- 您現在的位置：買賣IC網 > PDF目錄366258 > 6P8A (NEC Corp.) MOS INTEGRATED CIRCUIT 4-BIT SINGLE-CHIP MICROCONTROLLER FOR INFRARED REMOTE CONTROL TRANSMISSION PDF資料下載
參數資料
| 型號： | 6P8A |
| 廠商： | NEC Corp. |
| 英文描述： | MOS INTEGRATED CIRCUIT 4-BIT SINGLE-CHIP MICROCONTROLLER FOR INFRARED REMOTE CONTROL TRANSMISSION |
| 中文描述： | 馬鞍山集成電路4位單片機的紅外遙控傳輸 |
| 文件頁數： | 21/95頁 |
| 文件大?。?/td> | 692K |
| 代理商： | 6P8A |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁當前第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁第42頁第43頁第44頁第45頁第46頁第47頁第48頁第49頁第50頁第51頁第52頁第53頁第54頁第55頁第56頁第57頁第58頁第59頁第60頁第61頁第62頁第63頁第64頁第65頁第66頁第67頁第68頁第69頁第70頁第71頁第72頁第73頁第74頁第75頁第76頁第77頁第78頁第79頁第80頁第81頁第82頁第83頁第84頁第85頁第86頁第87頁第88頁第89頁第90頁第91頁第92頁第93頁第94頁第95頁
21
μ
PD6P8, 6P8A, 6P8B
Data Sheet U17848EJ3V0DS
4.2.2 S
0
port (bit 2 of P1)
The S
0
port is an input/OFF mode port.
The pin state can be read by setting this port to input mode using bit 0 of the P4 register.
In input mode, the use of a pull-down resistor for the S
0
and S
1
/LED port can be specified in 2-bit units by software
using bit 4 of the P4 register.
If input mode is released (thus set to OFF mode), the pin becomes high-impedance but is configured so that
through current does not flow internally. In OFF mode, 1 can be read regardless of the pin state.
After reset, S
0
is set to OFF mode, thus becoming high-impedance.
4.2.3 S
1
/LED port (bit 3 of P1)
The S
1
/LED port is an I/O port.
Input or output mode can be set using bit 2 of the P4 resister. The pin state can be read in both input mode
and output mode.
When in input mode, the use of a pull-down resistor for the S
0
and S
1
/LED ports can be specified in 2-bit units
by software using bit 4 of the P4 register.
When in output mode, the pull-down resistor is automatically disconnected and this pin becomes the remote
control transmission display pin (refer to
5 TIMER
).
After reset, S
1
/LED is placed in output mode, and a high level is output.
4.2.4 S
2
port (bit 1 of P1)
The S
2
port is an input port.
Use of STOP mode release for the S
2
port can be specified by bit 3 of the P4 register.
When using the pin as a key input from a key matrix, enable (bit 3 of the P4 register is set to 1) the use of STOP
mode release (at this time, a pull-down resistor is connected internally.) When STOP mode release is disabled
(bit 3 of the P4 register is set to 0), it can be used as an input port that does not release the STOP mode even if
the release condition is met (at this time, a pull-down resistor is not connected internally.)
The state of the pin can be read in both cases.
After reset, S
2
is set to input mode where the STOP mode release is disabled, and enters a high-impedance
state.
相關PDF資料 |
PDF描述 |
|---|---|
| 6P8B | MOS INTEGRATED CIRCUIT 4-BIT SINGLE-CHIP MICROCONTROLLER FOR INFRARED REMOTE CONTROL TRANSMISSION |
| 6PHR60 | FAST RECOVERY SINGLE-PHASE FULL WAVE BRIDGE 6 AMPERES FOR P.C. BOARD AND HEAT SINK MOUNTING 200 NANOSECOND FAST RECOVERY |
| 6PHR | FAST RECOVERY SINGLE-PHASE FULL WAVE BRIDGE 6 AMPERES FOR P.C. BOARD AND HEAT SINK MOUNTING 200 NANOSECOND FAST RECOVERY |
| 6PHR05 | FAST RECOVERY SINGLE-PHASE FULL WAVE BRIDGE 6 AMPERES FOR P.C. BOARD AND HEAT SINK MOUNTING 200 NANOSECOND FAST RECOVERY |
| 6PHR10 | FAST RECOVERY SINGLE-PHASE FULL WAVE BRIDGE 6 AMPERES FOR P.C. BOARD AND HEAT SINK MOUNTING 200 NANOSECOND FAST RECOVERY |
相關代理商/技術參數 |
參數描述 |
|---|---|
| 6P8B | 制造商:NEC 制造商全稱:NEC 功能描述:MOS INTEGRATED CIRCUIT 4-BIT SINGLE-CHIP MICROCONTROLLER FOR INFRARED REMOTE CONTROL TRANSMISSION |
| 6PA1 | 功能描述:開關配件 Enclose Basic Switch RoHS:否 制造商:C&K Components 類型:Cap 用于:Pushbutton Switches 設計目的: |
| 6PA102 | 功能描述:開關配件 YOKE ROLLER NYLON BOTH MNT ON FRONT RoHS:否 制造商:C&K Components 類型:Cap 用于:Pushbutton Switches 設計目的: |
| 6PA102-4 | 制造商:Honeywell Sensing and Control 功能描述:Limit Switch-Sp Part |
| 6PA104 | 功能描述:開關配件 SWITCH PACKET NYLON RoHS:否 制造商:C&K Components 類型:Cap 用于:Pushbutton Switches 設計目的: |
發布緊急采購，3分鐘左右您將得到回復。