型: 面板寬度: 面板高度: 外部寬度: 外部高度: 外部深度: 顏色:Black
發布緊急采購，3分鐘左右您將得到回復。

采購需求

(若只采購一條型號，填寫一行即可)

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

*型號 *數量 廠商 批號 封裝
添加更多采購

我的聯系方式

*
*
*