- 您現在的位置：買賣IC網 > PDF目錄379205 > IBM13M8734HCD (IBM Microeletronics) 8M x 72 1 Bank Registered/Buffered SDRAM Module(8M x 72 1組寄存/緩沖同步動態RAM模塊) PDF資料下載
參數資料
| 型號： | IBM13M8734HCD |
| 廠商： | IBM Microeletronics |
| 英文描述： | 8M x 72 1 Bank Registered/Buffered SDRAM Module(8M x 72 1組寄存/緩沖同步動態RAM模塊) |
| 中文描述： | 8米× 72 1銀行注冊/緩沖內存模組（8米× 72 1組寄存/緩沖同步動態內存模塊） |
| 文件頁數： | 1/21頁 |
| 文件大?。?/td> | 339K |
| 代理商： | IBM13M8734HCD |
IBM13M8734HCD
8M x 72 1 Bank Registered/Buffered SDRAM Module
19L7291.E93875A
8/99
IBM Corporation. All rights reserved.
Use is further subject to the provisions at the end of this document.
Page 1 of 21
Features
168-Pin Registered 8-Byte Dual In-Line Memory
Module
8Mx72 Synchronous DRAM DIMM
Performance:
-10
Device Latency
3
Clock Frequency
66
Clock Access Time
8.2
Intended for 66/100MHz and PC100 applica-
tions
Inputs and outputs are LVTTL (3.3V) compatible
Single 3.3V
±
0.3V Power Supply
Single Pulsed RAS interface
SDRAMs have four internal banks
Module has one physical bank
Fully Synchronous to positive Clock Edge
Programmable Operation:
- DIMM CAS Latency:3, 4 (Registered
mode),
- Burst Type: Sequential or Interleave
- Burst Length: 1, 2, 4, 8, Full-Page (Full-
Page supports Sequential burst only)
- Operation: Burst Read and Write
or Multiple Burst Read with Single Write
Data Mask for Byte Read/Write control
Auto Refresh (CBR) and Self Refresh
Automatic and controlled Precharge Commands
Suspend Mode and Power Down Mode
12/9/2 Addressing (Row/Column/Bank)
4096 refresh cycles distributed across 64ms
Card size: 5.25" x 1.5" x 0.157"
Gold contacts
SDRAM
S
in TSOP - Type II Package
Serial Presence Detect with Write protect feature
2, 3 (Buffered mode)
Description
IBM13M8734HCD is a registered 168-Pin Synchro-
nous DRAM Dual In-Line Memory Module (DIMM)
organized as an 8Mx72 high-speed memory array.
The DIMM uses nine 8Mx8 SDRAMs in 400 mil
TSOP packages. The DIMM achieves high-speed
data-transfer rates of up to 100 MHz by employing a
prefetch/pipeline hybrid architecture that synchro-
nizes the output data to a system clock.
The DIMM is intended for use in applications oper-
ating from 66MHz to 100 MHz, PC100, memory bus
speeds, and/or heavily loaded bus applications. All
control and address signals are re-driven through
registers/buffers to the SDRAM devices. The DIMM
can be operated in either registered mode (REGE
pin tied high), where the control/address input sig-
nals are latched in the register on one rising clock
edge and sent to the SDRAM devices on the follow-
ing rising clock edge (data access is delayed by one
clock), or in buffered mode (REGE pin tied low)
where the input signals pass through the regis-
ter/buffer to the SDRAM devices on the same clock.
XTK simulation models of the DIMM are available to
determine which mode to design for.
A phase-lock loop (PLL) on the DIMM is used to re-
drive the clock signals to the SDRAM devices to
minimize system clock loading. (CK0 is connected
to the PLL, and CK1, CK2, and CK3 are terminated
on the DIMM.) A single clock enable (CKE0) con-
trols all devices on the DIMM, enabling the use of
SDRAM power-down modes.
Prior to any access operation, the device CAS
latency and burst type/length/operation type must
be programmed into the DIMM by address inputs
A0-A9 using the mode register set cycle. The DIMM
CAS latency when operated in buffered mode is the
same as the device CAS latency as specified in the
SPD EEPROM. The DIMM CAS latency when oper-
ated in registered mode is one clock later due to the
address and control signals being clocked to the
SDRAM devices.
The DIMM uses serial presence detects imple-
mented via a serial EEPROM using the two-pin IIC
protocol. The first 128 bytes of serial PD data are
programmed and locked by the DIMM manufac-
turer. The last 128 bytes are available to the cus-
tomer and may be write protected by providing a
high level to pin 81 on the DIMM. An on-board pull-
down resistor keeps this in the write-enable mode.
All IBM 168-pin DIMMs provide a high-performance,
flexible 8-byte interface in a 5.25" long space-saving
footprint.
-260
2
100
7.2
-360
2
66
10.2
-360 Units
3
100
7.2
MHz
ns
.
Discontinued (4/1/00 - last order; 7/31/00 - last ship)
相關PDF資料 |
PDF描述 |
|---|---|
| IBM13N16644HCB | 16M x 64 Two-Bank Unbuffered SDRAM Module(16M x 64 2組不帶緩沖同步動態RAM模塊) |
| IBM13N16734HCB | 16M x 72 Two-Bank Unbuffered SDRAM Module(16M x 72 2組不帶緩沖同步動態RAM模塊) |
| IBM13N16644HC | 16M x 64 2 Bank Unbuffered SDRAM Module(16M x 64 2組不帶緩沖同步動態RAM模塊) |
| IBM13N16734HC | 16M x 72 2 Bank Unbuffered SDRAM Module(16M x 72 2組不帶緩沖同步動態RAM模塊) |
| IBM13Q16734HCB | 16M x 72 Registered SDRAM Module(16M x 72 200腳寄存同步動態RAM模塊) |
相關代理商/技術參數 |
參數描述 |
|---|---|
| IBM14H5481 | 制造商:AVED Memory Products 功能描述: |
| IBM14H5540 | 制造商:AVED MEMORY PRODUCTS 功能描述: 制造商:AVED Memory Products 功能描述: |
| IBM17R8251 | 制造商:AVED Memory Products 功能描述: |
| IBM17R8252 | 制造商:AVED Memory Products 功能描述: |
| IBM1805T | 制造商:Schneider Electric 功能描述:IBM1805T |
發布緊急采購，3分鐘左右您將得到回復。