- 您現在的位置：買賣IC網 > PDF目錄379205 > IBM42G12LNNAA30 (IBM Microeletronics) Gigabit Ethernet/Fibre Channel Small Form Factor PTH Transceiver(吉（10^ 9 G)位以太網/光纖通道PTH收發器) PDF資料下載
參數資料
| 型號： | IBM42G12LNNAA30 |
| 廠商： | IBM Microeletronics |
| 英文描述： | Gigabit Ethernet/Fibre Channel Small Form Factor PTH Transceiver(吉（10^ 9 G)位以太網/光纖通道PTH收發器) |
| 中文描述： | 千兆以太網/光纖通道纖巧甲狀旁腺收發器（吉（10 ^ 9政）位以太網/光纖通道甲狀旁腺收發器） |
| 文件頁數： | 5/24頁 |
| 文件大?。?/td> | 212K |
| 代理商： | IBM42G12LNNAA30 |
IBM42G12SNNAA30 IBM42G10SNNAA30
IBM42G12LNNAA30 IBM42G10LNNAA30 IBM42F12LNNAA30 IBM42F10LNNAA30
Gigabit Ethernet/Fibre Channel Small Form Factor PTH Transceiver
IBM42F12SNNAA30 IBM42F10SNNAA30
..
08/15/00
Page 5 of 23
Output Signal Definitions
Levels for the signals described in this section are listed in Receive Signal Interface on page 8 and Control
Electrical Interface on page 9.
Rx_DAT
The incoming optical signal is converted and repowered as a differential PECL serial data stream. The
Receive Signal Interface table on page 8 gives the voltage levels and timing characteristics for the Rx_DAT
signals.
Rx_SD
The Receive Signal Detect line is high (a logical one) when the incoming modulated light intensity is sufficient
for reliable operation. This is the state for normal operation. The line is low (a logical zero) when the incoming
modulated light intensity is below that required to guarantee the correct operation of the link. Normally, this
condition only occurs when either the link is unplugged or the companion transceiver is turned off. This signal
is normally used by the system for diagnostic purposes.
This signal has a push-pull output driver.
Tx_Fault (Only available on 2 X 6)
Upon sensing an improper power level in the laser driver, the SFF sets this signal high and turns off the laser.
The Tx_Fault signal can be reset with the Tx_Disable line.
The laser is turned off within 100
μ
s as shown in the Transmitter Fault Detection timing diagram below.
This signal has an open drain TTL driver. A pull up resistor is required on the host side of the SFF connector.
The recommended value for this resistor is 10k
.
Receive Signal Detection
Rx_SD
t_SD_off
<100
μ
s
t_SD_on
<100
μ
s
Signal Removed
Optical Signal
Transmitter Fault Detection
safety fault
Tx_Fault
Optical
Power
t_fault
<100
μ
s
transmitter
Tx_Fault option is only available on 2 X 6
相關PDF資料 |
PDF描述 |
|---|---|
| IBM42F12SNNAA30 | Gigabit Ethernet/Fibre Channel Small Form Factor PTH Transceiver(吉（10^ 9 G)位以太網/光纖通道PTH收發器) |
| IBM42G12SNNAA30 | Gigabit Ethernet/Fibre Channel Small Form Factor PTH Transceiver(吉（10^ 9 G)位以太網/光纖通道PTH收發器) |
| IBM42G10SNNAA30 | Gigabit Ethernet/Fibre Channel Small Form Factor PTH Transceiver(吉（10^ 9 G)位以太網/光纖通道PTH收發器) |
| IBM42F21LNNAA10 | 1x Fibre Channel Small Form Factor PTH Transceiver(1x吉位光纖通道小外形PTH收發器) |
| IBM42G21LNNAA10 | 1x Fibre Channel Small Form Factor PTH Transceiver(1x吉位光纖通道小外形PTH收發器) |
相關代理商/技術參數 |
參數描述 |
|---|---|
| IBM42S10SNNAA20 | 制造商:IBM 功能描述:IC,DATACOM,ETHERNET TRANSCEIVER,XFO |
| IBM4MB01 | 制造商:AVED MEMORY PRODUCTS 功能描述: 制造商:AVED Memory Products 功能描述: |
| IBM63H2431-BRD | 制造商:AVED MEMORY PRODUCTS 功能描述: |
| IBM63H2469 | 制造商:AVED Memory Products 功能描述: |
| IBM64793 | 制造商:Harris Corporation 功能描述: |
發布緊急采購，3分鐘左右您將得到回復。