參數(shù)資料
型號: 935263448557
廠商: NXP SEMICONDUCTORS
元件分類: 無繩電話/電話
英文描述: SPEAKER PHONE CIRCUIT, PQFP44
封裝: PLASTIC, SOT-307, QFP-44
文件頁數(shù): 7/43頁
文件大?。?/td> 237K
代理商: 935263448557
1999 Oct 14
15
Philips Semiconductors
Product specication
Speech and handsfree IC
TEA1098
To determine the noise level, the signals between
pin TENV and pin TNOI, and between pin RENV and
pin RNOI are buffered. The buffers have a maximum
source current of 1
A and a maximum sink current of
120
A.
Capacitors CTNOI and CRNOI set the timing of both noise
envelope detectors. In the basic application, see Fig.19,
the value of both capacitors is 4.7
F.
At room temperature, the 1
A sourced current
corresponds to a maximum noise envelope rise-slope of
approximately 0.07 dB/ms which is small enough to track
background noise without being affected by speech
bursts.
The 120
A sink current corresponds to a maximum
fall-slope of approximately 8.5 dB/ms. However, because
the noise envelope tracks the fall of the signal envelope, it
will never fall faster than approximately 0.7 dB/ms.
The behaviour of the signal envelope and noise envelope
detectors is illustrated in Fig.11.
handbook, full pagewidth
MBG354
INPUT SIGNAL
SIGNAL ENVELOPE
NOISE ENVELOPE
4 mV (RMS)
1 mV (RMS)
A
C
36 mV
B
A
B
time
A: 85 dB/ms
B: 0.7 dB/ms
C: 0.07 dB/ms
Fig.11 Signal and noise envelope waveforms.
Decision logic: pins IDT and SWT
The TEA1098 selects its mode of operation (Tx, Rx or Idle)
by comparing the signal and noise envelopes of both
channels. This is executed by the decision logic.
The resulting voltage on pin SWT is the input to the voice
switch.
To facilitate the distinction between signal and noise, the
signal is considered as speech when its envelope is more
than 4.3 dB above the noise envelope. At room
temperature, this is equal to a voltage difference of
VENV VNOI = 13 mV. This so called speech/noise
threshold is implemented in both channels.
The signal on pin TXIN contains both speech and the
acoustically coupled signal from the loudspeaker.
In Rx mode, the loudspeaker signal overrides the speech.
Therefore, the signal envelope on pin TENV consists
mainly of the loudspeaker signal. To correct this, an
attenuator is connected between pin TENV and the
TENV/RENV comparator. Its attenuation is equal to that
applied to the microphone amplifier.
相關PDF資料
PDF描述
935263448518 SPEAKER PHONE CIRCUIT, PQFP44
08-01-0106 Connector Contact,SKT,CRIMP Terminal
08-03-0101 Crimp Socket Contact; Wire Size (AWG):20-18; Contact Material:Phosphor Bronze; Contact Plating:Tin
08-05-0104 KK 156 Term Crp Edge Card 18 24Awg SGold
08-01-0116 WIRE TERMINAL
相關代理商/技術參數(shù)
參數(shù)描述
935264217557 制造商:NXP Semiconductors 功能描述:SUB ONLY IC
935267356112 制造商:NXP Semiconductors 功能描述:IC TEA1507PN
935268081112 制造商:NXP Semiconductors 功能描述:SUB ONLY IC
935268721125 制造商:NXP Semiconductors 功能描述:Buffer/Line Driver 1-CH Non-Inverting 3-ST CMOS 5-Pin TSSOP T/R
935269304128 制造商:ST-Ericsson 功能描述:IC AUDIO CODEC W/TCH SCRN 48LQFP