
PWM
Carrier waveform
Pulse
Source
Internal/External
Internal modulation
Sine, Square, Ramp, Triangle, Noise, Arb
(2 mHz to 20 kHz)
Deviation
0% to 100% of pulse width
FSK
Carrier waveforms
Sine, Square, Ramp, Arb
Source
Internal/External
Internal modulation
50% duty cycle square (2 mHz to 100 kHz)
External Modulation Input[6] (for AM, FM, PM, PWM)
Voltage range
± 5 V full scale
Input impedance
5 k
typical
Bandwidth
DC to 20 kHz
SWEEP
Waveforms
Sine, Square, Ramp, Arb
Type
Linear or Logarithmic
Direction
Up or Down
Sweep time
1 ms to 500 s
Trigger
Single, External, or Internal
Marker
falling edge of sync signal
(programmable frequency)
BURST[7]
Waveforms
Sine, Square, Ramp, Triangle, Pulse, Noise, Arb
Type
Counted (1 to 50,000 cycles), Infinite, Gated
Start/Stop Phase
-360° to +360°
Internal Period
1 s to 500 s
Gate Source
External trigger
Trigger source
Single, External or Internal
TRIGGER CHARACTERISTICS
Trigger input
Input level
TTL compatible
Slope
Rising or Falling, selectable
Pulse width
> 100 ns
Input impedance
>10 k
, DC coupled
Latency
< 500 ns
Jitter (rms)
6 ns (3.5 ns for pulse)
Trigger output
Level
TTL compatible into
≥ 1 k
Pulse width
> 400 ns
Output Impedance
50
, typical
Maximum rate
1 MHz
Fanout
≤ 4 Agilent 33220As
PROGRAMMING TIMES (typical)
Configuration times
USB
LAN
GPIB
Function Change
111 ms
Frequency Change
1.5 ms
2.7 ms
1.2 ms
Amplitude Change
30 ms
Select User Arb
124 ms
123 ms
Arb Download Times (binary transfer)
USB
LAN
GPIB
64K points
96.9 ms
191.7 ms
336.5 ms
16K points
24.5 ms
48.4 ms
80.7 ms
4K points
7.3 ms
14.6 ms
19.8 ms
GENERAL
Power Supply
CAT II
100 - 240V @ 50/60Hz (-5%, +10%)
100 - 120V @ 400Hz (±10%)
Power Consumption
50 VA max
Operating Environment
IEC 61010
Pollution Degree 2
Indoor Location
Operating Temperature
0°C to 55°C
Operating Humidity
5% to 80% RH, non-condensing
Operating Altitude
Up to 3000 meters
Storage Temperature
-30°C to 70°C
State Storage Memory
Power off state automatically saved.
Four user-configurable stored states
Interface
USB, GPIB, and LAN standard
Language
SCPI - 1993, IEEE-488.2
Dimensions (W x H x D)
Bench top
261.1mm x 103.8mm x 303.2mm
Rack mount
212.8mm x 88.3mm x 272.3mm
Weight
3.4 kg (7.5 lbs)
Safety Designed to
UL-1244, CSA 1010, EN61010
EMC Tested to
MIL-461C, EN55011, EN50082-1
Vibration and Shock
MIL-T-28800, Type III, Class 5
Acoustic Noise
30 dBa
Warm-up Time
1 hour
Warranty
1 year
Footnotes
[1]
add 1/10th of output amplitude and offset spec per °C for operation
outside the range of of 18°C to 28°C
[2]
Autorange enabled
[3]
DC offset set to 0 V
[4]
spurious output at low amplitude is –75 dBm typical
[5]
add 1 ppm/°C average for operation outside the range of 18°C to 28°C
[6]
FSK uses trigger input (1 MHz maximum)
[7]
Sine and square waveforms above 6 MHz are allowed only with
an “infinite” burst count
3