- 您現在的位置：買賣IC網 > PDF目錄362803 > EVAL-ADF7012EB4 (Analog Devices, Inc.) Multichannel ISM Band FSK/GFSK/OOK/GOOK/ASK Transmitter PDF資料下載
參數資料
| 型號： | EVAL-ADF7012EB4 |
| 廠商： | Analog Devices, Inc. |
| 英文描述： | Multichannel ISM Band FSK/GFSK/OOK/GOOK/ASK Transmitter |
| 中文描述： | 多通道ISM頻段FSK信號/的GFSK /元件Ook /約克/ ASK發射 |
| 文件頁數： | 16/28頁 |
| 文件大?。?/td> | 772K |
| 代理商： | EVAL-ADF7012EB4 |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁當前第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁
ADF7012
OUTPUT DIVIDER
An output divider is a programmable divider following the
VCO in the PLL loop. It is useful when using the ADF7012 to
generate frequencies of < 500 MHz.
Rev. 0 | Page 16 of 28
0
PFD
CP
PA
OUTPUT
DIVIDER
÷
1/2/4/8
LOOP
FILTER
REFERENCE
DIVIDER
÷
N
VCO
Figure 35. Output Divider Location in PLL.
The output divider may be used to reduce feedthrough of the
VCO by amplifying only the VCO/2 component, restricting the
VCO feedthrough to leakage.
Because the divider is in loop, the N register values should be
set up according to the usual formula. However, the VCO gain
(K
V
) should be scaled according to the divider setting, as shown
in the following example.
Fout = 433 MHz, Fvco = 866 MHz, K
V
@ 868 MHz =
60 MHz/V
Therefore, K
V
for loop filter design = 30 MHz/V.
The divider value is set in the R register.
Table 5.
OD1
0
0
1
1
MUXOUT MODES
The MUXOUT pin allows the user access to various internal
signals in the transmitter, and provides information on the
PLL lock status, the regulator, and the battery voltage. The
MUXOUT is accessed by programming Bits M1 to M4 in the
function register and observing the signal at the MUXOUT pin.
OD2
0
1
0
1
Divider Status
Divider off
Divide by 2
Divide by 4
Divide by 8
Battery Voltage Read back
By setting MUXOUT to 1010 to 1101, the battery voltage can be
estimated. The battery measuring circuit features a voltage
divider and a comparator where the divided-down supply
voltage is compared to the regulator voltage.
Table 6.
MUXOUT
MUXOUT High
1010
DV
DD
> 3.25 V
1011
DV
DD
> 3.0 V
1100
DV
DD
> 2.75 V
1101
DV
DD
> 2.35 V
MUXOUT Low
DV
DD
< 3.25 V
DV
DD
< 3.0 V
DV
DD
< 2.75 V
DV
DD
< 2.35 V
The accuracy of the measurement is limited by the accuracy of
the regulator voltage and also the internal resistor tolerances.
Regulator Ready
The regulator has a power-up time, dependant on process and
the external capacitor. The regulator ready signal indicates that
the regulator is fully powered, and that the serial interface is
active. This is the default setting on power-up at MUXOUT.
Digital Lock Detect
Digital lock detect indicates that the status of the PLL loop.
The PLL loop takes time to settle on power-up and when the
frequency of the loop is changed by changing the N value.
When lock detect is high, the PFD has counted a number of
consecutive cycles where the phase error is < 15 ns. The lock
detect precision bit in the function register determines whether
this is 3 cycles (LDP = 0), or 5 cycles (LDP=1). It is recom-
mended that LDP be set to 1. The lock detect is not completely
accurate and goes high before the output has settled to exactly
the correct frequency. In general, add 50% to the indicated
lock time to obtain lock time to within 1 kHz. The lock detect
should be enabled.
R Divider
MUXOUT provides the output of the R divider. This is a
narrow pulsed digital signal at frequency F
PFD
. This signal may
be used to check the operation of the crystal circuit and the R
divider. R divider/2 is a buffered version of this signal at F
PFD
/2.
相關PDF資料 |
PDF描述 |
|---|---|
| EVAL-ADF7012EB5 | Multichannel ISM Band FSK/GFSK/OOK/GOOK/ASK Transmitter |
| EVAL-ADG936-REB | Wideband 4 GHz, 36 dB Isolation at 1 GHz, CMOS 1.65 V to 2.75 V, Dual SPDT |
| EVAL-ADG936EB | Wideband 4 GHz, 36 dB Isolation at 1 GHz, CMOS 1.65 V to 2.75 V, Dual SPDT |
| EVAL-ADM1022 | Evaluation Board for Microprocessor System Temperature Monitor |
| EVAL-ADM1023 | Evaluation Board for Microprocessor System Temperature Monitor |
相關代理商/技術參數 |
參數描述 |
|---|---|
| EVAL-ADF7012EB5 | 制造商:AD 制造商全稱:Analog Devices 功能描述:Multichannel ISM Band FSK/GFSK/OOK/GOOK/ASK Transmitter |
| EVAL-ADF7020-1DBZ4 | 功能描述:BOARD EVAL ADF7020-1 405-435MHZ RoHS:是 類別:RF/IF 和 RFID >> RF 評估和開發套件，板 系列:- 標準包裝:1 系列:- 類型:GPS 接收器 頻率:1575MHz 適用于相關產品:- 已供物品:模塊 其它名稱:SER3796 |
| EVAL-ADF7020-1DBZ5 | 功能描述:BOARD EVAL ADF7020-2 ADJ FREQ RoHS:是 類別:RF/IF 和 RFID >> RF 評估和開發套件，板 系列:- 標準包裝:1 系列:- 類型:GPS 接收器 頻率:1575MHz 適用于相關產品:- 已供物品:模塊 其它名稱:SER3796 |
| EVAL-ADF7020-1DBZ6 | 功能描述:BOARD EVAL ADF7020-1 470-510MHZ RoHS:是 類別:RF/IF 和 RFID >> RF 評估和開發套件，板 系列:- 標準包裝:1 系列:- 類型:GPS 接收器 頻率:1575MHz 適用于相關產品:- 已供物品:模塊 其它名稱:SER3796 |
| EVAL-ADF7020-1DBZ7 | 功能描述:BOARD EVAL ADF7020-1 310-340MHZ RoHS:是 類別:RF/IF 和 RFID >> RF 評估和開發套件，板 系列:- 標準包裝:1 系列:- 類型:GPS 接收器 頻率:1575MHz 適用于相關產品:- 已供物品:模塊 其它名稱:SER3796 |
發布緊急采購，3分鐘左右您將得到回復。