- 您現在的位置：買賣IC網 > PDF目錄384457 > HWB3163 (Intersil Corporation) () PDF資料下載
參數資料
| 型號： | HWB3163 |
| 廠商： | Intersil Corporation |
| 英文描述： | () |
| 中文描述： | （） |
| 文件頁數： | 8/11頁 |
| 文件大?。?/td> | 387K |
| 代理商： | HWB3163 |
8
Test Point E
RF Transmit Signal:
The optional SMA connector can be used to hook up a
Spectrum Analyzer for RF evaluation. Note that L4 (1.5nH)
must be removed and C141 (15pF) and C37 (150pF) must
be installed to activate the connector See (Figure 3).
This is the up-converted spread spectrum output of the card.
The center frequency of this signal is 2412-2484MHz
depending on the channel of operation. The output power of
the signal is approximately +12.5dBm. The peaks of the
sidelobes of the output spectrum (i.e., the regrowth) are
normally adjusted by the ALC/AGC to be 30dB below the
peak of the spectrum per requirements of IEEE 802.11.
The following table delineates the IEEE 802.11 channels and
their corresponding center frequencies. Although information
contained in Table 1 is deemed to be accurate, local regulatory
authorities should be consulted before using such equipment.
Test Points F and G
RF local oscillator (LO):
The behavior of the RF VCO can be monitored at Test
Point F.
The VCO output should be locked at the channel frequency
minus the IF (374MHz.) This means that the VCO will have
to lock between 2038MHz and 2110MHz. The output power
at test point F is approximately -6dBm. Ideally, the tuning
voltage of the VCO, when locked, falls between 0.5V and
2.2V. The tuning voltage of the RF VCO can be observed at
Test Point G.
Test Points H and I
IF local oscillator (LO):
The IF VCO is a discrete design and operates at 748MHz
(i.e., twice the IF frequency). The output frequency of this
VCO does not need to be varied; thus, minimal tuning range
is required.
The output frequency of this VCO can be observed at Test
Point H.
Ideally, the tuning voltage of the IF VCO, when locked, falls
between 0.5V and 2.2V. The tuning voltage of the IF VCO
can be observed at Test Point I.
TABLE 1. IEEE 802.11 CHANNELS
CHANNEL
NUMBER
1
CHANNEL
FREQUENCY
2412MHz
GEOGRAPHIC
USAGE
US, CA, ETSI
2
2417MHz
US, CA, ETSI
3
2422MHz
US, CA, ETSI
4
2427MHz
US, CA, ETSI
5
2432MHz
US, CA, ETSI
6
2437MHz
US, CA, ETSI
7
2442MHz
US, CA, ETSI
8
2447MHz
US, CA, ETSI
9
2452MHz
US, CA, ETSI
10
2457MHz
US, CA, ETSI, FR, SP
11
2462MHz
US, CA, ETSI, FR, SP
12
2467MHz
ETSI, FR
13
2472MHz
ETSI, FR
Japan
14
2484MHz
KEY:
US = United States, CA = Canada, ETSI = ETSI countries
(except France and Spain), FR = France, SP = Spain.
In Japan, authorization for Channels 1 through 11 is pending.
FIGURE 7. TRANSMITTED 2.4GHz SIGNAL SPECTRUM
(TEST POINT E)
FIGURE 8. RF LOCAL OSCILLATOR OUTPUT AT CHANNEL 8
(TEST POINT F)
FIGURE 9. IF LOCAL OSCILLATOR OUTPUT (TEST POINT H)
Application Note 9864
相關PDF資料 |
PDF描述 |
|---|---|
| HWL30NC | L-Band Power FET Non-Via Hole Chip |
| HWZT-MA | INDUSTRIAL GRADE CERAMIC RESONATOR |
| HWZT-MS | INDUSTRIAL GRADE CERAMIC RESONATOR |
| HXZT | LEADED CERAMIC RESONATOR |
| HY27LF161G2M-VCP | 1Gbit (128Mx8bit / 64Mx16bit) NAND Flash Memory |
相關代理商/技術參數 |
參數描述 |
|---|---|
| HWB3163-EVAL | 制造商:INTERSIL 制造商全稱:Intersil Corporation 功能描述:PRISM II⑩ 11Mbps Wireless Local Area Network PC Card |
| HWB-AF | 功能描述:熔絲座 BUSS FUSEHOLDER RoHS:否 制造商:Littelfuse 產品: 電流額定值:30 A 電壓額定值:1000 VDC 極數:1 系列: 安裝風格:DIN Rail 端接類型: 軸類型: 工作溫度范圍: |
| HWBASEA | 制造商:HellermannTyton 功能描述:BASE HW CLIPS PK50 制造商:HellermannTyton 功能描述:BASE, HW CLIPS, PK50 制造商:HELLERMANN TYTON 功能描述:BASE, HW CLIPS, PK50; External Length:38mm; External Width:38mm; Clip Material:Nylon 6.6 (Polyamide 6.6); Clip Colour:Black; SVHC:No SVHC (19-Dec-2012); Accessory Type:Mount Clip; Colour:Black; External Length / Height:38mm; Fixing ;RoHS Compliant: Yes |
| HWBB1 | 制造商:ROEBUCK 功能描述:BOTTLE BRUSH 1/4 PINT |
| HWBB2 | 制造商:ROEBUCK 功能描述:BOTTLE BRUSH 1/2 PINT |
發布緊急采購，3分鐘左右您將得到回復。