- 您現在的位置：買賣IC網 > PDF目錄2021 > 19588 (Desco)CONTR HAND GUN W/HOSE 220V NIST PDF資料下載
參數資料
| 型號： | 19588 |
| 廠商： | Desco |
| 文件頁數： | 3/4頁 |
| 文件大?。?/td> | 0K |
| 描述： | CONTR HAND GUN W/HOSE 220V NIST |
| 標準包裝： | 1 |
| 類型： | 電離器，風槍 |
| 安裝類型： | 臺式 |
| 輸入電壓： | 220VAC |
TB-2079 Page 3 of 4
DESCO WEST - 3651 Walnut Avenue, Chino, CA 91710 (909) 627-8178 Fax (909) 627-7449
DESCO EAST - One Colgate Way, Canton, MA 02021-1407 (781) 821-8370 Fax (781) 575-0172 Web Site: Desco.com
air volume or a brownish color to the filter. If either of these
conditions exist, you should replace the filter by unsnapping
connectors. Depress air line connectors allowing removal of filter.
The filter replacement is sold as Desco Item #60355 (two filters to
a package). Be sure to observe the flow direction on filter when
installing a replacement.
Installation of the Controller and
Ion Python Attachment
The mounting slots on the bottom of the controller allow for easy
mounting of the base. Install screws either on a wall or bench.
Using the mounting slots, place controller on the screws for secure
mounting of the unit. Mounting the controller underneath a bench
or on a wall saves valuable bench space. After mounting the unit,
a locking screw is provided on the back of the unit to prevent
accidental removal.
Figure 7. Installing controller to bench.
Neutralization Efficiency (Decay Time)
The comparative neutralization efficiency of ionizers is determined
by a standard test published by the ESD Association Standard
3.1. The decay rates measured using this standard are shown
in the chart below. This performance was measured with the air
nozzle at a distance of 6” from the charged plate and utilizing an
air pressure of 30 PSIG.
Decay rate per EOS/ESD S-3.1
Test Pressure
Decay rate
30 PSI
2 seconds
Charge Decay Time Constants
Notes:
1) Decay times are from 1,000 volts to 100 volts.
2) The air nozzle’s air stream is
perpendicular to the charged plate.
These units need very little maintenance. In order to maintain
the optimum performance of your unit, the following maintenance
procedures must be performed on a regular basis.
Make sure that the air supply is clean and free of contamination
and moisture. Drain compressor tank and filters periodically.
The filters may require
draining several times
daily, depending on your
compressed air system.
The fuse may be replaced
by removing the power
cord at the back of the
unit and opening the fuse
box at the IEC receptacle.
The controller uses a 1
amp fast acting fuse.
For
safety, do not use other
ratings.
Figure 4. Replacing the fuse.
Do not attempt to perform any repairs or adjustments on your
Desco equipment except for those covered in the operation
manual. Self-made repairs could create a hazard and will void the
warranty.
replacing the Air Nozzle Assembly
The air nozzle and hose assembly is designed to be removed or
replaced by the user in the event of damage or wear. To replace
the assembly, simply unscrew the collar at the base of the hose
and gently disconnect the connector from the receptacle.
To replace the nozzle assembly simply repeat the process in
reverse.
NOTE: Make sure the fittings inside the connector are properly
aligned with their receptacles before tightening the threaded collar.
replacing the Air Filter of the Ion Python
Periodic replacement of the air filter is recommended for
optimum performance of the ionizer. Compress outer sleeving
away from the filter housing. Examine the filter for any evidence
of contamination. The filter will turn red if there is any oil
contamination. If there has been moisture build-up, there will be a
change in
Locking screw inside unit
helps secure Python Controller
ION
PYTHON
CONTROLLER
2010 DESCO INDUSTRIES INC.
Employee Owned
Depress
to release
Nozzle
Charged Plate
Figure 5. Replacing air nozzle assembly
Figure 6. Air filter replacement.
Figure 9. EOS/ESD S-3.1 decay time test set up.
