- 您現在的位置：買賣IC網 > PDF目錄362803 > EVAL-CONTROLBRD2 (Analog Devices, Inc.) 4-Channel, 1.5 MSPS, 12-Bit and 10-Bit Parallel ADCs with a Sequencer PDF資料下載
參數資料
| 型號： | EVAL-CONTROLBRD2 |
| 廠商： | Analog Devices, Inc. |
| 元件分類： | ADC |
| 英文描述： | 4-Channel, 1.5 MSPS, 12-Bit and 10-Bit Parallel ADCs with a Sequencer |
| 中文描述： | 4通道，1.5 MSPS的12位和10位并行ADC的一個序列 |
| 文件頁數： | 12/32頁 |
| 文件大?。?/td> | 1253K |
| 代理商： | EVAL-CONTROLBRD2 |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁當前第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁
AD7933/AD7934
Preliminary Technical Data
Total Harmonic Distortion (THD)
THD is the ratio of the rms sum of harmonics to the
fundamental. For the AD7933/AD7934, it is defined as
(
)
1
6
5
4
3
2
V
V
V
V
V
V
THD
2
2
2
2
2
20log
dB
+
+
+
+
=
where
V
1
is the rms amplitude of the fundamental and
V
2
,
V
3
,
V
4
,
V
5
, and
V
6
are the rms amplitudes of the second through the
sixth harmonics.
Peak Harmonic or Spurious Noise
Peak harmonic or spurious noise is defined as the ratio of the
rms value of the next largest component in the ADC output
spectrum (up to f
S
/2 and excluding dc) to the rms value of the
fundamental. Normally, the value of this specification is
determined by the largest harmonic in the spectrum, but for
ADCs where the harmonics are buried in the noise floor, it will
be a noise peak
Intermodulation Distortion
With inputs consisting of sine waves at two frequencies, fa and
fb, any active device with nonlinearities will create distortion
products at sum and difference frequencies of mfa ± nfb where
m, n = 0, 1, 2, 3, etc. Intermodulation distortion terms are those
for which neither m nor n are equal to zero. For example, the
second-order terms include (fa + fb) and (fa fb), while the
third-order terms include (2fa + fb), (2fa fb), (fa + 2fb) and (fa
2fb).
The AD7933/AD7934 is tested using the CCIF standard where
two input frequencies near the top end of the input bandwidth
are used. In this case, the second-order terms are usually
distanced in frequency from the original sine waves, while the
third-order terms are usually at a frequency close to the input
frequencies. As a result, the second- and third-order terms are
specified separately. The calculation of the intermodulation
distortion is as per the THD specification where it is the ratio of
the rms sum of the individual distortion products to the rms
amplitude of the sum of the fundamentals expressed in dBs.
Rev. PrG | Page 12 of 32
相關PDF資料 |
PDF描述 |
|---|---|
| EVAL-AD7940CB | 3mW, 100kSPS, 14-Bit ADC in 6-Lead SOT-23 |
| EVAL-AD974CB | AD974 4-Channel, 16-Bit, 200 kSPS ADC(四通道,200kSPS,16位A/D轉換器,AD974的評估板) |
| EVAL-AD9831EB | CMOS Complete DDS |
| EVAL-AD9833EB | +2.5 V to +5.5 V, 25 MHz Low Power CMOS Complete DDS |
| EVAL-AD9834EB | Low Power, +2.3 V to +5.5 V, 50 MHz Complete DDS |
相關代理商/技術參數 |
參數描述 |
|---|---|
| EVAL-CONTROL-BRD2 | 制造商:AD 制造商全稱:Analog Devices 功能描述:4-Channel, 1.5 MSPS, 10-Bit and 12-Bit Parallel ADCs with a Sequencer |
| EVAL-CONTROLBRD22 | 制造商:AD 制造商全稱:Analog Devices 功能描述:Differential Input, Dual 2 MSPS, 12-Bit, 3-Channel SAR ADC |
| EVALCONTROLBRD23 | 制造商:AD 制造商全稱:Analog Devices 功能描述:1.75 MSPS, 4 mW 10-Bit/12-Bit Parallel ADCs |
| EVAL-CONTROLBRD23 | 制造商:AD 制造商全稱:Analog Devices 功能描述:Pseudo Differential, 555 kSPS, 12-Bit ADC in an 8-Lead SOT-23 |
| EVAL-CONTROLBRD24 | 制造商:AD 制造商全稱:Analog Devices 功能描述:1 MSPS, 12-Bit ADCs |
發布緊急采購，3分鐘左右您將得到回復。