參數資料
型號： AD5161BRMZ100
廠商： Analog Devices Inc
文件頁數： 7/20頁
文件大小： 0K
描述： IC DGTL POT SPI 100K 10-MSOP
標準包裝： 50
接片： 256
電阻（歐姆）： 100k
電路數： 1
溫度系數： 標準值 45 ppm/°C
存儲器類型： 易失
接口： I²C，SPI
電源電壓： 2.7 V ~ 5.5 V
工作溫度： -40°C ~ 125°C
安裝類型： 表面貼裝
封裝/外殼： 10-TFSOP，10-MSOP（0.118"，3.00mm 寬）
供應商設備封裝： 10-MSOP
包裝： 管件
產品目錄頁面： 786 (CN2011-ZH PDF)
Data Sheet
AD5161
Rev. B | Page 15 of 20
THEORY OF OPERATION
The AD5161 is a 256-position digitally controlled variable
resistor (VR)1 device.
An internal power-on preset places the wiper at midscale during
power-on, which simplifies the fault condition recovery at power-up.
PROGRAMMING THE VARIABLE RESISTOR
Rheostat Operation
The nominal resistance of the RDAC between terminals A and
B is available in 5 kΩ, 10 kΩ, 50 kΩ, and 100 kΩ. The final two
or three digits of the part number determine the nominal resistance
value, e.g., 10 kΩ = 10; 50 kΩ = 50. The nominal resistance (RAB) of
the VR has 256 contact points accessed by the wiper terminal,
plus the B terminal contact. The 8-bit data in the RDAC latch is
decoded to select one of the 256 possible settings. Assume a 10 kΩ
part is used, the wiper’s first connection starts at the B terminal
for data 0x00. Since there is a 60 Ω wiper contact resistance, such
connection yields a minimum of 60 Ω resistance between
Terminals W and B. The second connection is the first tap point,
which corresponds to 99 Ω (RWB = RAB/256 + RW = 39 Ω + 60 Ω)
for data 0x01. The third connection is the next tap point,
representing 177 Ω (2 × 39 Ω + 60 Ω) for data 0x02 and so on. Each
LSB data value increase moves the wiper up the resistor ladder
until the last tap point is reached at 9961 Ω (RAB – 1 LSB + RW).
Figure 42 shows a simplified diagram of the equivalent RDAC
circuit where the last resistor string will not be accessed;
therefore, there is 1 LSB less of the nominal resistance at full
scale in addition to the wiper resistance.
B
RDAC
LATCH
AND
DECODER
W
A
RS
SD BIT
D7
D6
D4
D5
D2
D3
D1
D0
Figure 42. AD5161 Equivalent RDAC Circuit
1 The terms digital potentiometer, VR, and RDAC are used interchangeably.
The general equation determining the digitally programmed
output resistance between W and B is
W
AB
WB
R
D
R
256
)
(
(1)
where D is the decimal equivalent of the binary code loaded in
the 8-bit RDAC register, RAB is the end-to-end resistance, and
RW
is the wiper resistance contributed by the on resistance of
the internal switch.
In summary, if RAB = 10 kΩ and the A terminal is open circuited,
the following output resistance RWB will be set for the indicated
RDAC latch codes.
Table 9. Codes and Corresponding RWB Resistance
D (Dec.)
RWB (Ω)
Output State
255
9,961
Full Scale (RAB – 1 LSB + RW)
128
5,060
Midscale
1
99
1 LSB
0
60
Zero Scale (Wiper Contact Resistance)
Note that in the zero-scale condition a finite wiper resistance of
60 Ω is present. Care should be taken to limit the current flow
between W and B in this state to a maximum pulse current of
no more than 20 mA. Otherwise, degradation or possible
destruction of the internal switch contact can occur.
