
6
Major Revisions in This Edition
p.23
121-pin fine pitch BGA has been added to
1.4 Ordering Information
p.24
121-pin fine pitch BGA has been added to
1.5 Pin Configuration (Top View)
.
p.57
The explanation of EP bit has been modified in
3.2.2 (2) Program status word (PSW)
.
p.71
The description has been modified in
3.4.6 (2) memory address output mode register
(MAM)
.
p.75
3.4.8 Peripheral I/O registers
has been modified.
Note
has been added to this section.
p.80
Caution
has been added to
3.4.9 Specific registers
.
p.90
Note
has been added to
4.7.1 Outline of function
.
p.102
Note
has been added to
Table 5-1 Interrupt Source List
.
p.148, 149
Caution
has been added to
7.1.3
(2) Capture/compare register n0 (CR00, CR10)
and
(3) Capture/compare register n1 (CR01, CR11)
.
p.152
Caution
has been modified in
Figure 7-2 Format of 16-Bit Timer Mode Control Register
0, 1 (TMC0, TMC1)
.
p.153
Caution
has been added to
Figure 7-3 Format of Capture/Compare Control Register 0,
1 (CRC0, CRC1)
.
p.155
Note
has been added to
Figure 7-4 Format of 16-Bit Timer Output Control Register 0, 1
(TOC0, TOC1)
p.156
p.157
p.160
Caution
has been added to the following figures:
Figure 7-5 Format of Prescaler Mode Register 0 (PRM0)
Figure 7-6 Format of Prescaler Mode Register 1 (PRM1)
Figure 7-10 Control register Settings in PPG Output Operation
p.162
Figure 7-13
has been modified.
p.164
TIn0 has been modified in
Figure 7-15 CRn1 Capture Operation with Rising Edge
Specified
.
p.164
p.166
p.167
The following figures have been modified.
Figure 7-16 Timing of Pulse Width Measurement with Free Running Counter (with
both edges specified)
Figure 7-18 Timing of Pulse Width Measurement with Free Running Counter and Two
Capture Registers (with rising edge specified)
Figure 7-20 Timing of Pulse Width Measurement by Restarting (with rising edge
specified)
p.198
The description has been changed in
8.4.1 Operation as watch timer.
p.222
Caution
has been added to
10.3.2 (1) IIC control register (IICC0)
.
p.223
Figure 10-9 Format of IIC Control Register (IICC0)
has been modified and
Remark
has
been added to this figure.
The explanation has been modified in
10.3.12 Communication reservation
.
p.266
p.269
Figure 10-23 Communication Reservation Flow Chart
has been modified.
p.303
Caution
has been added to
11.2 (2) A/D conversion result register (ADCR)
.
p.308
Caution
has been added to
11.4.1 Basic operation
.
p.314
11.5
(9) Reading A/D conversion result register (ADCR)
has been added.
p.359, 362, 366
Erase/write voltage has been changed to V
PP
= 7.8 V
The mark shows major revised points.