- 您現在的位置：買賣IC網 > PDF目錄379206 > IBM42S12LNYAA20 (IBM Microeletronics) 1250 MBd Gigabit Interface Converter(1250 MBd 吉位接口轉換器) PDF資料下載
參數資料
| 型號： | IBM42S12LNYAA20 |
| 廠商： | IBM Microeletronics |
| 英文描述： | 1250 MBd Gigabit Interface Converter(1250 MBd 吉位接口轉換器) |
| 中文描述： | 1250 MBd的千兆位接口轉換器（1250 MBd的吉位接口轉換器） |
| 文件頁數： | 18/35頁 |
| 文件大?。?/td> | 490K |
| 代理商： | IBM42S12LNYAA20 |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁當前第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁
IBM42S10SNNAA20
IBM42S10SNYAA20
1063/1250MBd Gigabit Interface Converter
IBM42S12SNYAA20
IBM42S10LNNAA20
IBM42S10LNYAA20
IBM42S12LNYAA20
IBM Corporation. All rights reserved.
Use is further subject to the provisions at the end of this document.
Page 18 of 34
GBIC.02
04/27/99
Notes for Long Wavelength Optical Characteristics
1. This 7.8dB optical power budget is a result of the difference between the worst case transmitted launch power and the receiver sen-
sitivity with a 2.7dB optical path power penalty (as specified in the ANSI Fibre Channel specification): (-9.5dBm) - (-20dBm + 2.7dB)
= 7.8dB.
2. Launched optical power is measured at the end of a two meter section of a 50/125
μ
m fiber for the GBIC-1063N, GBIC-1063NS, and
GBIC-1250NS and a 9/125mm fiber for the GBIC-1063N-LW, GBIC-1063NS-LW, and GBIC-1250NS-LW). The maximum and mini-
mum of the allowed range of average transmitter power coupled into the fiber are worst case values to account for manufacturing
variances, drift due to temperature variations, and aging effects.
3. Extinction Ratio is the ratio of the average optical power (in dB) in a logic level one to the average optical power in a logic level zero
measured under fully modulated conditions with a pattern of five 1s followed by five 0s, in the presence of worst case reflections.
4. RIN
12
is the laser noise, integrated over a specified bandwidth, measured relative to average optical power with 12 dB return loss.
See ANSI Fibre Channel Specification Annex A.5.
5. Eye opening is the portion of the bit time where the bit error rate (BER) is
≤
10
-12
. The general laser transmitter pulse shape charac-
teristics are specified in the form of a mask of the transmitter eye diagram. These characteristics include pulse overshoot, pulse
undershoot, and ringing, all of which should be controlled to prevent excessive degradation of the receiver sensitivity. When assess-
ing the transmit signal, it is important to consider not only the eye opening, but also the overshoot and undershoot limitations.
6. Deterministic Jitter is measured as the peak-to-peak timing variation of the 50% optical signal crossings when transmitting repetitive
K28.5 characters. It is defined in FC-PH, version 4.3, clause 3.1.87 as:
Timing distortions caused by normal circuit effects in the transmission system. Deterministic jitter is often subdivided into
duty cycle distortion (DCD) caused by propagation differences between the two transitions of a signal and data dependent
jitter (DDJ) caused by the interaction of the limited bandwidth of the transmission system components and the symbol
sequence.
7. Optical rise time is determined by measuring the 20% to 80% response of average maximum values using an oscilloscope and 4th
order Bessel Thompson filter having a 3 dB bandwidth of 0.75
nominal baud rate. The measurement is corrected to the full band-
width value. Optical fall times are measured using a 6 GHz photodetector followed by a 22 GHz sampling oscilloscope. No correc-
tions due to filtering or system bandwidth limitations are made on the measured value.
8. The minimum and maximum values of the average received power in dBm allow the input power range to maintain a BER < 10
-12
when the data is sampled in the center of the receiver eye. These values take into account power penalties caused by the use of a
laser transmitter with a worst-case combination of spectral width, extinction ratio, and pulse shape characteristics.
9. The Rx_LOS has hysteresis to minimize
“
chatter
”
on the output line. In principle, hysteresis alone does not guarantee chatter-free
operation. These GBICs, however, present an Rx_LOS line without chatter, where chatter is defined as a transient response having
a voltage level of greater than 0.5 volts (in the case of going from the negate level to the assert level) and of any duration that can be
sensed by the host logic.
相關PDF資料 |
PDF描述 |
|---|---|
| IBM42S12SNYAA20 | 1250 MBd Gigabit Interface Converter(1250 MBd 吉位接口轉換器) |
| IBM43GAENGP0002 | IBM Global Positioning Satellite Receiver(IBM全球定位衛星接收器) |
| IBM43RF0100 | SiGe High Dynamic Range Low Noise Transistor(用于高性能，低成本應用的硅鍺NPN低噪聲晶體管) |
| IBMB6M32734HGA | 32M x72 One Bank Registered DDR SDRAM Module(32M x 72 1組寄存同步雙數據速率動態RAM模塊) |
| IBMN312404CT3 | 128Mb(2Mbit x 16 I/O x 4 Bank) Synchronous DRAM(128M位(2M位 x 16 I/O x 4 組)同步動態RAM) |
相關代理商/技術參數 |
參數描述 |
|---|---|
| IBM4MB01 | 制造商:AVED MEMORY PRODUCTS 功能描述: 制造商:AVED Memory Products 功能描述: |
| IBM63H2431-BRD | 制造商:AVED MEMORY PRODUCTS 功能描述: |
| IBM63H2469 | 制造商:AVED Memory Products 功能描述: |
| IBM64793 | 制造商:Harris Corporation 功能描述: |
| IBM73178 | 制造商:Harris Corporation 功能描述: |
發布緊急采購，3分鐘左右您將得到回復。