參數資料
型號： 13745
廠商： Linear Technology Corporation
元件分類： 基準電壓源/電流源
英文描述： RADIATION HARDENED HIGH EFFICIENCY, 5 AMP SWITCHING REGULATORS
中文描述： 抗輻射高效，5安培開關穩壓器
文件頁數： 6/32頁
文件大?。?/td> 309K
代理商： 13745
6
LT1374
1374fb
FB/SENSE:
The feedback pin is the input to the error
amplifier which is referenced to an internal 2.42V source.
An external resistive divider is used to set the output
voltage. The fixed voltage (-5) parts have the divider
included on-chip and the FB pin is used as a SENSE pin,
connected directly to the 5V output. Three additional
functions are performed by the FB pin. When the pin
voltage drops below 1.7V, switch current limit is reduced.
Below 1.5V the external sync function is disabled. Below
1V, switching frequency is also reduced. See Feedback Pin
Function section in Applications Information for details.
BOOST:
The BOOST pin is used to provide a drive voltage,
higher than the input voltage, to the internal bipolar NPN
power switch. Without this added voltage, the typical
switch voltage loss would be about 1.5V. The additional
boost voltage allows the switch to saturate and voltage
loss approximates that of a 0.07
FET structure. Effi-
ciency improves from 75% for conventional bipolar de-
signs to > 89% for these new parts.
V
IN
:
This is the collector of the on-chip power NPN switch.
This pin powers the internal circuitry and internal regulator
when the BIAS pin is not present. At NPN switch on and off,
high dI/dt edges occur on this pin. Keep the external
bypass and catch diode close to this pin. All trace induc-
tance on this path will create a voltage spike at switch off,
adding to the V
CE
voltage across the internal NPN. Both V
IN
pins of the 16-lead TSSOP package must be shorted
together on the PC board.
GND:
The GND pin connection needs consideration for
two reasons. First, it acts as the reference for the regulated
output, so load regulation will suffer if the “ground” end of
the load is not at the same voltage as the GND pin of the
IC. This condition will occur when load current or other
currents flow through metal paths between the GND pin
and the load ground point. Keep the ground path short
between the GND pin and the load and use a ground plane
when possible. The second consideration is EMI caused
by GND pin current spikes. Internal capacitance between
the V
SW
pin and the GND pin creates very narrow (<10ns)
current spikes in the GND pin. If the GND pin is connected
to system ground with a long metal trace, this trace may
radiate excess EMI. Keep the path between the input
bypass and the GND pin short.
V
SW
:
The switch pin is the emitter of the on-chip power
NPN switch. This pin is driven up to the input pin voltage
during switch on time. Inductor current drives the switch
pin negative during switch off time. Negative voltage is
clamped with the external catch diode. Maximum negative
switch voltage allowed is –0.8V. Both V
SW
pins of the
16-lead TSSOP package must be shorted together on the
PC board.
BOOST Pin Current
SWITCH CURRENT (A)
0
0
B
10
20
40
30
60
50
1
2
3
4
5
1374 G16
80
70
100
90
DUTY CYCLE = 100%
Inductor Core Loss
INDUCTANCE (
μ
H)
0
5
C
C
1.0
0.1
0.01
0.001
10
15
20
20
12
8
4
2
1.2
0.8
0.4
0.2
0.12
0.08
0.04
0.02
25
1374 G01
TYPE 52
POWDERED IRON
Kool M
μ
PERMALLOY
μ
= 125
V
OUT
= 5V, V
IN
= 10V, I
OUT
= 1A
CORE LOSS IS
INDEPENDENT OF LOAD
CURRENT UNTIL LOAD CURRENT FALLS
LOW ENOUGH FOR CIRCUIT TO GO INTO
DISCONTINUOUS MODE
V
C
Pin Shutdown Threshold
JUNCTION TEMPERATURE (
°
C)
–50
1.4
1.2
1.0
0.8
0.6
0.4
100
1374 G11
–25
0
25
50
75
125
T
SHUTDOWN
TYPICAL PERFOR U
PIU
相關PDF資料
PDF描述
1374HV RADIATION HARDENED HIGH EFFICIENCY, 5 AMP SWITCHING REGULATORS
1374HVI RADIATION HARDENED HIGH EFFICIENCY, 5 AMP SWITCHING REGULATORS
1374I RADIATION HARDENED HIGH EFFICIENCY, 5 AMP SWITCHING REGULATORS
1374I5 RADIATION HARDENED HIGH EFFICIENCY, 5 AMP SWITCHING REGULATORS
1374SN RADIATION HARDENED HIGH EFFICIENCY, 5 AMP SWITCHING REGULATORS
相關代理商/技術參數
參數描述
13-7450-10 功能描述:IC 與器件插座 ELEVATOR STRIP LINE 13 PINS RoHS:否 制造商:Molex 產品:LGA Sockets 節距:1.02 mm 排數: 位置/觸點數量:2011 觸點電鍍:Gold 安裝風格:SMD/SMT 端接類型:Solder 插座/封裝類型:LGA 2011 工作溫度范圍:- 40 C to + 100 C
1374510-1 制造商:TE Connectivity 功能描述:C/A, SM BUF FIB, SC 1M1 - Bulk
1374515-1 制造商:TE Connectivity 功能描述:CA FIBER OPTIC 1M SGL MODE 2 SC SIMPLEX TO 2 LC SIMPLEX - Bulk
1374515-2 制造商:TE Connectivity 功能描述:CA FIBER OPTIC 2M SIMPLEX SC TO SIMPLEX LC - Bulk
1374515-3 制造商:TE Connectivity 功能描述:CA FIBER OPTIC 3M SIMPLEX SC TO SIMPLEX LC - Bulk 制造商:TE Connectivity 功能描述:Fiber Optic Cable Assemblies
發布緊急采購，3分鐘左右您將得到回復。

采購需求

(若只采購一條型號，填寫一行即可)

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

*型號 *數量 廠商 批號 封裝
添加更多采購

我的聯系方式

*
*
*