- 您現在的位置：買賣IC網 > PDF目錄69562 > 12061A100JAT2A KONDENSATOR 10PF 100V 10ST PDF資料下載
參數資料
| 型號： | 12061A100JAT2A |
| 英文描述： | KONDENSATOR 10PF 100V 10ST |
| 中文描述： | KONDENSATOR 10PF 100V的10ST |
| 文件頁數： | 32/46頁 |
| 文件大?。?/td> | 659K |
| 代理商： | 12061A100JAT2A |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁當前第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁第42頁第43頁第44頁第45頁第46頁
37
General Description
Effects of Voltage – Variations in voltage have little effect
on Class 1 dielectric but does affect the capacitance and
dissipation factor of Class 2 dielectrics. The application of
DC voltage reduces both the capacitance and dissipation
factor while the application of an AC voltage within a
reasonable range tends to increase both capacitance and
dissipation factor readings. If a high enough AC voltage is
applied, eventually it will reduce capacitance just as a DC
voltage will. Figure 2 shows the effects of AC voltage.
Capacitor specifications specify the AC voltage at which to
measure (normally 0.5 or 1 VAC) and application of the
wrong voltage can cause spurious readings. Figure 3 gives
the voltage coefficient of dissipation factor for various AC
voltages at 1 kilohertz. Applications of different frequencies
will affect the percentage changes versus voltages.
The effect of the application of DC voltage is shown in
Figure 4. The voltage coefficient is more pronounced for
higher K dielectrics. These figures are shown for room tem-
perature conditions. The combination characteristic known
as voltage temperature limits which shows the effects of
rated voltage over the operating temperature range is
shown in Figure 5 for the military BX characteristic.
Cap. Change vs. D.C. Volts
AVX X7R T.C.
Typical Cap. Change vs. Temperature
AVX X7R T.C.
Effects of Time – Class 2 ceramic capacitors change
capacitance and dissipation factor with time as well as tem-
perature, voltage and frequency. This change with time is
known as aging. Aging is caused by a gradual re-alignment
of the crystalline structure of the ceramic and produces an
exponential loss in capacitance and decrease in dissipation
factor versus time. A typical curve of aging rate for semi-
stable ceramics is shown in Figure 6.
If a Class 2 ceramic capacitor that has been sitting on the
shelf for a period of time, is heated above its curie point,
(125°C for 4 hours or 150°C for 12 hour will suffice) the part
will de-age and return to its initial capacitance and dissi-
pation factor readings. Because the capacitance changes
rapidly, immediately after de-aging, the basic capacitance
measurements are normally referred to a time period some-
time after the de-aging process. Various manufacturers use
different time bases but the most popular one is one day
or twenty-four hours after “l(fā)ast heat.” Change in the aging
curve can be caused by the application of voltage and
other stresses. The possible changes in capacitance due to
de-aging by heating the unit explain why capacitance
changes are allowed after test, such as temperature cycling,
moisture resistance, etc., in MIL specs. The application of
high voltages such as dielectric withstanding voltages also
25%
50%
75%
100%
Percent Rated Volts
Capacitance
Change
Percent
2.5
0
-2.5
-5
-7.5
-10
0VDC
RVDC
-55 -35
-15
+5
+25 +45 +65 +85 +105 +125
Temperature Degrees Centigrade
Capacitance
Change
Percent
+20
+10
0
-10
-20
-30
Figure 2
50
40
30
20
10
0
12.5
25
37.5
50
Volts AC at 1.0 KHz
Capacitance
Change
Percent
Cap. Change vs. A.C. Volts
AVX X7R T.C.
Figure 3
Curve 3 - 25 VDC Rated Capacitor
Curve 2 - 50 VDC Rated Capacitor
Curve 1 - 100 VDC Rated Capacitor
Curve 3
Curve 2
Curve 1
.5
1.0
1.5
2.0
2.5
AC Measurement Volts at 1.0 KHz
Dissipation
Factor
Percent
10.0
8.0
6.0
4.0
2.0
0
D.F. vs. A.C. Measurement Volts
AVX X7R T.C.
Figure 4
Figure 5
相關PDF資料 |
PDF描述 |
|---|---|
| 12061A100J-MR | CAP. 10PF MINIREEL 500PCS |
| 12061A101JAT2A | KONDENSATOR 100PF 100V 10ST |
| 12061A101J-MR | CAP. 100PF MINIREEL 500PCS |
| 12061A102JAT2A | KONDENSATOR 1000PF 100V 10ST |
| 12061A102J-MR | CAP. 1NF MINIREEL 500PCS |
相關代理商/技術參數 |
參數描述 |
|---|---|
| 12061A100JAT2A/4K | 制造商:AVX Corporation 功能描述:CAP CER 10PF 100V 5% NP0 1206 |
| 12061A100JAT4A | 功能描述:多層陶瓷電容器MLCC - SMD/SMT 1206 10pF 100volts C0G 5% RoHS:否 制造商:American Technical Ceramics (ATC) 電容:10 pF 容差:1 % 電壓額定值:250 V 溫度系數/代碼:C0G (NP0) 外殼代碼 - in:0505 外殼代碼 - mm:1414 工作溫度范圍:- 55 C to + 125 C 產品:Low ESR MLCCs 封裝:Reel |
| 12061A100JATMA | 制造商:AVX Corporation 功能描述: 制造商:AVX Corporation 功能描述:C1206G100J100 |
| 12061A100JATME | 制造商:AVX Corporation 功能描述: |
| 12061A100J-MR | 制造商:未知廠家 制造商全稱:未知廠家 功能描述:CAP. 10PF MINIREEL 500PCS |
發布緊急采購，3分鐘左右您將得到回復。