- 您現在的位置：買賣IC網 > PDF目錄39425 > LTC3859EFE#PBF (LINEAR TECHNOLOGY CORP) SWITCHING CONTROLLER, 900 kHz SWITCHING FREQ-MAX, PDSO38 PDF資料下載
參數資料
| 型號： | LTC3859EFE#PBF |
| 廠商： | LINEAR TECHNOLOGY CORP |
| 元件分類： | 穩壓器 |
| 英文描述： | SWITCHING CONTROLLER, 900 kHz SWITCHING FREQ-MAX, PDSO38 |
| 封裝： | 4.40 MM, LEAD FREE, PLASTIC, TSSOP-38 |
| 文件頁數： | 9/42頁 |
| 文件大?。?/td> | 624K |
| 代理商： | LTC3859EFE#PBF |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁當前第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁第42頁
LTC3859
17
3859fa
OPERATION
Frequency Selection and Phase-Locked Loop
(FREQ and PLLIN/MODE Pins)
The selection of switching frequency is a tradeoff between
efciency and component size. Low frequency opera-
tion increases efciency by reducing MOSFET switching
losses, but requires larger inductance and/or capacitance
to maintain low output ripple voltage.
The switching frequency of the LTC3859’s controllers can
be selected using the FREQ pin.
If the PLLIN/MODE pin is not being driven by an external
clock source, the FREQ pin can be tied to SGND, tied to
INTVCC, or programmed through an external resistor. Tying
FREQ to SGND selects 350kHz while tying FREQ to INTVCC
selects 535kHz. Placing a resistor between FREQ and
SGND allows the frequency to be programmed between
50kHz and 900kHz.
A phase-locked loop (PLL) is available on the LTC3859
to synchronize the internal oscillator to an external clock
source that is connected to the PLLIN/MODE pin. The
LTC3859’s phase detector adjusts the voltage (through an
internal lowpass lter) of the VCO input to align the turn-on
of controller 1’s external top MOSFET to the rising edge of
the synchronizing signal. Thus, the turn-on of controller
2’s external top MOSFET is 180 degrees out of phase to
the rising edge of the external clock source.
The VCO input voltage is pre-biased to the operating
frequency set by the FREQ pin before the external clock
is applied. If prebiased near the external clock frequency,
the PLL loop only needs to make slight changes to the
VCO input in order to synchronize the rising edge of the
external clock’s to the rising edge of TG1. The ability to
pre-bias the loop lter allows the PLL to lock in rapidly
without deviating far from the desired frequency.
The typical capture range of the LTC3859’s phase-locked
loop is from approximately 55kHz to 1MHz, with a guar-
antee over all manufacturing variations to be between
75kHz and 850kHz. In other words, the LTC3859’s PLL
is guaranteed to lock to an external clock source whose
frequency is between 75kHz and 850kHz.
The typical input clock thresholds on the PLLIN/MODE
pin are 1.6V (rising) and 1.2V (falling).
Boost Controller Operation When VIN > VOUT
When the input voltage to the boost channel rises above
its regulated VOUT voltage, the controller can behave
differently depending on the mode, inductor current and
VIN voltage. In forced continuous mode, the loop works
to keep the top MOSFET on continuously once VIN rises
above VOUT. An internal charge pump delivers current to
the boost capacitor from the BOOST3 pin to maintain a
sufciently high TG voltage. (The amount of current the
charge pump can deliver is characterized by two curves
in the Typical Performance Characteristics section.)
In pulse-skipping mode, if VIN is between 100% and 110%
of the regulated VOUT voltage, TG turns on if the inductor
current rises above a certain threshold and turns off if the
inductor current falls below this threshold. This threshold
current is set approximately to 3% of the programmed
maximum ILIM current. If the controller is programmed to
Burst Mode operation under this same VIN window, then
TG remains off regardless of the inductor current.
If VIN rises above 110% of the regulated VOUT voltage in
any mode, the controller turns on TG regardless of the
inductor current. In Burst Mode operation, however, the
internal charge pump turns off if the boost channel is
asleep. With the charge pump off, there would be nothing to
prevent the boost capacitor from discharging, resulting in
an insufcient TG voltage needed to keep the top MOSFET
completely on. To prevent excessive power dissipation
across the body diode of the top MOSFET in this situation,
the chip can be switched over to forced continuous mode
to enable the charge pump, or a Schottky diode can also
be placed in parallel with the top MOSFET.
Boost Controller at Low SENSE Pin Common Voltage
The current comparator of the boost controller is powered
directly from the SENSE3+ pin and can operate to voltages
as low as 2.5V. Since this is lower than the VBIAS UVLO of
the chip, VBIAS can be connected to the output of the boost
controller, as illustrated in the typical application circuit
in Figure 12. This allows the boost controller to handle
input voltage transients down to 2.5V while maintaining
output voltage regulation. If the SENSE3+ rises back
above 2.5V, the SS3 pin will be released initiating a new
soft-start sequence.
