參數資料
型號： 73M1822-IM/F
廠商： Maxim Integrated Products
文件頁數： 69/82頁
文件大?。?/td> 0K
描述： MICRODAA VOICE DATA/FAX 42-QFN
產品培訓模塊： Lead (SnPb) Finish for COTS
Obsolescence Mitigation Program
標準包裝： 260
系列： MicroDAA™
應用： 傳真，調制解調器，尋呼機
接口： 串行
電源電壓： *
封裝/外殼： 42-VFQFN 裸露焊盤
供應商設備封裝： 42-QFN（8x8）
包裝： 管件
安裝類型： 表面貼裝
DS_1x22_017
73M1822/73M1922 Data Sheet
Rev. 1.6
71
12.7 Voltage and Current Detection
The 73M1x22 is capable of detecting the following circumstances:
Under voltage on the line
Over voltage on the line
Over current
These 73M1x22 built-in mechanisms provide protection to both the device itself and the external line
circuitry.
If enabled, Over Voltage and Over Current detection will cause the 73M1x22 to go on-hook without the
intervention of the host.
If configured in Line Powered mode, the detection of an Under-voltage condition causes the 73M1x22 to
switch automatically to Barrier Powered Operation (see Section 10.2.1). This is done without the
intervention of the host.
For each of the detection functions there are enable control and detection status. For each of the functions
there is a master detection function enable bit that is to be set in order for the functions to work.
12.8 Under Voltage Detection (UVD)
Under Voltage Detection is an important feature of 73M1x22. It is intended to determine if the phone line is
not capable of supplying the current that the 73M1x22 requires from the line for proper operation. If this
function is enabled and If the line is not capable of providing this current, the UVD condition will be asserted
and can become a source of interrupt from 73M1x22 to its connected host.
12.9 Over Voltage Detection (OVD)
If enabled, Over Voltage Detection is indicated if the device senses that the line voltage exceeds a defined
threshold. The device allows the selection of choice of either 60 Vpk or 70 Vpk (depending upon the
attenuation ratio, typically this is 100:1).
If enabled the 73M1x22 will automatically go on-hook if over voltage is detected.
12.10 AC Signal Over Load Detection
This is the same feature as used for the detection of billing tones (see Section 11.4). In this most generic
sense, this detector provides an indicator that the AC signal on the line exceeds a value of
3.5 Vpk.
12.11 Over Current Detection (OID)
When the line current exceeds the safe operating range of the 73M1x22 or the external transistors, the
device indicates this condition. If enabled, the 73M1x22 will automatically go on-hook if an over current
event is detected.
相關PDF資料
PDF描述
73M1866B-IM/F MICRODAA SGL PCM HIGHWAY 42-QFN
73M2901CE-IGVR/F IC MODEM 3.3V V.22BIS 32-TQFP
73S1209F-68IMR/F/P IC SMART CARD READER PROG 68-QFN
73S1210F-68IMR/F/P IC SMART CARD READER PROG 68-QFN
73S1215F-68IMR/F/P IC SMART CARD READER PROG 68-QFN
相關代理商/技術參數
參數描述
73M1822-IMR/F 功能描述:電信線路管理 IC MicroDAA w/Serial Interface RoHS:否 制造商:STMicroelectronics 產品:PHY 接口類型:UART 電源電壓-最大:18 V 電源電壓-最小:8 V 電源電流:30 mA 最大工作溫度:+ 85 C 最小工作溫度:- 40 C 安裝風格:SMD/SMT 封裝 / 箱體:VFQFPN-48 封裝:Tray
73M1822-KEYCHN 功能描述:網絡開發工具 Keychain Eval Module RoHS:否 制造商:Rabbit Semiconductor 產品:Development Kits 類型:Ethernet to Wi-Fi Bridges 工具用于評估:RCM6600W 數據速率:20 Mbps, 40 Mbps 接口類型:802.11 b/g, Ethernet 工作電源電壓:3.3 V
73M1866B-IFX 功能描述:電信線路管理 IC MicroDAA w/PCM Highway RoHS:否 制造商:STMicroelectronics 產品:PHY 接口類型:UART 電源電壓-最大:18 V 電源電壓-最小:8 V 電源電流:30 mA 最大工作溫度:+ 85 C 最小工作溫度:- 40 C 安裝風格:SMD/SMT 封裝 / 箱體:VFQFPN-48 封裝:Tray
73M1866B-IM/F 功能描述:電信線路管理 IC MicroDAA w/PCM Highway RoHS:否 制造商:STMicroelectronics 產品:PHY 接口類型:UART 電源電壓-最大:18 V 電源電壓-最小:8 V 電源電流:30 mA 最大工作溫度:+ 85 C 最小工作溫度:- 40 C 安裝風格:SMD/SMT 封裝 / 箱體:VFQFPN-48 封裝:Tray
73M1866B-IMR/F 功能描述:電信線路管理 IC MicroDAA w/PCM Highway RoHS:否 制造商:STMicroelectronics 產品:PHY 接口類型:UART 電源電壓-最大:18 V 電源電壓-最小:8 V 電源電流:30 mA 最大工作溫度:+ 85 C 最小工作溫度:- 40 C 安裝風格:SMD/SMT 封裝 / 箱體:VFQFPN-48 封裝:Tray
發布緊急采購，3分鐘左右您將得到回復。

采購需求

(若只采購一條型號，填寫一行即可)

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

*型號 *數量 廠商 批號 封裝
添加更多采購

我的聯系方式

*
*
*