參數資料
型號: 8281
廠商: Allegro MicroSystems, Inc.
英文描述: LNB SUPPLY AND CONTROL-VOLTAGE REGULATORS
中文描述: LNB電源與控制,電壓調節器
文件頁數: 7/14頁
文件大?。?/td> 375K
代理商: 8281
8281
AND
8282
LNB SUPPLY AND
CONTROL-VOLTAGE REGULATORS
7
www.allegromicro.com
Grounding.
Use a star ground approach at the
device ground terminals. This allows the analog and
power grounds to be kept separate on the PWB up to
the device.
Noise immunity.
LNB systems can have a 50
-
mV
peak specification for noise on the coaxial cable.
This is easily achievable with proper layout and
following a few guidelines:
1. Use a low-ESR capacitor for V
BULK
. A maximum
of 200
-
m
is recommended.
2. The LNB output is sensitive to the TCAP refer-
ence terminal. Keep the PWB traces short and loca-
tion of C
TCAP
close to the device. This terminal is a
high-impedance node and noise can be induced from
proximity to an unshielded inductor. If the inductor
can not be placed far enough away to avoid noise
pickup, it is important to ensure that the induced
voltage is out of phase with the switching node LX.
Rotating the inductor can change the phase of the
induced voltage.
3. Be sure to place a 1
-
μ
F to 10
-
μ
F capacitor on
internal reference V
INT
(A8282 only).
4. Bypass EXTM with a 0.1
-
μ
F ceramic capacitor to
ground.
5. Increasing the output capacitance will attenuate
noise. However, this must be traded off with the
requiremnent for low cable capacitance for 22
-
kHz-
tone transmission.
APPLICATIONS INFORMATION (
cont’d
)
DirecTV.
With the A8282, it is possible to raise
the LNB output voltage 440
-
mV from the nominal
13
-
V setting to comply with DirecTV requirements.
This is accomplished by connecting a 1
-
M
resistor
between the VINT and TCAP terminals, sourcing
approximately 2.76
-
μ
A into the TCAP node. The
LNB output voltage is approximately six times the
setting of the voltage-select DAC as shown in the
figure.
+
VINT
LNB
VOLTAGE
REG.
25 k
TCAP
1
VOLTAGE
SELECT
X6
Dwg. EP-074
DiSEqC.
The 22
-
kHz tone is specified to be
compatible with EUTELSAT coaxial cable bus
standards.
The LNB output will be able to drive the DiSEqC
termination network. The inductor must pass the dc
current with minimal loss while the parallel resistor
provides the recommended source impedance at
22
-
kHz. Unidirectional communication systems such
as DiSEqC 1.0 do not need this termination and the
LNB can be directly connected to the coaxial cable.
13
-
V to 18
-
V transition.
The LNB output can be
rapidly switched between a high and a low setting as
a method of receiver-to-LNB communication. The
TCAP capacitor will control the slew rate based on
the RC charging.
t
r
or t
f
= 25 x 10
3
x C
TCAP
ln(V
LNB(H)
/V
LNB(L)
)
相關PDF資料
PDF描述
8282 OCTAL LATCH
8282 LNB SUPPLY AND CONTROL-VOLTAGE REGULATORS
82845G Intel 82845G/82845GL/82845GV Graphics and Memory Controller Hub (GMCH)
82845GL Intel 82845G/82845GL/82845GV Graphics and Memory Controller Hub (GMCH)
82845GV Intel 82845G/82845GL/82845GV Graphics and Memory Controller Hub (GMCH)
相關代理商/技術參數
參數描述
8281 0021000 功能描述:同軸電纜 20AWG 1C SHIELD 1000ft SPOOL RED RoHS:否 制造商:Murata RG 類型: 阻抗:50 Ohms 線規 - 美國線規(AWG): 導體材料: 絞合: 長度:300 mm 外殼材料: 外徑: 屏蔽:
8281 002500 功能描述:同軸電纜 20AWG 1C SHIELD 500ft SPOOL RED RoHS:否 制造商:Murata RG 類型: 阻抗:50 Ohms 線規 - 美國線規(AWG): 導體材料: 絞合: 長度:300 mm 外殼材料: 外徑: 屏蔽:
8281 003100 功能描述:多芯電纜 20AWG 1C SHIELD 100ft SPOOL ORANGE RoHS:否 制造商:Alpha Wire 導體數量:3 線規 - 美國線規(AWG):16 絞合:19 x 29 屏蔽:Shielded 長度:100 ft 電壓額定值:600 V 外殼材料:Polytetrafluoroethylene (PTFE) 絕緣材料:Polytetrafluoroethylene (PTFE) 類型:Communication and Control
8281 0031000 功能描述:同軸電纜 20AWG 1C SHIELD 1000ft SPOOL ORANGE RoHS:否 制造商:Murata RG 類型: 阻抗:50 Ohms 線規 - 美國線規(AWG): 導體材料: 絞合: 長度:300 mm 外殼材料: 外徑: 屏蔽:
8281 0041000 制造商:Belden Inc 功能描述:COAXIAL CABLE, RG-59/U, 1000FT, YELLOW; Reel Length (Imperial):1000ft; Reel Length (Metric):304.8m; Coaxial Cable Type:RG59; Conductor Size AWG:20AWG; Jacket Color:Yellow; Jacket Material:PE (Polyethylene); Conductor Material:Copper ;RoHS Compliant: Yes