參數資料
型號: 73K224BL
廠商: Electronic Theatre Controls, Inc.
英文描述: Single-Chip Modem w/ Integrated Hybrid
中文描述: 單芯片調制解調器瓦特/集成混合
文件頁數: 30/33頁
文件大?。?/td> 237K
代理商: 73K224BL
73K224BL
V.22bis/V.22/V.21/Bell 212A/103
Single-Chip Modem w/ Integrated Hybrid
30
close to each other near the area of the board
where the phone line connection is accessed. To
avoid problems, power supply and ground traces
should be routed separately to the analog and
digital functions on the board, and digital signals
should not be routed near low level or high
impedance analog traces. The analog and digital
grounds should only connect at one point near the
K-Series device ground pin to avoid ground loops.
The K-Series modem ICs should have both high
frequency and low frequency bypassing as close
to the package as possible.
MODEM PERFORMANCE
CHARACTERISTICS
The curves presented here define modem IC
performance under a variety of line conditions
while inducing disturbances that are typical of
those encountered during data transmission on
public service telephone lines. Test data was
taken using an AEA Electronics’ “Autotest I”
modem test set and line simulator, operating
under computer control. All tests were run full-
duplex, using a Concord Data Systems 224 as the
reference modem. A 511 pseudo-random-bit
pattern was used for each data point. Noise was
C-message weighted and all signal-to-noise (S/N)
ratios reflect total power measurements similar to
the CCITT V.56 measurement specification. The
individual tests are defined as follows.
BER VS. S/N
This test measures the ability of the modem to
operate over noisy lines with a minimum of data-
transfer errors. Since some noise is generated in
the best of dial-up lines, the modem must operate
with the lowest S/N ratio possible. Better modem
performance is indicated by test curves that are
closest to the BER axis. A narrow spread between
curves representing the four line parameters
indicates minimal variation in performance while
operating over a range of operating conditions.
Typically, a DPSK modem will exhibit better BER
performance test curves receiving in the low band
than in the high band.
BER VS. RECEIVE LEVEL
This test measures the dynamic range of the
modem. Because signal levels vary widely over
dial-up lines, the widest possible dynamic range is
desirable. The minimum Bell specification calls for
36 dB of dynamic range. S/N ratios are held
constant at the indicated values while the receive
level is lowered from a very high to very low signal
levels. The width of the “bowl” of these curves,
taken at the BER point, is the measure of dynamic
range.
相關PDF資料
PDF描述
73K224BL-IGT Single-Chip Modem w/ Integrated Hybrid
73K224BL-IH Single-Chip Modem w/ Integrated Hybrid
73K324BL Single-Chip Modem w/Integrated Hybrid
73K324BL-IGT CONN, SHROUDED HDR, 34PIN, MALE, 0.100
73K324BL-IH Four Wall Header; No. of Contacts:34; Pitch Spacing:0.1"; No. of Rows:2; Gender:Header; Body Material:Glass-filled Polyester; Contact Plating:Nickel; Leaded Process Compatible:No; Mounting Type:Through Hole RoHS Compliant: No
相關代理商/技術參數
參數描述
73K224BL-IGT 制造商:未知廠家 制造商全稱:未知廠家 功能描述:Single-Chip Modem w/ Integrated Hybrid
73K224BL-IH 制造商:未知廠家 制造商全稱:未知廠家 功能描述:Single-Chip Modem w/ Integrated Hybrid
73K224BL-IH/F 功能描述:電信集成電路 Modem Data Pump With Hybrid Relay Driver RoHS:否 制造商:STMicroelectronics 類型:Telecom IC - Various 工作電源電壓:4.75 V to 5.25 V 電源電流: 工作溫度范圍:- 40 C to + 85 C 安裝風格:SMD/SMT 封裝 / 箱體:PQFP-100 封裝:Tray
73K224BL-IHR/F 功能描述:電信集成電路 Modem Data Pump With Hybrid Relay Driver RoHS:否 制造商:STMicroelectronics 類型:Telecom IC - Various 工作電源電壓:4.75 V to 5.25 V 電源電流: 工作溫度范圍:- 40 C to + 85 C 安裝風格:SMD/SMT 封裝 / 箱體:PQFP-100 封裝:Tray
73K224L 制造商:TERIDIAN 制造商全稱:TERIDIAN 功能描述:Single-Chip Modem