Similar to the mechanical potentiometer, the resistance of the
RDAC between the wiper W and terminal A also produces a
digitally controlled complementary resistance RWA. When these
terminals are used, the B terminal can be opened. Setting the
resistance value for RWA starts at a maximum value of resistance
and decreases as the data loaded in the latch increases in value.
The general equation for this operation is
W
AB
WA
R
D
R
256
)
(
(2)
For RAB = 10 kΩ and the B terminal open circuited, the
following output resistance RWA will be set for the indicated
RDAC latch codes.
Table 10. Codes and Corresponding RWA Resistance
D (Dec.)
RWA (Ω)
Output State
255
99
Full Scale
128
5,060
Midscale
1
9,961
1 LSB
0
10,060
Zero Scale
Typical device to device matching is process lot dependent and
may vary by up to ±30%. Since the resistance element is processed
in thin film technology, the change in RAB with temperature has
a very low 45 ppm/°C temperature coefficient.
相關PDF資料
PDF描述
MS3450W24-2PZ CONN RCPT 7POS WALL MNT W/PINS
VI-JVY-MZ CONVERTER MOD DC/DC 3.3V 16.5W
MS3450W24-2PW CONN RCPT 7POS WALL MNT W/PINS
AD5115BCPZ10-500R7 IC DGTL POT 32POS 10K 8LFCSP
MS3450W24-2P CONN RCPT 7POS WALL MNT W/PINS
相關代理商/技術參數
參數描述
AD5161BRMZ100-RL7 功能描述:IC DGTL POT SPI 100K 10-MSOP RoHS:是 類別:集成電路 (IC) >> 數據采集 - 數字電位器 系列:- 標準包裝:3,000 系列:DPP 接片:32 電阻（歐姆）:10k 電路數:1 溫度系數:標準值 300 ppm/°C 存儲器類型:非易失 接口:3 線串行（芯片選擇，遞增，增/減） 電源電壓:2.5 V ~ 6 V 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:8-WFDFN 裸露焊盤 供應商設備封裝:8-TDFN（2x3） 包裝:帶卷 (TR)
AD5161BRMZ10-RL7 功能描述:IC DGTL POT SPI 10K 10-MSOP RoHS:是 類別:集成電路 (IC) >> 數據采集 - 數字電位器 系列:- 標準包裝:3,000 系列:DPP 接片:32 電阻（歐姆）:10k 電路數:1 溫度系數:標準值 300 ppm/°C 存儲器類型:非易失 接口:3 線串行（芯片選擇，遞增，增/減） 電源電壓:2.5 V ~ 6 V 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:8-WFDFN 裸露焊盤 供應商設備封裝:8-TDFN（2x3） 包裝:帶卷 (TR)
AD5161BRMZ5 功能描述:IC POT DGTL 5K 256POS 10-MSOP RoHS:是 類別:集成電路 (IC) >> 數據采集 - 數字電位器 系列:- 產品培訓模塊:Lead (SnPb) Finish for COTS Obsolescence Mitigation Program 標準包裝:1 系列:- 接片:256 電阻（歐姆）:100k 電路數:1 溫度系數:標準值 35 ppm/°C 存儲器類型:非易失 接口:3 線串口 電源電壓:2.7 V ~ 5.25 V 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:8-WDFN 裸露焊盤 供應商設備封裝:8-TDFN-EP（3x3） 包裝:剪切帶 (CT) 產品目錄頁面:1399 (CN2011-ZH PDF) 其它名稱:MAX5423ETA+TCT
AD5161BRMZ50 功能描述:IC POT DGTL 50K 256POS 10-MSOP RoHS:是 類別:集成電路 (IC) >> 數據采集 - 數字電位器 系列:- 產品培訓模塊:Lead (SnPb) Finish for COTS Obsolescence Mitigation Program 標準包裝:1 系列:- 接片:256 電阻（歐姆）:100k 電路數:1 溫度系數:標準值 35 ppm/°C 存儲器類型:非易失 接口:3 線串口 電源電壓:2.7 V ~ 5.25 V 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:8-WDFN 裸露焊盤 供應商設備封裝:8-TDFN-EP（3x3） 包裝:剪切帶 (CT) 產品目錄頁面:1399 (CN2011-ZH PDF) 其它名稱:MAX5423ETA+TCT
AD5161BRMZ50-RL7 功能描述:IC DGTL POT 256POS 50K 10MSOP RoHS:是 類別:集成電路 (IC) >> 數據采集 - 數字電位器 系列:- 標準包裝:3,300 系列:WiperLock™ 接片:257 電阻（歐姆）:100k 電路數:1 溫度系數:標準值 150 ppm/°C 存儲器類型:易失 接口:3 線 SPI（芯片選擇） 電源電壓:1.8 V ~ 5.5 V 工作溫度:-40°C ~ 125°C 安裝類型:表面貼裝 封裝/外殼:8-VDFN 裸露焊盤 供應商設備封裝:8-DFN-EP（3x3） 包裝:帶卷 (TR)
發布緊急采購，3分鐘左右您將得到回復。

采購需求

(若只采購一條型號，填寫一行即可)

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

*型號 *數量 廠商 批號 封裝
添加更多采購

我的聯系方式

*
*
*