相關PDF資料 |
PDF描述 |
|---|---|
| LTC3859EFE#TRPBF | SWITCHING CONTROLLER, 900 kHz SWITCHING FREQ-MAX, PDSO38 |
| LTC4160EUDC#PBF | POWER SUPPLY MANAGEMENT CKT, PQCC20 |
| LTC4266IUHF#TRPBF | POWER SUPPLY MANAGEMENT CKT, PQCC38 |
| LTC4266CUHF#PBF | POWER SUPPLY MANAGEMENT CKT, PQCC38 |
| LTC500-4MM | LOW PASS FILTER |
相關代理商/技術參數 |
參數描述 |
|---|---|
| LTC3859EUHF#PBF | 功能描述:IC REG CTRLR BST PWM CM 38-QFN RoHS:是 類別:集成電路 (IC) >> PMIC - 穩壓器 - DC DC 切換控制器 系列:- 特色產品:LM3753/54 Scalable 2-Phase Synchronous Buck Controllers 標準包裝:1 系列:PowerWise® PWM 型:電壓模式 輸出數:1 頻率 - 最大:1MHz 占空比:81% 電源電壓:4.5 V ~ 18 V 降壓:是 升壓:無 回掃:無 反相:無 倍增器:無 除法器:無 Cuk:無 隔離:無 工作溫度:-5°C ~ 125°C 封裝/外殼:32-WFQFN 裸露焊盤 包裝:Digi-Reel® 產品目錄頁面:1303 (CN2011-ZH PDF) 其它名稱:LM3754SQDKR |
| LTC3859EUHF#TRPBF | 功能描述:IC REG CTRLR BST PWM CM 38-QFN RoHS:是 類別:集成電路 (IC) >> PMIC - 穩壓器 - DC DC 切換控制器 系列:- 標準包裝:4,500 系列:PowerWise® PWM 型:控制器 輸出數:1 頻率 - 最大:1MHz 占空比:95% 電源電壓:2.8 V ~ 5.5 V 降壓:是 升壓:無 回掃:無 反相:無 倍增器:無 除法器:無 Cuk:無 隔離:無 工作溫度:-40°C ~ 125°C 封裝/外殼:6-WDFN 裸露焊盤 包裝:帶卷 (TR) 配用:LM1771EVAL-ND - BOARD EVALUATION LM1771 其它名稱:LM1771SSDX |
| LTC3859IFE#PBF | 功能描述:IC REG CTRLR BST PWM CM 38-TSSOP RoHS:是 類別:集成電路 (IC) >> PMIC - 穩壓器 - DC DC 切換控制器 系列:- 標準包裝:4,500 系列:PowerWise® PWM 型:控制器 輸出數:1 頻率 - 最大:1MHz 占空比:95% 電源電壓:2.8 V ~ 5.5 V 降壓:是 升壓:無 回掃:無 反相:無 倍增器:無 除法器:無 Cuk:無 隔離:無 工作溫度:-40°C ~ 125°C 封裝/外殼:6-WDFN 裸露焊盤 包裝:帶卷 (TR) 配用:LM1771EVAL-ND - BOARD EVALUATION LM1771 其它名稱:LM1771SSDX |
| LTC3859IFE#TRPBF | 功能描述:IC REG CTRLR BST PWM CM 38-TSSOP RoHS:是 類別:集成電路 (IC) >> PMIC - 穩壓器 - DC DC 切換控制器 系列:- 標準包裝:4,500 系列:PowerWise® PWM 型:控制器 輸出數:1 頻率 - 最大:1MHz 占空比:95% 電源電壓:2.8 V ~ 5.5 V 降壓:是 升壓:無 回掃:無 反相:無 倍增器:無 除法器:無 Cuk:無 隔離:無 工作溫度:-40°C ~ 125°C 封裝/外殼:6-WDFN 裸露焊盤 包裝:帶卷 (TR) 配用:LM1771EVAL-ND - BOARD EVALUATION LM1771 其它名稱:LM1771SSDX |
| LTC3859IUHF#PBF | 功能描述:IC REG CTRLR BST PWM CM 38VQFN RoHS:是 類別:集成電路 (IC) >> PMIC - 穩壓器 - DC DC 切換控制器 系列:- 標準包裝:2,000 系列:- PWM 型:電流模式 輸出數:1 頻率 - 最大:1MHz 占空比:50% 電源電壓:9 V ~ 10 V 降壓:無 升壓:是 回掃:是 反相:無 倍增器:無 除法器:無 Cuk:無 隔離:無 工作溫度:-40°C ~ 85°C 封裝/外殼:8-TSSOP（0.173"，4.40mm 寬） 包裝:帶卷 (TR) |
發布緊急采購，3分鐘左右您將得到回復。