參數資料
型號: 73K324BL-IH
廠商: Electronic Theatre Controls, Inc.
英文描述: Four Wall Header; No. of Contacts:34; Pitch Spacing:0.1"; No. of Rows:2; Gender:Header; Body Material:Glass-filled Polyester; Contact Plating:Nickel; Leaded Process Compatible:No; Mounting Type:Through Hole RoHS Compliant: No
中文描述: 單芯片調制解調器瓦特/集成混合
文件頁數: 31/34頁
文件大小: 319K
代理商: 73K324BL-IH
73K324BL
V.22bis/V.22/V.21/V.23 Bell 212A
Single-Chip Modem w/Integrated Hybrid
31
To accomplish this, high speed digital devices should
be locally bypassed, and the telephone line interface
and K-Series device should be located close to each
other near the area of the board where the phone line
connection is accessed. To avoid problems, power
supply and ground traces should be routed separately
to the analog and digital functions on the board, and
digital signals should not be routed near low level or
high impedance analog traces. The analog and digital
grounds should only connect at one point near the K-
Series device ground pin to avoid ground loops. The
K-Series modem ICs should have both high frequency
and low frequency bypassing as close to the package
as possible.
MODEM PERFORMANCE
CHARACTERISTICS
The curves presented here define modem IC
performance under a variety of line conditions while
inducing disturbances that are typical of those
encountered during data transmission on public
service telephone lines. Test data was taken using an
TAS “1200” modem test set and line simulator,
operating under computer control. All tests were run
full-duplex, using a standard off-the-shelf modem as
the reference modem. A 511 pseudo-random-bit
pattern was used for each data point. Noise was C-
message weighted and all signal-to-noise (S/N) ratios
reflect total power measurements similar to the CCITT
V.56 measurement specification. The individual tests
are defined as follows.
BER VS. S/N
This test measures the ability of the modem to
operate over noisy lines with a minimum of data-
transfer errors. Since some noise is generated in
the best of dial-up lines, the modem must operate
with the lowest S/N ratio possible. Better modem
performance is indicated by test curves that are
closest to the BER axis. A narrow spread between
curves representing the four line parameters
indicates minimal variation in performance while
operating over a range of operating conditions.
Typically, a DPSK modem will exhibit better BER
performance test curves receiving in the low band
than in the high band.
BER VS. RECEIVE LEVEL
This test measures the dynamic range of the
modem. Because signal levels vary widely over
dial-up lines, the widest possible dynamic range is
desirable. The minimum Bell specification calls for
36 dB of dynamic range. S/N ratios are held
constant at the indicated values while the receive
level is lowered from a very high to very low signal
levels. The width of the “bowl” of these curves,
taken at the BER point, is the measure of dynamic
range.
相關PDF資料
PDF描述
73K324L EMBASE
73K324L-28IH COSSE
73K324L-IGT CCITT V.22bis, V.22, V.21, V.23, Bell 212A Single-Chip Modem
73K324L-IP CCITT V.22bis, V.22, V.21, V.23, Bell 212A Single-Chip Modem
73M2910L Microcontroller
相關代理商/技術參數
參數描述
73K324BL-IH/F 功能描述:電信集成電路 Single Chip Modem w/Integrated Hybrid RoHS:否 制造商:STMicroelectronics 類型:Telecom IC - Various 工作電源電壓:4.75 V to 5.25 V 電源電流: 工作溫度范圍:- 40 C to + 85 C 安裝風格:SMD/SMT 封裝 / 箱體:PQFP-100 封裝:Tray
73K324BL-IHR/F 功能描述:電信集成電路 Single Chip Modem w/Integrated Hybrid RoHS:否 制造商:STMicroelectronics 類型:Telecom IC - Various 工作電源電壓:4.75 V to 5.25 V 電源電流: 工作溫度范圍:- 40 C to + 85 C 安裝風格:SMD/SMT 封裝 / 箱體:PQFP-100 封裝:Tray
73K324L 制造商:未知廠家 制造商全稱:未知廠家 功能描述:CCITT V.22bis, V.22, V.21, V.23, Bell 212A Single-Chip Modem
73K324L-28IH 制造商:未知廠家 制造商全稱:未知廠家 功能描述:CCITT V.22bis, V.22, V.21, V.23, Bell 212A Single-Chip Modem
73K324L-28IH/F 功能描述:電信集成電路 Modem Data Pump V.21-23 & V.22Bis RoHS:否 制造商:STMicroelectronics 類型:Telecom IC - Various 工作電源電壓:4.75 V to 5.25 V 電源電流: 工作溫度范圍:- 40 C to + 85 C 安裝風格:SMD/SMT 封裝 / 箱體:PQFP-100 封裝:Tray