參數資料
型號： 5962-9167102QXA
廠商： NATIONAL SEMICONDUCTOR CORP
元件分類： 穩壓器
英文描述： 3.2 A SWITCHING REGULATOR, 62 kHz SWITCHING FREQ-MAX, MBFM2
封裝： TO-3, 4 PIN
文件頁數： 6/29頁
文件大?。?/td> 658K
代理商： 5962-9167102QXA
(Continued)
PROCEDURE (Adjustable Output Voltage Versions)
EXAMPLE (Adjustable Output Voltage Versions)
3. Output Capacitor Selection (C
OUT)
A. The value of the output capacitor together with the induc-
tor defines the dominate pole-pair of the switching regulator
loop. For stable operation, the capacitor must satisfy the fol-
lowing requirement:
The above formula yields capacitor values between 10 F
and 2000 F that will satisfy the loop requirements for stable
operation. But to achieve an acceptable output ripple volt-
age, (approximately 1% of the output voltage) and transient
response, the output capacitor may need to be several times
larger than the above formula yields.
B. The capacitor’s voltage rating should be at last 1.5 times
greater than the output voltage. For a 10V regulator, a rating
of at least 15V or more is recommended.
Higher voltage electrolytic capacitors generally have lower
ESR numbers, and for this reasion it may be necessary to
select a capacitor rate for a higher voltage than would nor-
mally be needed.
3. Output Capacitor Selection (C
OUT)
A.
However, for acceptable output ripple voltage select
C
OUT ≥ 220 F
C
OUT = 220 F electrolytic capacitor
4. Catch Diode Selection (D1)
A. The catch-diode current rating must be at least 1.2 times
greater than the maximum load current. Also, if the power
supply design must withstand a continuous output short, the
diode should have a current rating equal to the maximum
current limit of the LM2575. The most stressful condition for
this diode is an overload or shorted output. See diode selec-
tion guide in
Figure 8.
B. The reverse voltage rating of the diode should be at least
1.25 times the maximum input voltage.
4. Catch Diode Selection (D1)
A. For this example, a 3A current rating is adequate.
B. Use a 40V MBR340 or 31DQ04 Schottky diode, or any of
the suggested fast-recovery diodes in
Figure 8.
5. Input Capacitor (C
IN)
An aluminum or tantalum electrolytic bypass capacitor lo-
cated close to the regulator is needed for stable operation.
5. Input Capacitor (C
IN)
A 100 F aluminum electrolytic capacitor located near the in-
put and ground pins provides sufficient bypassing.
To further simplify the buck regulator design procedure, National Semiconductor is making available computer design software to
be used with the Simple Switcher line of switching regulators. Switchers Made Simple (version 3.3) is available on a (312") dis-
kette for IBM compatible computers from a National Semiconductor sales office in your area.
www.national.com
14
相關PDF資料
PDF描述
5962-9167401QEA 3 A SWITCHING REGULATOR, 58 kHz SWITCHING FREQ-MAX, CDIP16
5962-9167401QXA 3 A SWITCHING REGULATOR, 58 kHz SWITCHING FREQ-MAX, MBFM2
5962-9167401QZA 3 A SWITCHING REGULATOR, 58 kHz SWITCHING FREQ-MAX, CDSO16
5962-9168901MXA BRUSHLESS DC MOTOR CONTROLLER, 2 A, CDIP28
5962-9168901QXA BRUSHLESS DC MOTOR CONTROLLER, 0.2 A, CDIP28
相關代理商/技術參數
參數描述
5962-9167201QEA 制造商:Rochester Electronics LLC 功能描述: 制造商:Texas Instruments 功能描述:
5962-9167601HXA 制造商:Micropac Industries Inc 功能描述:Optocoupler Logic-Out Open Collector DC-IN 1-CH 6-Pin 制造商:Micropac Industries, Inc. 功能描述:Optocoupler Logic-Out Open Collector DC-IN 1-CH 6-Pin
59629167702MZA 制造商:Integrated Device Technology Inc 功能描述:FIFO Mem Async Dual Depth/Width Uni-Dir 8K x 9 32-Pin LLCC
5962-9167703MXA 制造商:Integrated Device Technology Inc 功能描述:FIFO ASYNC DUAL DEPTH/WIDTH UNI-DIR 8KX9 28CDIP - Rail/Tube
5962-9167703MYA 制造商:Integrated Device Technology Inc 功能描述:FIFO ASYNC DUAL DEPTH/WIDTH UNI-DIR 8KX9 28CDIP - Rail/Tube
發布緊急采購，3分鐘左右您將得到回復。

采購需求

(若只采購一條型號，填寫一行即可)

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

*型號 *數量 廠商 批號 封裝
添加更多采購

我的聯系方式

*
*
*