- 您現在的位置：買賣IC網 > PDF目錄67354 > A1155LUA-T MAGNETIC FIELD SENSOR-HALL EFFECT, 1-6mT, RECTANGULAR, THROUGH HOLE MOUNT PDF資料下載
參數資料
| 型號： | A1155LUA-T |
| 元件分類： | 磁阻傳感器 |
| 英文描述： | MAGNETIC FIELD SENSOR-HALL EFFECT, 1-6mT, RECTANGULAR, THROUGH HOLE MOUNT |
| 封裝： | 1.50 X 4 MM, 3 MM HEIGHT, LEAD FREE, SIP-3 |
| 文件頁數： | 12/12頁 |
| 文件大小： | 301K |
| 代理商： | A1155LUA-T |
Chopper-Stabilized, Two Wire
Hall-Effect Switches
A1152, A1153,
A1155, and A1156
9
Allegro MicroSystems, Inc.
115 Northeast Cutoff
Worcester, Massachusetts 01615-0036 U.S.A.
1.508.853.5000; www.allegromicro.com
The device must be operated below the maximum junction tem-
perature of the device, TJ(max). Under certain combinations of
peak conditions, reliable operation may require derating supplied
power or improving the heat dissipation properties of the appli-
cation. This section presents a procedure for correlating factors
affecting operating TJ. (Thermal data is also available on the
Allegro MicroSystems Web site.)
The Package Thermal Resistance, RJA, is a figure of merit sum-
marizing the ability of the application and the device to dissipate
heat from the junction (die), through all paths to the ambient air.
Its primary component is the Effective Thermal Conductivity, K,
of the printed circuit board, including adjacent devices and traces.
Radiation from the die through the device case, RJC, is relatively
small component of RJA. Ambient air temperature, TA, and air
motion are significant external factors, damped by overmolding.
The effect of varying power levels (Power Dissipation, PD), can
be estimated. The following formulas represent the fundamental
relationships used to estimate TJ, at PD.
PD = VIN
× IIN
(1)
T = PD
× RJA
(2)
TJ = TA + ΔT
(3)
For example, given common conditions such as: TA= 25°C,
VCC = 12 V, ICC = 4 mA, and RJA = 140 °C/W, then:
PD = VCC
× ICC = 12 V × 4 mA = 48 mW
T = PD
× RJA = 48 mW × 140 °C/W = 7°C
TJ = TA + T = 25°C + 7°C = 32°C
A worst-case estimate, PD(max), represents the maximum allow-
able power level (VCC(max), ICC(max)), without exceeding
TJ(max), at a selected RJA and TA.
Example: Reliability for VCC at TA=150°C, package UA, using a
low-K PCB.
Observe the worst-case ratings for the device, specifically:
RJA=165 °C/W, TJ(max) =165°C, VCC(max)= 24 V, and
ICC(max) = 17 mA.
Calculate the maximum allowable power level, PD(max). First,
invert equation 3:
Tmax = TJ(max) – TA = 165°C–150°C = 15°C
This provides the allowable increase to TJ resulting from internal
power dissipation. Then, invert equation 2:
PD(max) = Tmax÷RJA =15°C÷165 °C/W=91mW
Finally, invert equation 1 with respect to voltage:
VCC(est) = PD(max) ÷ ICC(max)= 91mW÷17 mA=5 V
The result indicates that, at TA, the application and device can
dissipate adequate amounts of heat at voltages ≤VCC(est).
Compare VCC(est) to VCC(max). If VCC(est) ≤ VCC(max), then reli-
able operation between VCC(est) and VCC(max) requires enhanced
RJA. If VCC(est) ≥ VCC(max), then operation between VCC(est)
and VCC(max) is reliable under these conditions.
Power Derating
相關PDF資料 |
PDF描述 |
|---|---|
| A1174EEWLT-P | MAGNETIC FIELD SENSOR-HALL EFFECT, -5.5-5.5mT, 300mV, RECTANGULAR, SURFACE MOUNT |
| A1174EEWLT-T | MAGNETIC FIELD SENSOR-HALL EFFECT, -5.5-5.5mT, 300mV, RECTANGULAR, SURFACE MOUNT |
| A1193LUA-T | MAGNETIC FIELD SENSOR-HALL EFFECT, 1-20mT, RECTANGULAR, THROUGH HOLE MOUNT |
| A1192LLHLT-T | MAGNETIC FIELD SENSOR-HALL EFFECT, 1-20mT, RECTANGULAR, SURFACE MOUNT |
| A1190LUA-T | MAGNETIC FIELD SENSOR-HALL EFFECT, 1-20mT, RECTANGULAR, THROUGH HOLE MOUNT |
相關代理商/技術參數 |
參數描述 |
|---|---|
| A1155LUBTN-F-T | 功能描述:2WIRE FACTORY PROGRAMMED SWITCH 制造商:allegro microsystems, llc 系列:汽車級，AEC-Q100 零件狀態:在售 功能:單極開關 技術:霍爾效應 極化:南極 測試條件:-40°C ~ 150°C 電壓 - 電源:3 V ~ 24 V 電流 - 電源（最大值）:17mA 電流 - 輸出（最大值）:- 輸出類型:電流源 特性:- 工作溫度:-40°C ~ 150°C 封裝/外殼:2-SIP 模塊 供應商器件封裝:2-ultramini SIP 標準包裝:8,000 |
| A1155LUBTN-T | 功能描述:2-WIRE FACTORY PROGRAMMED SWITCH 制造商:allegro microsystems, llc 系列:汽車級，AEC-Q100 零件狀態:在售 功能:單極開關 技術:霍爾效應 極化:南極 感應范圍:6mT 跳閘，1mT 釋放 測試條件:-40°C ~ 150°C 電壓 - 電源:3 V ~ 24 V 電流 - 電源（最大值）:17mA 電流 - 輸出（最大值）:- 輸出類型:電流源 特性:- 工作溫度:-40°C ~ 150°C 封裝/外殼:2-SIP 模塊 供應商器件封裝:2-ultramini SIP 標準包裝:8,000 |
| A1156 | 制造商:ALLEGRO 制造商全稱:Allegro MicroSystems 功能描述:Chopper-Stabilized, Two Wire Hall-Effect Switches |
| A-1156 | 制造商:TE Connectivity 功能描述: |
| A1156LLHLT-T | 功能描述:IC HALL EFFECT SWITCH SOT-23-W RoHS:是 類別:傳感器，轉換器 >> 磁性 - 霍爾效應，數字式開關，線性，羅盤 (IC) 系列:- 標準包裝:1 系列:- 傳感范圍:20mT ~ 80mT 類型:旋轉 電源電壓:4.5 V ~ 5.5 V 電流 - 電源:15mA 電流 - 輸出（最大）:- 輸出類型:數字式，PWM，8.5 位串行 特點:可編程 工作溫度:-40°C ~ 150°C 封裝/外殼:20-SSOP（0.209"，5.30mm 寬） 供應商設備封裝:20-SSOP 包裝:Digi-Reel® 其它名稱:AS5132-HSST-500DKR |
發布緊急采購，3分鐘左右您將得到回復。
