- 您現在的位置：買賣IC網 > PDF目錄359439 > VT900 (PerkinElmer Inc.) Photoconductive Cells and Analog Optoisolators (Vactrols) PDF資料下載
參數資料
| 型號： | VT900 |
| 廠商： | PerkinElmer Inc. |
| 英文描述： | Photoconductive Cells and Analog Optoisolators (Vactrols) |
| 中文描述： | 光導細胞和模擬光隔離器（Vactrols） |
| 文件頁數： | 67/76頁 |
| 文件大?。?/td> | 1240K |
| 代理商： | VT900 |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁第42頁第43頁第44頁第45頁第46頁第47頁第48頁第49頁第50頁第51頁第52頁第53頁第54頁第55頁第56頁第57頁第58頁第59頁第60頁第61頁第62頁第63頁第64頁第65頁第66頁當前第67頁第68頁第69頁第70頁第71頁第72頁第73頁第74頁第75頁第76頁
62
Application Notes—Analog Optical Isolators
Limiters
If the magnitude of an AC signal varies over a wide range, it may be
necessary to amplify or compress the signal before any audio
processing can be performed. In other cases, the audio power has to
be limted to prevent damage to an output device. Circuits that perform
this function on a continual basis need a non-linear element to produce
variable gain. However most non-linear elements introduce distortion.
This is unacceptable in a high fidelity audio circuit and other critical
applications. Using an AOI, simple circuits can be made to performthis
function without introducing distortion or generating any noise.
Signal Limiters
Any circuit that performs as a limter or compressor must have low gain
when the signal magnitude is high and high gain when the signal is
low The gain is adjusted so that a wide dynamc range is compressed
into a small one. In other signal processing applications, the signal
may need to be virtually constant.
The circuit such as shown in Figure 4a will keep the output level
constant when the input voltage varies over a range of 50 – 60db.
Amplifier A1 operates as an inverting amplifier with a gain:
e
out
/ e
in
= R
PHOTOCELL
/ R
1
The feedback resistor is a photocell and has an “off” resistance of 10
megohms, mnimum and an “on” resistance of 5000 ohms with 5.0 mA
in the LED. Using the components shown, the gain of this stage varies
between 500 with no signal and 0.5 with maximumsignal applied. R
2
limts the maximumgain and is needed to prevent the amplifier, A
1
fromgoing open loop when there is no input signal, in which case the
cell “off” resistance is much higher than 10 M
.
Amplifier A
2
operates as a high input impedance rectifier that drives
the LED. The forward drop of the LED is 1.6 – 2.0V, and when the peak
output of the rectifier exceeds this value, current will flow into the LED.
As the signal increases, more current flows into the LED, driving the
photocell resistance lower thus decreasing the amplifier gain. The
output of A
1
is regulated at a voltage determned by the forward drop of
the LED and the closed loop gain of amplifier A
2
. A
2
amplifies the
signal by a factor of two, and a 1.8V peak (1.27 VRMS) is required to
activate this AOI. This results in the output voltage being held to 0.64
VRMS over a input range of 1 – 600 mV. Changing the value of R
4
changes the gain of the rectifier. Omtting R
4
will double the output
voltage because the rectifier gain drops to one. Putting a resistor in
series with the LED will cause the regulated voltage to rise as the input
is increased (see Figure 4b). As the amplifier gain changes, the
amplifier bandwidth also changes. When the signal is low the amplifier
will have the highest gain and lowest bandwidth.
Figure 4a. Peak Sensing Compressor
Figure 4b. Output Characteristics
相關PDF資料 |
PDF描述 |
|---|---|
| VT905GA | |
| VT905GC | |
| VT90N1 | |
| VT90N2 | |
| VT90N3 | |
相關代理商/技術參數 |
參數描述 |
|---|---|
| VT905GA | 制造商:未知廠家 制造商全稱:未知廠家 功能描述: |
| VT905GB | 制造商:未知廠家 制造商全稱:未知廠家 功能描述: |
| VT905GC | 制造商:未知廠家 制造商全稱:未知廠家 功能描述: |
| VT90A114 | 制造商:未知廠家 制造商全稱:未知廠家 功能描述: |
| VT90A432 | 制造商:未知廠家 制造商全稱:未知廠家 功能描述: |
發布緊急采購，3分鐘左右您將得到回復。