相關PDF資料 |
PDF描述 |
|---|---|
| 19635 | TESTER MINIMEG 9VDC NIST |
| 19665 | MONITOR DUAL WIRE CONTINOUS 120V |
| 19780 | KIT METER RES DIG TEMP/HUMIDITY |
| 19784 | TEST KIT SURFACE RESISTANCE |
| 19851 | WRIST STRAP DUAL ASSY 12' CORD |
相關代理商/技術參數 |
參數描述 |
|---|---|
| 1958800000 | 功能描述:CONN PLUG TERM BLOCK 5.00MM 9POS RoHS:是 類別:連接器，互連式 >> 接線座 - 接頭，插頭和插口 系列:Omnimate BLZP 產品培訓模塊:BLF Push-In Connector Technology PCB Connection Technology 產品目錄繪圖:BLF Series 5.08/270F 特色產品:BLF Pluggable PCB Connectors 標準包裝:24 系列:Omnimate BLF 端接塊類型:插頭，母插口 每電平位置:12 間距:0.200"（5.08mm） 級別數目:1 接頭定向:- 插頭導線入口:270° 端子:無螺絲 － 按入式 線規:12-26 AWG 電流:10A 電壓:300V 安裝類型:自由懸掛 特點:法蘭，固定鎖（非導線側） 顏色:黑 包裝:散裝 產品目錄頁面:336 (CN2011-ZH PDF) 配套產品:1513660000-ND - CONN HDR 5.08MM 12POS 90 ORG1513610000-ND - CONN HDR 5.08MM 12POS 90 BLK1515960000-ND - CONN HDR 5.08MM 12POS 90 ORG281-1285-ND - CONN HEADER RT ANG 5.08MM 12POS 其它名稱:281-2711 |
| 195881-000 | 制造商:TE Connectivity 功能描述:Connector Accessories Tinel Lock Adapter Right Angle Aluminum Alloy Olive Drab Cadmium Over Electroless Nickel 制造商:TE Connectivity 功能描述:TXR41AB90-1804AI - Bulk 制造商:TE Connectivity 功能描述:ADPTR TINEL LOCK ANG SHELL 18,19 |
| 1958810000 | 功能描述:CONN PLUG TERM BLOCK 5.00MM 8POS RoHS:是 類別:連接器，互連式 >> 接線座 - 接頭，插頭和插口 系列:Omnimate BLZP 標準包裝:1 系列:OSTTS 端接塊類型:插頭，母插口 每電平位置:22 間距:0.138"（3.50mm） 級別數目:1 接頭定向:- 插頭導線入口:270° 端子:螺釘 線規:16-28 AWG 電流:8A 電壓:300V 安裝類型:自由懸掛 特點:- 顏色:綠 包裝:散裝 配套產品:OSTOQ221251-ND - CONN TERM BLK HEADER 22POS 3.5MMOSTOQ221250-ND - CONN TERM BLK HEADER 22POS 3.5MMOSTVK221150-ND - CONN TERM BLK HDR 22POS 3.5MM |
| 1958820000 | 功能描述:CONN PLUG TERM BLOCK 5.00MM 7POS RoHS:是 類別:連接器，互連式 >> 接線座 - 接頭，插頭和插口 系列:Omnimate BLZP 標準包裝:1 系列:OSTTS 端接塊類型:插頭，母插口 每電平位置:22 間距:0.138"（3.50mm） 級別數目:1 接頭定向:- 插頭導線入口:270° 端子:螺釘 線規:16-28 AWG 電流:8A 電壓:300V 安裝類型:自由懸掛 特點:- 顏色:綠 包裝:散裝 配套產品:OSTOQ221251-ND - CONN TERM BLK HEADER 22POS 3.5MMOSTOQ221250-ND - CONN TERM BLK HEADER 22POS 3.5MMOSTVK221150-ND - CONN TERM BLK HDR 22POS 3.5MM |
| 1958821 | 功能描述:可插拔接線端子 FK-MCP 1.5/ 2-ST- 3,81 CRWH SO RoHS:否 制造商:Phoenix Contact 產品:Plugs 系列:PTS 端接類型:Spring Cage 位置/觸點數量:5 線規量程:26-14 節距:5 mm 電流額定值:10 A 電壓額定值:250 V 安裝風格: 安裝角: 觸點電鍍: |
發布緊急采購，3分鐘左右您將得到回復。