- 您現在的位置：買賣IC網 > PDF目錄3909 > 101-0404 (Rabbit Semiconductor)MODULE RABBITCORE RCM2000 PDF資料下載
參數資料
| 型號： | 101-0404 |
| 廠商： | Rabbit Semiconductor |
| 文件頁數： | 26/80頁 |
| 文件大?。?/td> | 0K |
| 描述： | MODULE RABBITCORE RCM2000 |
| 標準包裝： | 1 |
| 系列： | RabbitCore® |
| 模塊/板類型： | MPU 核心模塊 |
| 適用于相關產品： | RCM2000 |
| 其它名稱： | 316-1008 |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁當前第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁第42頁第43頁第44頁第45頁第46頁第47頁第48頁第49頁第50頁第51頁第52頁第53頁第54頁第55頁第56頁第57頁第58頁第59頁第60頁第61頁第62頁第63頁第64頁第65頁第66頁第67頁第68頁第69頁第70頁第71頁第72頁第73頁第74頁第75頁第76頁第77頁第78頁第79頁第80頁
28
RabbitCore RCM2000
4.2 Memory I/O Interface
Thirteen of the Rabbit 2000 address lines (A0–A12) and all the data lines (D0–D7) are
available as outputs on the RCM2000. I/0 write (/IOWR), I/0 read (/IORD), buffer enable
(/BUFEN), and Watchdog Output (/WDO) are also available for interfacing to external
devices.
The STATUS output has three different programmable functions:
1. It can be driven low on the first op code fetch cycle.
2. It can be driven low during an interrupt acknowledge cycle.
3. It can also serve as a general-purpose output.
4.2.1 Additional I/0
Although, the output clock is available on the PCLK pin, the output clock is disabled in
software starting with Dynamic C v 7.02 and later. This reduces radiated emissions. The
primary function of PCLK is as a peripheral clock or a peripheral clock ÷ 2, but PCLK can
instead be used as a digital output. See Section 5.2.1, “PCLK Output,” for more informa-
tion.
Two status mode pins, SMODE0 and SMODE1, are available as inputs. The logic state of
these two pins determines the startup procedure after a reset. /RES_IN is an external input
used to reset the Rabbit 2000 microprocessor and RCM2000 memory. /RES_OUT is an
output from the reset circuitry that can be used to reset other peripheral devices.
4.3 Serial Communication
The RCM2000 does not have an RS-232 or an RS-485 transceiver directly on the board.
However, the Prototyping Board does support a industry standard RS-232 transceiver
chip. See Appendix B, “Prototyping Board,” for more information.
4.3.1 Serial Ports
There are four serial ports designated as Serial Ports A, B, C, and D. All four serial ports
can operate in an asynchronous mode up to the baud rate of the system clock divided by
32. An asynchronous port can handle 7 or 8 data bits. A 9th bit address scheme, where an
additional bit is sent to mark the first byte of a message, is also supported. Serial Ports A
and B can be operated alternately in the clocked serial mode. In this mode, a clock line
synchronously clocks the data in or out. Either of the two communicating devices can sup-
ply the clock. When the Rabbit provides the clock, the baud rate can be up to 1/4 of the
system clock frequency, or more than 6.45 Mbps for a 25.8 MHz clock speed.
相關PDF資料 |
PDF描述 |
|---|---|
| 006200505130000+ | CONN FFC/FPC 5POS 1MM R/A SMD |
| 006208505110000 | CONN FFC/FPC 5POS 1MM ZIF SMD |
| 006208505110000+ | CONN FFC/FPC 5POS 1MM ZIF SMD |
| 395-030-541-204 | CARD EDGE 30POS DL .100X.200 BLK |
| 395-030-541-202 | CARD EDGE 30POS DL .100X.200 BLK |
相關代理商/技術參數 |
參數描述 |
|---|---|
| 101-040400 | 制造商:Distributed By MCM 功能描述:RJ10 PLUGS STRANDED FLAT WIREPK10 |
| 101-040400-24 | 制造商:Distributed By MCM 功能描述:RJ10 PLUGS SOLID STRANDED WIRE FLAT PK10 |
| 10104046SP | 制造商:Pentair Technical Products / Hoffman 功能描述:RFG TXV SPO BBINE2GAB15 |
| 101-0405 | 功能描述:模塊化系統 - SOM RCM2010 RABBITCORE RoHS:否 制造商:Digi International 外觀尺寸:ConnectCore 9P 處理器類型:ARM926EJ-S 頻率:150 MHz 存儲容量:8 MB, 16 MB 存儲類型:NOR Flash, SDRAM 接口類型:I2C, SPI, UART 工作電源電壓:3.3 V 最大工作溫度:+ 85 C 尺寸:1.97 in x 1.97 in x 6.1 in |
| 101-0406 | 功能描述:開發板和工具包 - 其他處理器 Cloning Board RoHS:否 制造商:Freescale Semiconductor 產品:Development Systems 工具用于評估:P3041 核心:e500mc 接口類型:I2C, SPI, USB 工作電源電壓: |
發布緊急采購，3分鐘左右您將得到回復。