- 您現在的位置：買賣IC網 > PDF目錄24618 > 91719BGLF (INTEGRATED DEVICE TECHNOLOGY INC) 9179 SERIES, PLL BASED CLOCK DRIVER, 1 TRUE OUTPUT(S), 0 INVERTED OUTPUT(S), PDSO16 PDF資料下載
參數資料
| 型號： | 91719BGLF |
| 廠商： | INTEGRATED DEVICE TECHNOLOGY INC |
| 元件分類： | 時鐘及定時 |
| 英文描述： | 9179 SERIES, PLL BASED CLOCK DRIVER, 1 TRUE OUTPUT(S), 0 INVERTED OUTPUT(S), PDSO16 |
| 封裝： | 4.40 MM, 0.65 MM PITCH, MO-153, TSSOP-16 |
| 文件頁數： | 7/12頁 |
| 文件大小： | 97K |
| 代理商： | 91719BGLF |
4
ICS91719
0506C—07/28/03
1.
The ICS clock generator is a slave/receiver, I
2C component. It can read back the data stored in the latches for
verification. Read-Back will support Intel PIIX4 "Block-Read" protocol.
2.
The data transfer rate supported by this clock generator is 100K bits/sec or less (standard mode)
3.
The input is operating at 3.3V logic levels.
4.
The data byte format is 8 bit bytes.
5.
To simplify the clock generator I
2C interface, the protocol is set to use only "Block-Writes" from the controller.
The bytes must be accessed in sequential order from lowest to highest byte with the ability to stop after any
complete byte has been transferred. The Command code and Byte count shown above must be sent, but the
data is ignored for those two bytes. The data is loaded until a Stop sequence is issued.
6.
At power-on, all registers are set to a default condition, as shown.
Controller (Host)
ICS (Slave/Receiver)
Start Bit
Address
D2(H)
ACK
Dummy Command Code
ACK
Dummy Byte Count
ACK
Byte 0
ACK
Byte 1
ACK
Byte 2
ACK
Byte 3
ACK
Byte 4
ACK
Byte 5
ACK
Byte 6
ACK
Byte 7
ACK
Stop Bit
How to Write:
Controller (Host)
ICS (Slave/Receiver)
Start Bit
Address
D3(H)
ACK
Byte Count
ACK
Byte 0
ACK
Byte 1
ACK
Byte 2
ACK
Byte 3
ACK
Byte 4
ACK
Byte 5
ACK
Byte 6
ACK
Byte 7
Stop Bit
How to Read:
General I
2C serial interface information
The information in this section assumes familiarity with I
2C programming.
For more information, contact ICS for an I
2C programming application note.
How to Write:
Controller (host) sends a start bit.
Controller (host) sends the write address D2 (H)
ICS clock will
acknowledge
Controller (host) sends a dummy command code
ICS clock will
acknowledge
Controller (host) sends a dummy byte count
ICS clock will
acknowledge
Controller (host) starts sending first byte (Byte 0)
through byte 6
ICS clock will
acknowledge each byte one at a
time.
Controller (host) sends a Stop bit
How to Read:
Controller (host) will send start bit.
Controller (host) sends the read address D3 (H)
ICS clock will
acknowledge
ICS clock will send the
byte count
Controller (host) acknowledges
ICS clock sends first byte
(Byte 0) through byte 7
Controller (host) will need to acknowledge each
byte
Controller (host) will send a stop bit
Notes:
相關PDF資料 |
PDF描述 |
|---|---|
| 91719AGLFT | 9179 SERIES, PLL BASED CLOCK DRIVER, 1 TRUE OUTPUT(S), 0 INVERTED OUTPUT(S), PDSO16 |
| 917308-1 | 0.6 mm2, PHOSPHOR BRONZE, TIN FINISH, WIRE TERMINAL |
| 051-428-3875 | RF Coaxial Connectors |
| 91730AMLFT | 9173 SERIES, PLL BASED CLOCK DRIVER, 1 TRUE OUTPUT(S), 0 INVERTED OUTPUT(S), PDSO8 |
| 91730AMLF | 9173 SERIES, PLL BASED CLOCK DRIVER, 1 TRUE OUTPUT(S), 0 INVERTED OUTPUT(S), PDSO8 |
相關代理商/技術參數 |
參數描述 |
|---|---|
| 91719BGLFT | 功能描述:時鐘發生器及支持產品 RoHS:否 制造商:Silicon Labs 類型:Clock Generators 最大輸入頻率:14.318 MHz 最大輸出頻率:166 MHz 輸出端數量:16 占空比 - 最大:55 % 工作電源電壓:3.3 V 工作電源電流:1 mA 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:QFN-56 |
| 9171-A-156 | 制造商:Hart Scientific / Fluke 功能描述:METROLOGY WELL, -30C, W/9171-INSA, 115V 制造商:DANAHER - FLUKE 功能描述:METROLOGY WELL, -30C, W/9171-INSA, 115V 制造商:Fluke Electronics 功能描述:METROLOGY WELL, -30C, W/9171-INSA, 115V |
| 9171-A-R-156 | 制造商:Hart Scientific / Fluke 功能描述:METROLOGY WELL, -30C,W/9171-INSA,W/REF, 115V 制造商:Fluke Electronics 功能描述:METROLOGY WELL, -30C,W/9171-INSA,W/REF, 115V |
| 9171B | 功能描述:DC POWER SUPPLY 0-10V, 10A / 10- 制造商:b&k precision 系列:9170B 零件狀態:在售 類型:工作臺（AC 至 DC） 電壓 - 電源:115VAC，230VAC 電壓 - 輸出:0 ~ 20VDC 電流 - 輸出:0 ~ 10A 顯示類型:LCD 字符數:- 輸出數:1 大小/尺寸:16.339" 長 x 8.268" 寬 x 3.425" 高（415.00mm x 210.00mm x 87.00mm） 特性:存儲器，可編程，跟蹤，USB 接口 功率（W）:100W 精度 - 電壓表；安培計:0.05% + 5mV; 0.1% + 2mA 電壓調節 - 線路:0.01% + 1mV 電壓調節 - 負載:0.01% + 1mV 電流調節 - 線路:0.01% + 250μA 電流調節 - 負載:0.01% + 250μA 紋波:3mV p-p，0.35mV rms 重量:17 磅（7.7kg） 標準包裝:1 |
| 9171-B-156 | 制造商:Hart Scientific / Fluke 功能描述:METROLOGY WELL, -30C, W/9171-INSB, 115V 制造商:DANAHER - FLUKE 功能描述:METROLOGY WELL, -30C, W/9171-INSB, 115V |
發布緊急采購，3分鐘左右您將得到回復。