
TABLE 22. Bluetooth Low Power Modes
Command
Event
Description
Set Default Link Policy
Get Default Link Policy
Set Link Policy
Get Link Policy
Enter Sniff Mode
Exit Sniff Mode
Enter Hold Mode
Set Default Link Policy Confirm
Get Default Link Policy Confirm
Set Link Policy Confirm
Get Link Policy Confirm
Enter Sniff Mode Confirm
Exit Sniff Mode Confirm
Enter Hold Mode Confirm
Power Save Mode Changed
Defines the link policy used for any incoming or outgoing link
Returns the stored default link policy
Defines the modes allowed for a specific link
Returns the actual link policy for the link
Remote device changed power save mode on the link
TABLE 23. Audio Control Commands
Command
Event
Description
Establish SCO Link
Establish SCO Link Confirm
SCO Link Established Indicator
Establish SCO Link on existing RFComm Link
A remote device has established a SCO link to the local
device
Release SCO Link Audio Control
SCO Link has been released
Changes Packet Type for existing SCO link
SCO Packet Type has been changed
Set Audio Settings for existing Link
Get Audio Settings for existing Link
Configure the volume
Get current volume setting
Mutes the microphone input
Release SCO Link
Change SCO Packet Type
Set Audio Settings
Get Audio Settings
Set Volume
Get Volume
Mute
Release SCO Link Confirm
SCO Link Released Indicator
Change SCO Packet Type Confirm
SCO Packet Type changed indicator
Set Audio Settings Confirm
Get Audio Settings Confirm
Set Volume Confirm
Get Volume Confirm
Mute Confirm
TABLE 24. Wake Up Functionality
Command
Event
Description
Disable Transport Layer
Transport Layer Enabled
Disabling the UART Transport Layer and activates the
Hardware Wakeup function
TABLE 25. SPP Port Configuration and Status
Command
Event
Description
Set Port Config
Get Port Config
Set Port Config Confirm
Get Port Config Confirm
Port Config Changed
SPP Get Port Status Confirm
SPP Port Set DTR Confirm
SPP Port Set RTS Confirm
SPP Port BREAK
SPP Port Overrun Error Confirm
SPP Port Parity Error Confirm
SPP Port Framing Error Confirm
SPP Port Status Changed
Set port setting for the virtual serial port link over the air
Read the actual port settings for a virtual serial port
Notification if port settings were changed from remote device
Returns status of DTR, RTS (for the active RFComm link)
Sets the DTR bit on the specified link
Sets the RTS bit on the specified link
Indicates that the host has detected a break
Used to indicate that the host has detected an overrun error
Host has detected a parity error
Host has detected a framing error
Indicates that remote device has changed one of the port
status bits
SPP Get Port Status
SPP Port Set DTR
SPP Port Set RTS
SPP Port BREAK
SPP Port Overrun Error
SPP Port Parity Error
SPP Port Framing Error
17
www.national.com
L