- 您現在的位置：買賣IC網 > PDF目錄67351 > 70IMX4-15-8 (POWER-ONE INC) 1-OUTPUT 4.2 W DC-DC REG PWR SUPPLY MODULE PDF資料下載
參數資料
| 型號： | 70IMX4-15-8 |
| 廠商： | POWER-ONE INC |
| 元件分類： | 電源模塊 |
| 英文描述： | 1-OUTPUT 4.2 W DC-DC REG PWR SUPPLY MODULE |
| 封裝： | 8.5 MM, DIP-24 |
| 文件頁數： | 10/12頁 |
| 文件大?。?/td> | 180K |
| 代理商： | 70IMX4-15-8 |
REV. AUG 05, 2004
Page 7 of 12
www.power-one.com
IMX4 DC-DC Series Data Sheet
4-Watt DC-DC Converters
Thermal Considerations
If a converter, mounted on a PCB, is located in free, quasi-
stationary air (convection cooling) at the indicated maximum
ambient
temperature
TA max
(see
table:
Temperature
specifications) and is operated at its nominal input voltage and
output power, the case temperature
TC measured at the:
Measuring point of case temperature TC (see: Mechanical Data)
will approach the indicated value
TC max after the warm-up phase.
However, the relationship between
TA and TC depends heavily on
the conditions of operation and integration into a system. The
thermal conditions are influenced by input voltage, output
current, airflow, temperature of surrounding components and
surfaces and the properties of the printed circuit board.
TA max is
therefore only an indicative value and under practical operating
conditions, the ambient temperature
TA may be higher or lower
than this value.
Caution: The case temperature
TC measured at the Measuring
point of case temperature TC (see: Mechanical Data) may under
no circumstances exceed the specified maximum value. The
installer must ensure that under all operating conditions
TC
remains within the limits stated in the table:
Temperature
specifications.
Short Circuit Behavior
The current limit characteristic shuts down the converter whenever
a short circuit is applied to its output. It acts self-protecting and
automatically recovers after removal of the overload condition.
Output Overvoltage Protection
The outputs of the IMX4 converters are protected against
overvoltages by Zener diodes. In the event of an overvoltage
on the output, the unit will shut-down and attempt to restart
automatically. The main purpose of this feature is to protect
against possible overvoltages which could occur due to a
failure in the feedback control circuit. The units are not
designed to withstand external overvoltages applied to the
outputs.
Connection in Series
The outputs of single or dual output units can be connected in
series without any precautions, taking into consideration that
the highest output voltage should remain below 60 V for SELV
operation.
Connection in Parallel
Several
converters
with
equal
output
voltage
can
be
connected in parallel and will share their output current quite
equally. However, this may cause start-up problems at initial
start-up, and is only recommended in applications where one
converter is able to deliver the full load current, e.g, in true
redundant systems.
Fig. 10
Vo versus Io (typ) of single output units (example for
20/40IMX4-05)
Fig. 11
Vo versus Io (typ) of dual output units (±15 V), with 30 V
load connected to Vo+ and Vo–.
Fig. 12
Cross load regulation of dual output units. Vo1 versus
Io1 (typ) for various Io2 (40IMX4-1515).
Fig. 13
Flexible load distribution on dual outputs (2
∞ 12 V) with
load variation from 0 to 150% of Po1 nom on output 1.
Output 2 loaded with 25% of Po2 nom.
Typical Performance Curves
5.25
5.0
4.75
4.5
4.25
4.0
0
0.1
0.2 0.3 0.4
0.5
0.6 0.7
0.8
0.9 1.0 I
o [A]
Vo [V]
05056
14
14.5
15
15.5
16
16.5
Vo1 [V]
20
40
60
80
100
120
140
Io1 [mA]
0
Io2 = 140 mA
Io2 = 14 mA
05058
28.5
29
29.5
30
30.5
31
31.5
Vo1 + Vo2 [V]
20
40
60
80
100
120
140
Io [mA]
0
05057
Vo1, Vo2 [V]
Io1
Io1 no
05059
12.8
12.4
12
11.6
11.2
030
60
90
120
150
[%]
Vo2
Vo1
相關PDF資料 |
PDF描述 |
|---|---|
| 70IMX4-05-9Z | 1-OUTPUT 4 W DC-DC REG PWR SUPPLY MODULE |
| 70IMX4-12-8Z | 1-OUTPUT 4 W DC-DC REG PWR SUPPLY MODULE |
| 70IMX4-03-8Z | 1-OUTPUT 4 W DC-DC REG PWR SUPPLY MODULE |
| 70IMX4-05-9 | 1-OUTPUT 3.5 W DC-DC REG PWR SUPPLY MODULE |
| 70IMX4-03-9 | 1-OUTPUT 4 W DC-DC REG PWR SUPPLY MODULE |
相關代理商/技術參數 |
參數描述 |
|---|---|
| 70IMX4-15-8G | 功能描述:DC DC CONVERTER 15V 4.2W 制造商:bel power solutions 系列:Melcher IMX4 零件狀態:在售 類型:隔離模塊，保形涂層 輸出數:1 電壓 - 輸入（最小值）:40V 電壓 - 輸入（最大值）:121V 電壓 - 輸出 1:15V 電壓 - 輸出 2:- 電壓 - 輸出 3:- 電壓 - 輸出 4:- 電流 - 輸出（最大值）:280mA 功率（W）:4.2W 電壓 - 隔離:2kV 應用:ITE（商業），鐵路 特性:OCP，OTP，OVP，SCP 工作溫度:-40°C ~ 85°C 效率:80.5% 安裝類型:通孔 封裝/外殼:24-DIP 模塊，13 引線 大小/尺寸:1.30" 長 x 0.79" 寬 x 0.33" 高（33.0mm x 20.1mm x 8.4mm） 供應商器件封裝:- 標準包裝:10 |
| 70IMX4-15-9 | 制造商:POWER-ONE 制造商全稱:Power-One 功能描述:4 Watt DC-DC Converters |
| 70IMX7-03-8 | 功能描述:DC/DC轉換器 7W (3V) DC Input (40-121V) RoHS:否 制造商:Murata 產品: 輸出功率: 輸入電壓范圍:3.6 V to 5.5 V 輸入電壓（標稱）: 輸出端數量:1 輸出電壓（通道 1）:3.3 V 輸出電流（通道 1）:600 mA 輸出電壓（通道 2）: 輸出電流（通道 2）: 安裝風格:SMD/SMT 封裝 / 箱體尺寸: |
| 70IMX7-03-8G | 功能描述:DC/DC轉換器 RoHS:否 制造商:Murata 產品: 輸出功率: 輸入電壓范圍:3.6 V to 5.5 V 輸入電壓（標稱）: 輸出端數量:1 輸出電壓（通道 1）:3.3 V 輸出電流（通道 1）:600 mA 輸出電壓（通道 2）: 輸出電流（通道 2）: 安裝風格:SMD/SMT 封裝 / 箱體尺寸: |
| 70IMX7-03-9 | 制造商:POWER-ONE 制造商全稱:Power-One 功能描述:7 Watt DC-DC Converters |
發布緊急采購，3分鐘左右您將得到回復。