- 您現在的位置：買賣IC網 > PDF目錄371379 > 2377-1 (Texas Instruments, Inc.) IEEE 802.3af PoE POWERED DEVICE CONTROLLERS WITH AUTO-RETRY PDF資料下載
參數資料
| 型號： | 2377-1 |
| 廠商： | Texas Instruments, Inc. |
| 英文描述： | IEEE 802.3af PoE POWERED DEVICE CONTROLLERS WITH AUTO-RETRY |
| 中文描述： | IEEE 802.3af標準的PoE用電設備控制器，自動重試 |
| 文件頁數： | 6/23頁 |
| 文件大?。?/td> | 649K |
| 代理商： | 2377-1 |
www.ti.com
1
2
3
4
5
6
7
8
VSS
CLASS
N/C
DET
RTN
PG
VDD
ILIM
Detailed Pin Description
The following descriptions refer to the schematic of Figure 1 and the functional block diagram.
I(LIM)
25000
R(ILIM)
(1)
TPS2375-1
TPS2377-1
SLVS570–MARCH 2005
DEVICE INFORMATION (continued)
TPS2375-1/77-1
(TOP VIEW)
TERMINAL FUNCTIONS
PIN NAME
PIN NUMBER
I/O
DESCRIPTION
Connect a resistor from ILIM to VSS to set the start-up inrush current limit. The
equation for calculating the resistor is shown in the detailed pin description section for
ILIM.
Connect a resistor from CLASS to VSS to set the classification of the powered device
(PD). The IEEE classification levels and corresponding resistor values are shown in
Table 1.
Connect a 24.9-k
detection resistor from DET to VDD for a valid PD detection.
Return line on the source side of the TPS2375-1 from the PSE.
Switched output side return line used as the low-side reference for the TPS2375-1
load.
Open-drain, power-good output; active high.
No connection
Positive line from the rectified PSE provided input.
ILIM
1
O
CLASS
2
O
DET
VSS
3
4
O
I
RTN
5
O
PG
NC
VDD
6
7
8
O
I
ILIM
:
A resistor from this pin to VSS sets the inrush current limit per Equation 1:
where ILIM is the desired inrush current value, in amperes, and R
is the value of the programming resistor
from ILIM to VSS, in ohms. The practical limits on R
(ILIM)
are 62.5 k
to 500 k
. A value of 178 k
is
recommended for compatibility with legacy power sourcing equipment (PSE).
Inrush current limiting prevents current drawn by the bulk capacitor from causing the line voltage to sag below
the lower UVLO threshold. Adjustable inrush current limiting allows the use of arbitrarily large capacitors and also
accommodates legacy systems that require low inrush currents.
The ILIM pin must not be left open or shorted to VSS.
CLASS:
Classification is implemented by means of an external resistor, R
(CLASS)
, connected between CLASS
and VSS. The controller draws current from the input line through R
(CLASS)
when the input voltage lies between
13 V and 21 V. The classification currents specified in the electrical characteristics table include the bias current
flowing into VDD and any RTN leakage current.
Table 1. CLASSIFICATION
CLASS
0
1
2
3
4
PD POWER (W)
0.44 – 12.95
0.44 – 3.84
3.84 – 6.49
6.49 – 12.95
-
R
(CLASS)
(
)
4420
±
1%
953
±
1%
549
±
1%
357
±
1%
255
±
1%
802.3af LIMITS (mA)
0 - 4
9 - 12
17 - 20
26 - 30
36 - 44
NOTE
Default class
Reserved for future use
6
相關PDF資料 |
PDF描述 |
|---|---|
| 238.2 | 5 Volt and 3.3 Volt MicroMonitor |
| 238.25 | Fuse |
| 238.3 | 5 Volt and 3.3 Volt MicroMonitor |
| 238.4 | Fuse |
| 238.5 | Fuse |
相關代理商/技術參數 |
參數描述 |
|---|---|
| 2377-12-020 | 制造商:Coto Technology 功能描述:RELAY REED DPST 500MA 12V 制造商:Coto Technology 功能描述:RELAY REED DPST-NO 12VDC 5 制造商:Coto Technology 功能描述:RELAY REED DPST-NO 12VDC 500MA TH 制造商:Coto Technology 功能描述:RELAY, REED, DPST-NO, 12VDC, 500MA, TH 制造商:Coto Technology 功能描述:Reed Relays 2 Form A Relay 制造商:Coto Technology 功能描述:RELAY, REED, DPST-NO, 12VDC, 500MA, TH, Coil Voltage VDC Nom:12V, Coil Resistance:500ohm, Switching Current Max:500mA, Switching Voltage Max:200V, Contact Configuration:DPST-NO, Relay Mounting:Through Hole, External Height:9.7mm 制造商:Coto Technology 功能描述:Relays |
| 23-772 | 制造商:MCM 功能描述:3M RA DC EXTENSION CORD 2.1MM DC PLUG; 2.1MM DC JACK |
| 2377-2 | 制造商:KR 制造商全稱:KR Electronics, Inc. 功能描述:Bandpass Filter |
| 23-773 | 制造商:MCM 功能描述:5M RA DC EXTENSION CORD 2.1MM DC PLUG; 2.1MM DC JACK |
| 2377-3 | 制造商:KR 制造商全稱:KR Electronics, Inc. 功能描述:Bandpass Filter |
發布緊急采購，3分鐘左右您將得到回復。