
EK-P1 Evaluation Kit: Differential Pressure Sensor ASP1400339
www.sensirion.com
Page 3 of 9
(1) 3 sensor systems ASP1400
(2) serial interface cable with power supply
(3) bypass tube with reduction muff
(4) reduction to 12mm tubes
(5) reduction to 6mm tubes
(6) rubber hose
(7) FlowViewer (V1.2) software on CD
Table 1: Contents of the evaluation kit EP-F1
What You Need to Get Started
Make sure you have all of the following items before you install the hardware and
HumiViewer software for Windows 95/98/2000/NT:
_ Windows 95/98/2000 or Windows NT version 4.0.
_ An unused serial interface port (e.g. COM1).
_ HumiViewer (V 1.3) software for Windows 95/98/2000/NT on CD.
_ Contents of your evaluation kit as described in the Introduction.
If you do not have a CD drive and would like to order the FlowViewer software on a floppy
disk, please contact Sensirion AG. Additionally, software for the use of your ASP1400 with
a Palm Pilot is available on our internet page (www.sensirion.com).
Installing the Hardware
In the following section all the necessary electrical interconnections for the ASP1400
sensor system will be listed. These connections are required between the ASP1400, a PC
serial interface and a power supply.
Observe precautions when handling electrostatic sensitive devices!
To install your ASP1400 complete the following steps (see Fig. 2):
_ Turn off your PC. Keep your PC plugged in so that it remains grounded while you
install the ASP1400.
_ Connect the serial interface cable with the COM port of your PC (configuration of
the serial interface see App. A).
_ Connect the interface cable with the ASP1400 (pin diagram of the ASP1400 is
given in App. B).
_ Plug in the power supply. Input 100V - 240V AC, 47Hz - 63Hz.
_ Turn on your PC and start Windows 95/98/NT.