- 您現在的位置：買賣IC網 > PDF目錄3910 > 101-0600 (Rabbit Semiconductor)COMPUTER SNGLBD BL2510 512K FLSH PDF資料下載
參數資料
| 型號： | 101-0600 |
| 廠商： | Rabbit Semiconductor |
| 文件頁數： | 32/106頁 |
| 文件大?。?/td> | 0K |
| 描述： | COMPUTER SNGLBD BL2510 512K FLSH |
| 標準包裝： | 10 |
| 系列： | SBC |
| 模塊/板類型： | 單板計算機模塊 |
| 適用于相關產品： | BL2510 |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁當前第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁第42頁第43頁第44頁第45頁第46頁第47頁第48頁第49頁第50頁第51頁第52頁第53頁第54頁第55頁第56頁第57頁第58頁第59頁第60頁第61頁第62頁第63頁第64頁第65頁第66頁第67頁第68頁第69頁第70頁第71頁第72頁第73頁第74頁第75頁第76頁第77頁第78頁第79頁第80頁第81頁第82頁第83頁第84頁第85頁第86頁第87頁第88頁第89頁第90頁第91頁第92頁第93頁第94頁第95頁第96頁第97頁第98頁第99頁第100頁第101頁第102頁第103頁第104頁第105頁第106頁
User’s Manual
25
Pulse-width modulation (PWM) is used for the D/A conversion. The digital signal, which
is either 0 V or 3.3 V, will be a train of pulses. This means that if the signal is taken to be
usually at 0 V (or ground), the pulses will be some 3.3 V pulses of varying width. The
voltage will be 0 V for a given time, then jump to 3.3 V for a given time, then back to
ground for a given time, then back to 3.3 V, and so on. A hardware filter that consists of a
resistor and capacitor averages the 3.3 V signal and the 0 V signal over time. Therefore, if
the time that the signal is at 3.3 V is equal to the time the signal is 0 V, the duty cycle will
be 50%, and the average signal will be 1.65 V. If the time at 3.3 V is only 25% of the time,
then the average voltage will be 0.825 V. Thus, the software needs to only vary the time
the signal is at 3.3 V with respect to the time the signal is at 0 V to achieve any desired
voltage between 0 and 3.3 V. It is very easy to do pulse-width modulation with the Rabbit
3000 microprocessor because the chip’s architecture includes an advanced PWM feature.
3.4.2.1 DA0 and DA1
The RC networks supporting DA0 and DA1 converts pulse-width modulated signals to an
analog voltage between 0 V and 3.3 V. A digital signal that varies with time is fed from
PF6 or PF7. The resolution of the DA0 or DA1 output depends on the smallest increment
of time to change the on/off time (the time between 3.3 V and 0 V). The Coyote uses the
Rabbit 3000’s Port F control registers to clock out the signal at a timer timeout. The dedi-
cated PWM hardware has 10 bits of resolution, and so that the voltage can be varied in
1/1024 increments. The resolution is thus about 3 mV (3.3 V/1024).
R6 and R13 are present solely to balance the op amp input current bias. R4 and R15 help
to achieve a voltage close to ground for a 0% duty cycle.
A design constraint dictates how fast the PWM hardware must run. The hardware filter
has a resistor-capacitor filter that averages the 0 V and 3.3 V values. Its effect is to smooth
out the digital pulse train. It cannot be perfect, and so there will be some ripple in the output
voltage. The maximum signal decay between pulses will occur when DA1 is set to 1.65 V.
This means the pulse train will have a 50% duty cycle. The maximum signal decay will be
where RC = 2.5 ms, and t is the pulse on or off time (not the length of the total cycle).
The PWM hardware is driven at the Rabbit 3000 frequency divided by 2. The frequency
achievable with a 29.4 MHz clock is (29.4 MHz/2)/1024 = 14.3 kHz. Since the Rabbit 3000
PWM spreader enhances the frequency fourfold, the effective frequency becomes 57.4 kHz.
This is a period of 1/f = 17.4 s. For a 50% duty cycle, half of the period will be high (8.7
s at 3.3 V), and half will be low (8.7 s at 0 V). Thus, a 29.4 MHz Coyote has t = 8.7 s.
1.65 V
1
e
t
–
RC
--------
–
相關PDF資料 |
PDF描述 |
|---|---|
| 101-0575 | COMPUTER SNGLBD BL2500 256K FLSH |
| 20-101-0526 | COMPUTER SNGLBD LP3510 FOX7.4MHZ |
| 101-0526 | COMPUTER SNGLBD LP3510 FOX7.4MHZ |
| 101-0576 | COMPUTER SNGLBD BL2510 256K FLSH |
| 20-101-1055 | MODULE RABBITCORE RCM3375 |
相關代理商/技術參數 |
參數描述 |
|---|---|
| 101-0601 | 功能描述:處理器配件 Keypad/Display Unit 3.3V w/o Case RoHS:否 制造商:Olimex Ltd. 產品:Cable 用于: |
| 101-0602 | 功能描述:單板計算機 BL2500 512K/512K RoHS:否 制造商:Ampro By ADLINK 外觀尺寸:EPIC 處理器類型:Intel Atom D510 頻率:1.66 GHz 存儲容量:2 GB (max) 存儲類型:DDR2, L2 Cache 接口類型:Ethernet, PS/2, SATA, Serial, USB 工作電源電壓:5 V, 12 V 功耗:13 W 最大工作溫度:+ 70 C 尺寸:165.1 mm x 114.3 mm |
| 10106020-1 | 制造商:Amphenol Corporation 功能描述:10-305770-028 - Bulk |
| 10106020-2 | 制造商:Amphenol Corporation 功能描述:10106020-2 - Bulk |
| 10106029-001LF | 功能描述:電源到板 15DC+16S Right Angle HCI Header RoHS:否 制造商:TE Connectivity / AMP 系列:5787444 產品類型:Connectors 觸點類型: 電壓額定值:50 V 電流額定值: 節距: 位置/觸點數量:5 安裝風格:Through Hole 端接類型: 觸點電鍍:Tin |
發布緊急采購，3分鐘左右您將得到回復。