- 您現在的位置：買賣IC網 > PDF目錄379205 > IBM3209K3114 (IBM Microeletronics) IBM Packet Routing Switch Serial Interface Converter(IBM封裝路線選擇開關串行接口轉換器) PDF資料下載
參數資料
| 型號： | IBM3209K3114 |
| 廠商： | IBM Microeletronics |
| 英文描述： | IBM Packet Routing Switch Serial Interface Converter(IBM封裝路線選擇開關串行接口轉換器) |
| 中文描述： | IBM的分組路由交換機串行接口轉換器（IBM的封裝路線選擇開關串行接口轉換器） |
| 文件頁數： | 149/152頁 |
| 文件大小： | 2390K |
| 代理商： | IBM3209K3114 |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁第42頁第43頁第44頁第45頁第46頁第47頁第48頁第49頁第50頁第51頁第52頁第53頁第54頁第55頁第56頁第57頁第58頁第59頁第60頁第61頁第62頁第63頁第64頁第65頁第66頁第67頁第68頁第69頁第70頁第71頁第72頁第73頁第74頁第75頁第76頁第77頁第78頁第79頁第80頁第81頁第82頁第83頁第84頁第85頁第86頁第87頁第88頁第89頁第90頁第91頁第92頁第93頁第94頁第95頁第96頁第97頁第98頁第99頁第100頁第101頁第102頁第103頁第104頁第105頁第106頁第107頁第108頁第109頁第110頁第111頁第112頁第113頁第114頁第115頁第116頁第117頁第118頁第119頁第120頁第121頁第122頁第123頁第124頁第125頁第126頁第127頁第128頁第129頁第130頁第131頁第132頁第133頁第134頁第135頁第136頁第137頁第138頁第139頁第140頁第141頁第142頁第143頁第144頁第145頁第146頁第147頁第148頁當前第149頁第150頁第151頁第152頁
IBM3209K3114
Advance
IBM Packet Routing Switch Serial Interface Converter
prssi.01
July 12, 2000
Appendix B: PLL
Page 139 of 142
11. Appendix B: PLL
11.1 PLL Configuration
During Chip POR, the PLL is held reset and stays in reset mode until a software access releases the PLL
RESET bit in the register configuration table. Before starting the PLL (by releasing the PLL RESET bit), the
PLL RANGE, PLL MULT and PLL TUNE bits must be written in the PLL register. Once the PLL is started, a
poll the PLL register for PLLLOCK bit detection. When the PLLLOCK bit is detected high, the logic clocked by
the PLL is ready to work.
11.2 PLL Reset
PLL_RESET bit [15] is provided in the register configuration table @ 90, 94, 9C. PLL RANGE [bits 5-0] and
MULT [bits 31-28] bits are provided in the register configuration table @ 90, 94, 9C. PLL TUNE bits [13-8] are
provided in the register configuration table @ 90, 94, 9C. PLLLOCK bit [14] is provided in the register config-
uration table @ 90, 94, 9C.
The RESET function puts the PLL in bypass mode so the output clock is identical to the input reference clock.
RESET should be held active (high) during power-on until all of the following condition are met: All PLL inputs
are stable and at their final values. The reference clock is stable. PLL VDDA and Vdd are at their final values.
A RESET is also required should the PLL inputs change after power-on.
11.3 PLL Range and MULT
PLL RANGE [bits 5-0] and MULT [bits 31-28] are provided in the register configuration table @ 90, 94, 9C.
Use these programmable inputs to choose the output frequency of the PLL. The logic state of these inputs
must be stable before the PLL can begin to lock.
11.4 PLL Tune
PLL TUNE bits [13-8] are provided in the register configuration table @ 90, 94, 9C. These programmable
inputs are used to optimize the PLL stability and jitter. The logic state of these inputs must be stable before
the PLL can begin to lock.
11.5 PLL LOCK
PLLLOCK bit [14] is provided in the register configuration table @ 90, 94, 9C. This signal indicates when the
feedback clock is in phase with the reference clock. While RESET is high, PLLLOCK will be low. Following
reset, PLLLOCK will stay low until lock is achieved.
The PLLLOCK signal will go high less than 300 μs after:
The reference clock is stabilized at a constant frequency
The RANGE and MULT inputs are at their final states
The VDDA input is at the rail
相關PDF資料 |
PDF描述 |
|---|---|
| IBM32NPCXX1EPABBE66 | IBM Processor for Network Resources(異步轉換模式（ATM）32位微處理器（用于網絡資源管理）) |
| IBM39MPEGCS24DPFA16C | High Performance Audio/Video Decoder(高性能音頻/視頻譯碼器) |
| IBM39MPEGCS24PFA16C | High Performance Audio/Video Decoder(高性能音頻/視頻譯碼器) |
| IBM39STB130x0 | STB130x0 A/V Transport/Decoders(STB130x0 音頻/視頻的傳送譯碼器) |
| IBM42F10SNNAA20 | SFF-1063/1250N-SW PTH Serial Optical Transceiver(SFF-1063/1250N-SW PTH串行光纖收發器) |
相關代理商/技術參數 |
參數描述 |
|---|---|
| IBM3209K4060 | 制造商:未知廠家 制造商全稱:未知廠家 功能描述:Telecom Switching Circuit |
| IBM3288H2848 | 制造商:未知廠家 制造商全稱:未知廠家 功能描述:Telecommunication IC |
| IBM32NPR100EXXCAB133 | 制造商:未知廠家 制造商全稱:未知廠家 功能描述:Microprocessor |
| IBM32NPR101EPXCAC133 | 制造商:未知廠家 制造商全稱:未知廠家 功能描述:Microprocessor |
| IBM35CPC945C03C-2 | 制造商:IBM 功能描述: |
發布緊急采購，3分鐘左右您將得到回復。