- 您現在的位置：買賣IC網 > PDF目錄371437 > 2927 (Allegro MicroSystems, Inc.) DUAL FULL-BRIDGE PWM MOTOR DRIVER PDF資料下載
參數資料
| 型號： | 2927 |
| 廠商： | Allegro MicroSystems, Inc. |
| 元件分類： | 基準電壓源/電流源 |
| 英文描述： | DUAL FULL-BRIDGE PWM MOTOR DRIVER |
| 中文描述： | 雙全橋PWM電機驅動 |
| 文件頁數： | 4/8頁 |
| 文件大小： | 78K |
| 代理商： | 2927 |
2927
DUAL FULL-BRIDGE
PWM MOTOR DRIVER
115 Northeast Cutoff, Box 15036
Worcester, Massachusetts 01615-0036 (508) 853-5000
APPLICATIONS INFORMATION
PWM CURRENT CONTROL:
The UDN2927EB dual bridge is designed
to drive both windings of a bipolar stepper
motor. Output current is sensed and con-
trolled independently in each bridge by an
external sense resistor (R
S
), internal com-
parator, and monostable multivibrator.
When the bridge is turned ON, current
increases in the motor winding and it is
sensed by the external sense resistor until
the sense voltage (V
SENSE
) reaches the level
set at the comparator’s input:
I
TRIP
= V
REF
/10 R
S
The comparator then triggers the mon-
ostable which turns OFF the source driver of
the bridge. The actual load current peak will
be slightly higher than the trip point (espe-
cially for low-inductance loads) because of
the internal logic and switching delays. This
delay (t
d
) is typically 2
μ
s. After turn-off, the
motor current will normally decay, circulating
through the external ground clamp diode and
sink transistor. The source driver’s OFF time
(and therefore the magnitude of the current
decrease) is determined by the monostable’s
external RC timing components, where t
off
=
R
T
C
T
within the range of 20 k
to 100 k
and 200 pF to 500 pF.
When the source driver is re-enabled, the
winding current (the sense voltage) is again
allowed to rise to the comparator’s threshold.
This cycle repeats itself, maintaining the
average motor winding current at the desired
level.
Special circuitry has been included to
prevent runaway current control when the
fixed OFF time (t
off
) is set too short. This
circuitry prevents the source driver from
being re-enabled until the load current has
decayed to below the I
TRIP
level.
PWM OUTPUT CURRENT WAVEFORM
+
–
0
V
PHASE
I
OUT
t
d
t
off
I
Dwg. WM-003-1A
LOAD CURRENT PATHS
Dwg. EP-006-14
RS
BB
V
BRIDGE ON
SOURCE OFF
ALL OFF
相關PDF資料 |
PDF描述 |
|---|---|
| 292A | Low Cost Single and Multichannel Isolation Amplifier |
| 290 | Low Cost Single and Multichannel Isolation Amplifier |
| 292 | Low Cost Single and Multichannel Isolation Amplifier |
| 290A | Low Cost Single and Multichannel Isolation Amplifier |
| 293-766-30 | 5-Pin, Multiple-Input, Programmable Reset ICs |
相關代理商/技術參數 |
參數描述 |
|---|---|
| 292-7.15K | 功能描述:厚膜電阻器 - SMD 7.15Kohms 1% Tol RoHS:否 制造商:Bourns 電阻:1.5 Ohms 容差:1 % 功率額定值:25 W 電壓額定值:250 V 外殼代碼 - in: 外殼代碼 - mm: 端接類型:SMD/SMT 溫度系數:100 PPM / C 系列:PWR163 工作溫度范圍:- 55 C to + 155 C 封裝:Tube |
| 292-7.15K-RC | 功能描述:厚膜電阻器 - SMD 1/10WATT 7.15KOHMS RoHS:否 制造商:Bourns 電阻:1.5 Ohms 容差:1 % 功率額定值:25 W 電壓額定值:250 V 外殼代碼 - in: 外殼代碼 - mm: 端接類型:SMD/SMT 溫度系數:100 PPM / C 系列:PWR163 工作溫度范圍:- 55 C to + 155 C 封裝:Tube |
| 292-7.32K | 功能描述:厚膜電阻器 - SMD 7.32Kohms 1% Tol RoHS:否 制造商:Bourns 電阻:1.5 Ohms 容差:1 % 功率額定值:25 W 電壓額定值:250 V 外殼代碼 - in: 外殼代碼 - mm: 端接類型:SMD/SMT 溫度系數:100 PPM / C 系列:PWR163 工作溫度范圍:- 55 C to + 155 C 封裝:Tube |
| 292-7.32K-RC | 功能描述:厚膜電阻器 - SMD 1/10WATT 7.32KOHMS RoHS:否 制造商:Bourns 電阻:1.5 Ohms 容差:1 % 功率額定值:25 W 電壓額定值:250 V 外殼代碼 - in: 外殼代碼 - mm: 端接類型:SMD/SMT 溫度系數:100 PPM / C 系列:PWR163 工作溫度范圍:- 55 C to + 155 C 封裝:Tube |
| 292-7.5K | 功能描述:厚膜電阻器 - SMD 7.5Kohms 1% Tol RoHS:否 制造商:Bourns 電阻:1.5 Ohms 容差:1 % 功率額定值:25 W 電壓額定值:250 V 外殼代碼 - in: 外殼代碼 - mm: 端接類型:SMD/SMT 溫度系數:100 PPM / C 系列:PWR163 工作溫度范圍:- 55 C to + 155 C 封裝:Tube |
發布緊急采購，3分鐘左右您將得到回復。