參數資料
型號: 3583JM
元件分類: 運算放大器
英文描述: High Voltage, High Current OPERATIONAL AMPLIFIER
中文描述: 高電壓,大電流運算放大器
文件頁數: 5/6頁
文件大小: 113K
代理商: 3583JM
5
3583
TYPICAL PERFORMANCE CURVES (CONT)
T
CASE = +25°C, ±VCC = 150VDC, unless otherwise noted.
3583
0.1F
V+
–50V to –150V
R
2
R
1
V
O
G = 1 +
R
2
R
1
Connect case
to ground.
V–
+50V to +150V
3
4
100k
V+
Optional offset
voltage trim
circuit.
V
IN
3583
FIGURE 1. Basic Circuit Connections.
APPLICATION INFORMATION
Figure 1 shows the basic connections required to operate the
3583. Power supply bypass capacitors should be connected
close to the device pins. Be sure that these capacitors have an
adequate voltage rating.
Input offset voltage and drift of the 3583 are laser-trimmed.
Many applications require no external offset trimming.
Figure 1 also shows connection of an optional offset trim
potentiometer connected to pins 3 and 4.
FET input circuitry reduces the input bias current of the 3583
to less than 20pA at room temperature. Input bias current
remains nearly constant throughout the full common-mode
range. Input bias current approximately doubles for each 10
°C
increase in case temperature above 25
°C. Heat sinking can
help minimize this effect by reducing the case temperature.
Input circuitry of the 3583 is protected with series limiting
resistors and input clamp diodes. The inputs can withstand the
full rated supply voltage of
±150V (common-mode or differ-
ential).
THERMAL PROTECTION
The 3583 has internal thermal shut-down circuitry that acti-
vates at a case temperature of approximately 150
°C or higher.
As this circuitry is activated, the output current drive is
reduced. As the case temperature returns to less than the
activation temperature, operation will return to normal. A heat
sink may be required depending on load and signal conditions.
Note that a 75mA output may not be safe for all output
voltages—see typical performance curve “Safe Operating
Area”. Applications such as current sources where output
voltage may be low (or the opposite polarity of the output
current) can overstress the output stage.
The thermal shut-down circuit will normally protect the
amplifier during a short-circuit to ground. It will not protect
against short-circuit to one of the power supplies. The typical
performance curve “Safe Operating Area” shows that the
large stress occurring during this high voltage condition may
cause damage if it exceeds 5ms duration. The thermal
protection circuitry will not activate fast enough to protect
the device from short-circuits to one of the power supplies.
The package case of the 3583 is electrically isolated from all
circuitry. No special insulating hardware is required.
Although not absolutely required, it is recommended that the
case be connected to ground.
相關PDF資料
PDF描述
3584JM High Voltage, High Speed OPERATIONAL AMPLIFIER
3584 High Voltage, High Speed OPERATIONAL AMPLIFIER
35863-1127 11 CONTACT(S), FEMALE, RIGHT ANGLE FFC/FPC CONNECTOR, SURFACE MOUNT
35863-1227 12 CONTACT(S), FEMALE, RIGHT ANGLE FFC/FPC CONNECTOR, SURFACE MOUNT
35863-1327 13 CONTACT(S), FEMALE, RIGHT ANGLE FFC/FPC CONNECTOR, SURFACE MOUNT
相關代理商/技術參數
參數描述
3583KTR 功能描述:FUSE CLIP ON TAPE AND REEL WITH 制造商:keystone electronics 系列:3583KTR 零件狀態:在售 保險絲座類型:夾 保險絲類型:刀片 配套使用產品/相關產品:APM,ATM,297,997 保險絲尺寸:- 電路數:1 電壓:- 額定電流:15A 安裝類型:表面貼裝 朝向:垂直 端子類型:SMD(SMT)接片 觸頭材料:黃銅 觸頭鍍層:錫 標準包裝:1
3584 制造商:VISUAL COMMUNICATIONS COMPANY LLC 功能描述:3584 /Custom Part
35840 功能描述:BLOW VAC 120VAC RoHS:是 類別:工具 >> 真空 系列:Menda® Blow Vac 標準包裝:1 系列:-
35-840 功能描述:基本/快動開關 SNAP SWITCH RoHS:否 制造商:Omron Electronics 觸點形式:SPDT 執行器:Lever 電流額定值:5 A 電壓額定值 AC:250 V 電壓額定值 DC:30 V 功率額定值: 工作力:120 g IP 等級:IP 67 NEMA 額定值: 端接類型:Wire 安裝:Panel
35-840-B37R 制造商:GC Electronics 功能描述: