- 您現在的位置：買賣IC網 > PDF目錄24839 > 93732YFLFT (INTEGRATED DEVICE TECHNOLOGY INC) 93732 SERIES, PLL BASED CLOCK DRIVER, 6 TRUE OUTPUT(S), 6 INVERTED OUTPUT(S), PDSO28 PDF資料下載
參數資料
| 型號： | 93732YFLFT |
| 廠商： | INTEGRATED DEVICE TECHNOLOGY INC |
| 元件分類： | 時鐘及定時 |
| 英文描述： | 93732 SERIES, PLL BASED CLOCK DRIVER, 6 TRUE OUTPUT(S), 6 INVERTED OUTPUT(S), PDSO28 |
| 封裝： | 0.209 INCH, ROHS COMPLIANT, MO-150, SSOP-28 |
| 文件頁數： | 5/8頁 |
| 文件大小： | 98K |
| 代理商： | 93732YFLFT |
5
ICS93732
0578J—06/20/08
1.
The ICS clock generator is a slave/receiver, I
2C component. It can read back the data stored in the latches
for verification. Read-Back will support Intel PIIX4 "Block-Read" protocol.
2.
The data transfer rate supported by this clock generator is 100K bits/sec or less (standard mode)
3.
The input is operating at 3.3V logic levels.
4.
The data byte format is 8 bit bytes.
5.
To simplify the clock generator I
2C interface, the protocol is set to use only "Block-Writes" from the controller.
The bytes must be accessed in sequential order from lowest to highest byte with the ability to stop after any
complete byte has been transferred. The Command code and Byte count shown above must be sent, but the
data is ignored for those two bytes. The data is loaded until a Stop sequence is issued.
6.
At power-on, all registers are set to a default condition, as shown.
General I
2C serial interface information
The information in this section assumes familiarity with I
2C programming.
For more information, contact ICS for an I
2C programming application note.
How to Write:
Controller (host) sends a start bit.
Controller (host) sends the write address D4
(H)
ICS clock will acknowledge
Controller (host) sends a dummy command code
ICS clock will acknowledge
Controller (host) sends a dummy byte count
ICS clock will acknowledge
Controller (host) starts sending first byte (Byte 0)
through byte 6
ICS clock will acknowledge each byte one at a time.
Controller (host) sends a Stop bit
How to Read:
Controller (host) will send start bit.
Controller (host) sends the read address D5
(H)
ICS clock will acknowledge
ICS clock will send the byte count
Controller (host) acknowledges
ICS clock sends first byte (Byte 0) through byte 6
Controller (host) will need to acknowledge each byte
Controller (host) will send a stop bit
Notes:
Controller (Host)
ICS (Slave/Receiver)
Start Bit
Address
D4(H)
ACK
Dummy Command Code
ACK
Dummy Byte Count
ACK
Byte 0
ACK
Byte 1
ACK
Byte 2
ACK
Byte 3
ACK
Byte 4
ACK
Byte 5
ACK
Byte 6
ACK
Stop Bit
How to Write:
Controller (Host)
ICS (Slave/Receiver)
Start Bit
Address
D5(H)
ACK
Byte Count
ACK
Byte 0
ACK
Byte 1
ACK
Byte 2
ACK
Byte 3
ACK
Byte 4
ACK
Byte 5
ACK
Byte 6
ACK
Stop Bit
How to Read:
相關PDF資料 |
PDF描述 |
|---|---|
| 93735AF-T | 93735 SERIES, PLL BASED CLOCK DRIVER, 10 TRUE OUTPUT(S), 0 INVERTED OUTPUT(S), PDSO48 |
| 93735AFLF | 93735 SERIES, PLL BASED CLOCK DRIVER, 10 TRUE OUTPUT(S), 0 INVERTED OUTPUT(S), PDSO48 |
| 93735AF | 93735 SERIES, PLL BASED CLOCK DRIVER, 10 TRUE OUTPUT(S), 0 INVERTED OUTPUT(S), PDSO48 |
| 9374PC | LED DISPLAY DRIVER, DIP16 |
| 939 | WIRE TERMINAL |
相關代理商/技術參數 |
參數描述 |
|---|---|
| 937-330 | 功能描述:支架與墊片 Plastic Spcr .33 in Nylon White RoHS:否 制造商:Schurter 類型:Transipillar Spacers 長度:16 m 螺紋大小:M4 外徑:10 mm 材料:Nylon with Steel 電鍍:Zinc |
| 93733-003 | 制造商:FCI 功能描述:MEMORY CARD RECEPTACLE - Rail/Tube |
| 937333-000 | 制造商:ELO Touch Solutions 功能描述:20.4IN FLAT ANTIGLARE;SAMPLE!! |
| 937-335 | 功能描述:支架與墊片 Plastic Spcr .335 in Nylon White RoHS:否 制造商:Schurter 類型:Transipillar Spacers 長度:16 m 螺紋大小:M4 外徑:10 mm 材料:Nylon with Steel 電鍍:Zinc |
| 937-345 | 功能描述:支架與墊片 Nylon Tubular,0.345 in. Length,0.125 OD,0.09 ID,White RoHS:否 制造商:Schurter 類型:Transipillar Spacers 長度:16 m 螺紋大小:M4 外徑:10 mm 材料:Nylon with Steel 電鍍:Zinc |
發(fā)布緊急采購，3分鐘左右您將得到回復。