- 您現在的位置：買賣IC網 > PDF目錄39425 > LTC3851EMSE-1#TRPBF (LINEAR TECHNOLOGY CORP) SWITCHING CONTROLLER, PDSO16 PDF資料下載
參數資料
| 型號： | LTC3851EMSE-1#TRPBF |
| 廠商： | LINEAR TECHNOLOGY CORP |
| 元件分類： | 穩壓器 |
| 英文描述： | SWITCHING CONTROLLER, PDSO16 |
| 封裝： | 0.150 INCH, LEAD FREE, PLASTIC, MSOP-16 |
| 文件頁數： | 10/28頁 |
| 文件大小： | 337K |
| 代理商： | LTC3851EMSE-1#TRPBF |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁當前第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁
LTC3851-1
18
38511f
APPLICATIONS INFORMATION
The required ESR due to a load current step is:
R
V
I
ESR ≤
Δ
where
ΔIisthechangeincurrentfromfullloadtozeroload
(or minimum load) and
ΔVistheallowedvoltagedeviation
(not including any droop due to nite capacitance).
The amount of capacitance needed is determined by the
maximum energy stored in the inductor. The capacitance
must be sufcient to absorb the change in inductor
current when a high current to low current transition
occurs. The opposite load current transition is generally
determined by the control loop OPTI-LOOP components,
so make sure not to over compensate and slow down
the response. The minimum capacitance to assure the
inductors’ energy is adequately absorbed is:
C
LI
VV
OUT
>
()
Δ
2
where
ΔI is the change in load current.
Manufacturers such as Nichicon, United Chemi-Con and
Sanyo can be considered for high performance through-
hole capacitors. The OS-CON semiconductor electrolyte
capacitor available from Sanyo has the lowest (ESR)(size)
product of any aluminum electrolytic at a somewhat
higher price. An additional ceramic capacitor in parallel
with OS-CON capacitors is recommended to reduce the
inductance effects.
In surface mount applications, ESR, RMS current handling
and load step specications may require multiple capaci-
tors in parallel. Aluminum electrolytic, dry tantalum and
special polymer capacitors are available in surface mount
packages. Special polymer surface mount capacitors offer
very low ESR but have much lower capacitive density per
unit volume than other capacitor types. These capacitors
offer a very cost-effective output capacitor solution and are
an ideal choice when combined with a controller having
high loop bandwidth. Tantalum capacitors offer the highest
capacitance density and are often used as output capaci-
tors for switching regulators having controlled soft-start.
Several excellent surge-tested choices are the AVX TPS,
AVX TPSV or the KEMET T510 series of surface mount
tantalums, available in case heights ranging from 1.5mm
to 4.1mm. Aluminum electrolytic capacitors can be used
in cost-driven applications, provided that consideration is
given to ripple current ratings, temperature and long-term
reliability. A typical application will require several to many
aluminum electrolytic capacitors in parallel. A combina-
tion of the above mentioned capacitors will often result
in maximizing performance and minimizing overall cost.
Other capacitor types include Nichicon PL series, NEC
Neocap, Panasonic SP and Sprague 595D series. Consult
manufacturers for other specic recommendations.
Like all components, capacitors are not ideal. Each
capacitor has its own benets and limitations. Combina-
tions of different capacitor types have proven to be a very
cost effective solution. Remember also to include high
frequency decoupling capacitors. They should be placed
as close as possible to the power pins of the load. Any
inductance present in the circuit board traces negates
their usefulness.
Setting Output Voltage
The LTC3851-1 output voltage is set by an external feed-
back resistive divider carefully placed across the output,
as shown in Figure 6. The regulated output voltage is
determined by:
VV
R
OUT
B
A
=+
0 8
1
.
To improve the transient response, a feed-forward ca-
pacitor, CFF, may be used. Great care should be taken to
route the VFB line away from noise sources, such as the
inductor or the SW line.
