- 您現在的位置：買賣IC網 > PDF目錄371425 > 27C512-55 (Macronix International Co., Ltd.) 512K-BIT [64Kx8] CMOS EPROM PDF資料下載
參數資料
| 型號： | 27C512-55 |
| 廠商： | Macronix International Co., Ltd. |
| 英文描述： | 512K-BIT [64Kx8] CMOS EPROM |
| 中文描述： | 為512k位[64Kx8]的CMOS存儲器 |
| 文件頁數： | 3/15頁 |
| 文件大?。?/td> | 772K |
| 代理商： | 27C512-55 |
3
P/N:PM0235
REV. 4.8, AUG. 26, 2003
MX27C512
NOTES:
1. VH = 12.0 V
±
0.5 V
2. X = Either VIH or VIL
3. A1 - A8 = A10 - A15 = VIL(For auto select)
4. See DC Programming Characteristics for VPP voltage during
programming.
MODE SELECT TABLE
PINS
MODE
CE
OE/VPP
A0
A9
OUTPUTS
Read
VIL
VIL
X
X
DOUT
Output Disable
VIL
VIH
X
X
High Z
Standby (TTL)
VIH
X
X
X
High Z
Standby (CMOS)
VCC
±
0.3V
X
X
X
High Z
Program
VIL
VPP
X
X
DIN
Program Verify
VIL
VIL
X
X
DOUT
Program Inhibit
VIH
VPP
X
X
High Z
Manufacturer Code(3)
VIL
VIL
VIL
VH
C2H
Device Code(3)
VIL
VIL
VIH
VH
91H
TWO-LINE OUTPUT CONTROL FUNCTION
To accommodate multiple memory connections, a two-
line control function is provided to allow for:
1. Low memory power dissipation,
2. Assurance that output bus contention will not
occur.
It is recommended that CE be decoded and used as the
primary device-selecting function, while OE be made a
common connection to all devices in the array and
connected to the READ line from the system control bus.
This assures that all deselected memory devices are in
their low-power standby mode and that the output pins
are only active when data is desired from a particular
memory device.
SYSTEM CONSIDERATIONS
During the switch between active and standby
conditions, transient current peaks are produced on the
rising and falling edges of Chip Enable. The magnitude
of these transient current peaks is dependent on the
output capacitance loading of the device. At a minimum,
a 0.1 uF ceramic capacitor (high frequency, low inherent
inductance) should be used on each device between
VCC and GND to minimize transient effects. In addition,
to overcome the voltage drop caused by the inductive
effects of the printed circuit board traces on EPROM
arrays, a 4.7 uF bulk electrolytic capacitor should be
used between VCC and GND for each eight devices.
The location of the capacitor should be close to where
the power supply is connected to the array.
相關PDF資料 |
PDF描述 |
|---|---|
| 27C512-70 | 512K-BIT [64Kx8] CMOS EPROM |
| 27C512-90 | 512K-BIT [64Kx8] CMOS EPROM |
| 27C512A-90L | 512K (64K x 8) CMOS EPROM |
| 27C512A-90ITS | 512K (64K x 8) CMOS EPROM |
| 27C512A-10ITS | 512K (64K x 8) CMOS EPROM |
相關代理商/技術參數 |
參數描述 |
|---|---|
| 27C512-55DI | 制造商:Rochester Electronics LLC 功能描述: |
| 27C512-55DM/B | 制造商:Rochester Electronics LLC 功能描述:- Bulk |
| 27C512-70 | 制造商:MCNIX 制造商全稱:Macronix International 功能描述:512K-BIT [64Kx8] CMOS EPROM |
| 27C512-70DM/B | 制造商:Rochester Electronics LLC 功能描述: |
| 27C512-70WMB | 制造商:Rochester Electronics LLC 功能描述:- Bulk |
發布緊急采購，3分鐘左右您將得到回復。