參數資料
型號: 73K221AL
廠商: TDK Corporation
英文描述: V.22, V.21, Bell 212A, Bell 103 Single-Chip Modem with Integrated Hybrid
中文描述: .22,.21,貝爾212A章,貝爾103單芯片調制解調器集成混合
文件頁數: 7/26頁
文件大小: 286K
代理商: 73K221AL
73K222BL
V.22, V.21, Bell 212A, Bell 103
Single-Chip Modem with Integrated Hybrid
7
DTE USER
NAME
PIN
TYPE
DESCRIPTION
EXCLK
22
I
External Clock. This signal is used in synchronous transmission when the
external timing option has been selected. In the external timing mode the
rising edge of EXCLK is used to strobe synchronous DPSK transmit data
applied to on the TXD pin. Also used for serial control interface.
RXCLK
26
O
Receive Clock. The falling edge of this clock output is coincident with the
transitions in the serial received data output. The rising edge of RXCLK
can be used to latch the valid output data. RXCLK will be valid as long as
a carrier is present.
RXD
25
O/
Weak
Pull-up
Received Data Output. Serial receive data is available on this pin. The
data is always valid on the rising edge of RXCLK when in synchronous
mode. RXD will output constant marks if no carrier is detected.
TXCLK
21
O
Transmit Clock. This signal is used in synchronous transmission to latch
serial input data on the TXD pin. Data must be provided so that valid data
is available on the rising edge of the TXCLK. The transmit clock is derived
from different sources depending upon the synchronization mode
selection. In internal mode the clock is generated internally. In external
mode TXCLK is phase locked to the EXCLK pin. In slave mode TXCLK is
phase locked to the RXCLK pin. TXCLK is always active.
TXD
24
I
Transmit Data Input. Serial data for transmission is applied on this pin.
In synchronous modes, the data must be valid on the rising edge of the
TXCLK clock. In asynchronous modes (1200/600 bit/s or 300 baud) no
clocking is necessary. DPSK data must be 1200/600 bit/s +1%, -2.5%
or +2.3%, -2.5 % in extended over speed mode.
ANALOG INTERFACE AND OSCILLATOR
NAME
PIN
TYPE
DESCRIPTION
RXA
32
I
Received modulated analog signal input from the telephone line
interface.
TXA1
TXA2
18
17
O
Transmit analog output to the telephone line interface.
XTL1
XTL2
3
4
I
I
These pins are for the internal crystal oscillator requiring a 11.0592
MHz parallel mode crystal. Load capacitors should be connected from
XTL1 and XTL2 to ground. XTL2 can also be driven from an external
clock.
OH
27
O
Off-hook relay driver. This signal is an open drain output capable of
sinking 40 mA and is used for controlling a relay. The output is the
complement of the OH register bit in the ID Register.
相關PDF資料
PDF描述
73K222AL V.22, V.21, Bell 212A, 103 Single-Chip Modem
73K222AL-IGT V.22, V.21, Bell 212A, 103 Single-Chip Modem
73K222AL-IH V.22, V.21, Bell 212A, 103 Single-Chip Modem
73K222AL-IP V.22, V.21, Bell 212A, 103 Single-Chip Modem
73K222AU Single-Chip Modem Modem with UART
相關代理商/技術參數
參數描述
73K222AL 制造商:TERIDIAN 制造商全稱:TERIDIAN 功能描述:Single-Chip Modem
73K222AL-IGT 制造商:TDK 制造商全稱:TDK Electronics 功能描述:V.22, V.21, Bell 212A, 103 Single-Chip Modem
73K222AL-IH 制造商:TDK 制造商全稱:TDK Electronics 功能描述:V.22, V.21, Bell 212A, 103 Single-Chip Modem
73K222AL-IH/F 功能描述:電信集成電路 Single Chip Modem /103 Modem Data Pump RoHS:否 制造商:STMicroelectronics 類型:Telecom IC - Various 工作電源電壓:4.75 V to 5.25 V 電源電流: 工作溫度范圍:- 40 C to + 85 C 安裝風格:SMD/SMT 封裝 / 箱體:PQFP-100 封裝:Tray
73K222AL-IHR/F 功能描述:電信集成電路 Single Chip Modem /103 Modem Data Pump RoHS:否 制造商:STMicroelectronics 類型:Telecom IC - Various 工作電源電壓:4.75 V to 5.25 V 電源電流: 工作溫度范圍:- 40 C to + 85 C 安裝風格:SMD/SMT 封裝 / 箱體:PQFP-100 封裝:Tray