- 您現在的位置：買賣IC網 > PDF目錄379206 > IBMN612804GT3B (IBM Microeletronics) 128Mb Double Data Rate Synchronous DRAM(128M位高速CMOS同步動態RAM（采用雙數據速率結構）) PDF資料下載
參數資料
| 型號： | IBMN612804GT3B |
| 廠商： | IBM Microeletronics |
| 英文描述： | 128Mb Double Data Rate Synchronous DRAM(128M位高速CMOS同步動態RAM（采用雙數據速率結構）) |
| 中文描述： | 128Mb的雙數據速率同步DRAM（128兆位高速的CMOS同步動態隨機存儲器（采用雙數據速率結構）） |
| 文件頁數： | 26/79頁 |
| 文件大?。?/td> | 1324K |
| 代理商： | IBMN612804GT3B |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁當前第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁第42頁第43頁第44頁第45頁第46頁第47頁第48頁第49頁第50頁第51頁第52頁第53頁第54頁第55頁第56頁第57頁第58頁第59頁第60頁第61頁第62頁第63頁第64頁第65頁第66頁第67頁第68頁第69頁第70頁第71頁第72頁第73頁第74頁第75頁第76頁第77頁第78頁第79頁
IBMN612404GT3B
IBMN612804GT3B
128Mb Double Data Rate Synchronous DRAM
Preliminary
IBM Corporation. All rights reserved.
Use is further subject to the provisions at the end of this document.
Page 26 of 79
06K0566.F39350B
1/01
Data from any Read burst may be truncated with a Burst Terminate command, as shown in timing figure enti-
tled Terminating a Read Burst: CAS Latencies (Burst Length = 8)on page 27. The Burst Terminate latency is
equal to the read (CAS) latency, i.e. the Burst Terminate command should be issued x cycles after the Read
command, where x equals the number of desired data element pairs.
Data from any Read burst must be completed or truncated before a subsequent Write command can be
issued. If truncation is necessary, the Burst Terminate command must be used, as shown in timing figure
entitled Read to Write: CAS Latencies (Burst Length = 4 or 8) on page 28. The example is shown for
t
DQSS
(min). The t
DQSS
(max) case, not shown here, has a longer bus idle time. t
DQSS
(min) and t
DQSS
(max)
are defined in the section on Writes.
A Read burst may be followed by, or truncated with, a Precharge command to the same bank (provided that
Auto Precharge was not activated). The Precharge command should be issued x cycles after the Read com-
mand, where x equals the number of desired data element pairs (pairs are required by the 2n prefetch archi-
tecture). This is shown in timing figure Read to Precharge: CAS Latencies (Burst Length = 4 or 8)on page 29
for Read latencies of 2 and 2.5. Following the Precharge command, a subsequent command to the same
bank cannot be issued until t
RP
is met. Note that part of the row precharge time is hidden during the access of
the last data elements.
In the case of a Read being executed to completion, a Precharge command issued at the optimum time (as
described above) provides the same operation that would result from the same Read burst with Auto Pre-
charge enabled. The disadvantage of the Precharge command is that it requires that the command and
address busses be available at the appropriate time to issue the command. The advantage of the Precharge
command is that it can be used to truncate bursts.
相關PDF資料 |
PDF描述 |
|---|---|
| IBMN625404GT3B | 256Mb Double Data Rate Synchronous DRAM(256M位雙數據速率同步動態RAM) |
| IBMN625804GT3B | 256Mb Double Data Rate Synchronous DRAM(256M位雙數據速率同步動態RAM) |
| ICM7321 | SINGLE 12/10/8-BIT VOLTAGE-OUTPUT DACS |
| ICM7321M | SINGLE 12/10/8-BIT VOLTAGE-OUTPUT DACS |
| ICM7321MG | SINGLE 12/10/8-BIT VOLTAGE-OUTPUT DACS |
相關代理商/技術參數 |
參數描述 |
|---|---|
| IBMPPC403GAJC33C1 | 制造商:IBM 功能描述: |
| IBMPPC750CLGEQ4023 | 制造商:IBM 功能描述:MPU 750CL RISC 32BIT 90NM 400MHZ 1.15V/1.8V 278FCBGA - Trays |
| IBMPPC750CLGEQ5023 | 制造商:IBM Microelectronics 功能描述:MPU 750CL RISC 32BIT 90NM 500MHZ 1.15V/1.8V 278FCBGA - Trays |
| IBMPPC750CLGEQA033 | 制造商:IBM 功能描述:MPU 750CL RISC 32BIT 90NM 1GHZ 1.15V/1.8V 278FCBGA - Trays 制造商:IBM 功能描述:IBMIBMPPC750CLGEQA033 CPU PPC 750CL 1GHZ |
| IBN100 | 制造商:Hubbell Wiring Device-Kellems 功能描述:ICON, BLANK,BR,100PK |
發布緊急采購，3分鐘左右您將得到回復。