Figure 6. Settling Output Voltage
LTC3851-1
VFB
VOUT
RB
CFF
RA
38511 F06
相關PDF資料 |
PDF描述 |
|---|---|
| LTC3851EUD-1#TRPBF | SWITCHING CONTROLLER, PQCC16 |
| LTCEMSE-1#PBF | SWITCHING CONTROLLER, PDSO16 |
| LTC3851IUD-1#TRPBF | SWITCHING CONTROLLER, PQCC16 |
| LTC3859IUHF#TRPBF | SWITCHING CONTROLLER, 900 kHz SWITCHING FREQ-MAX, PQCC38 |
| LTC3859EFE#PBF | SWITCHING CONTROLLER, 900 kHz SWITCHING FREQ-MAX, PDSO38 |
相關代理商/技術參數 |
參數描述 |
|---|---|
| LTC3851EUD#PBF | 功能描述:IC REG CTRLR BUCK PWM CM 16-QFN RoHS:是 類別:集成電路 (IC) >> PMIC - 穩壓器 - DC DC 切換控制器 系列:- 特色產品:LM3753/54 Scalable 2-Phase Synchronous Buck Controllers 標準包裝:1 系列:PowerWise® PWM 型:電壓模式 輸出數:1 頻率 - 最大:1MHz 占空比:81% 電源電壓:4.5 V ~ 18 V 降壓:是 升壓:無 回掃:無 反相:無 倍增器:無 除法器:無 Cuk:無 隔離:無 工作溫度:-5°C ~ 125°C 封裝/外殼:32-WFQFN 裸露焊盤 包裝:Digi-Reel® 產品目錄頁面:1303 (CN2011-ZH PDF) 其它名稱:LM3754SQDKR |
| LTC3851EUD#TRPBF | 功能描述:IC REG CTRLR BUCK PWM CM 16-QFN RoHS:是 類別:集成電路 (IC) >> PMIC - 穩壓器 - DC DC 切換控制器 系列:- 標準包裝:2,500 系列:- PWM 型:電流模式 輸出數:1 頻率 - 最大:500kHz 占空比:96% 電源電壓:4 V ~ 36 V 降壓:無 升壓:是 回掃:無 反相:無 倍增器:無 除法器:無 Cuk:無 隔離:無 工作溫度:-40°C ~ 125°C 封裝/外殼:24-WQFN 裸露焊盤 包裝:帶卷 (TR) |
| LTC3851EUD-1#PBF | 功能描述:IC REG CTRLR BUCK PWM CM 16-QFN RoHS:是 類別:集成電路 (IC) >> PMIC - 穩壓器 - DC DC 切換控制器 系列:- 標準包裝:2,500 系列:- PWM 型:電流模式 輸出數:1 頻率 - 最大:500kHz 占空比:96% 電源電壓:4 V ~ 36 V 降壓:無 升壓:是 回掃:無 反相:無 倍增器:無 除法器:無 Cuk:無 隔離:無 工作溫度:-40°C ~ 125°C 封裝/外殼:24-WQFN 裸露焊盤 包裝:帶卷 (TR) |
| LTC3851EUD-1#TRPBF | 功能描述:IC REG CTRLR BUCK PWM CM 16-QFN RoHS:是 類別:集成電路 (IC) >> PMIC - 穩壓器 - DC DC 切換控制器 系列:- 標準包裝:2,500 系列:- PWM 型:電流模式 輸出數:1 頻率 - 最大:500kHz 占空比:96% 電源電壓:4 V ~ 36 V 降壓:無 升壓:是 回掃:無 反相:無 倍增器:無 除法器:無 Cuk:無 隔離:無 工作溫度:-40°C ~ 125°C 封裝/外殼:24-WQFN 裸露焊盤 包裝:帶卷 (TR) |
| LTC3851IGN#PBF | 功能描述:IC REG CTRLR BUCK PWM CM 16-SSOP RoHS:是 類別:集成電路 (IC) >> PMIC - 穩壓器 - DC DC 切換控制器 系列:- 標準包裝:2,000 系列:- PWM 型:電流模式 輸出數:1 頻率 - 最大:1MHz 占空比:50% 電源電壓:9 V ~ 10 V 降壓:無 升壓:是 回掃:是 反相:無 倍增器:無 除法器:無 Cuk:無 隔離:無 工作溫度:-40°C ~ 85°C 封裝/外殼:8-TSSOP（0.173"，4.40mm 寬） 包裝:帶卷 (TR) |
發布緊急采購，3分鐘左右您將得到回復。