- 您現在的位置：買賣IC網 > PDF目錄373870 > AD5172BRM50 (ANALOG DEVICES INC) Dual, 256-Tap, Nonvolatile, I2C-Interface, Digital Potentiometers PDF資料下載
參數資料
| 型號： | AD5172BRM50 |
| 廠商： | ANALOG DEVICES INC |
| 元件分類： | 數字電位計 |
| 英文描述： | Dual, 256-Tap, Nonvolatile, I2C-Interface, Digital Potentiometers |
| 中文描述： | DUAL 50K DIGITAL POTENTIOMETER, 2-WIRE SERIAL CONTROL INTERFACE, 256 POSITIONS, PDSO10 |
| 封裝： | 3 X 4.90 MM, MO-187BA, MSOP-10 |
| 文件頁數： | 15/24頁 |
| 文件大?。?/td> | 948K |
| 代理商： | AD5172BRM50 |
AD5172/AD5173
Rev. A | Page 15 of 24
V
DD
2.7V
6V
P1
P1=P2=FDV302P, NDS0610
R1
10k
P2
C1
1
μ
F
C2
1nF
APPLY FOR OTP ONLY
AD5172/
AD5173
0
Poor PCB layout introduces parasitics that may affect the fuse
programming. Therefore, it is recommended to add a 1 μF
tantalum capacitor in parallel with a 1 nF ceramic capacitor as
close as possible to the V
DD
pin. These capacitors help ensure
OTP programming success by providing proper current densi-
ties. This combination of capacitor values provides both a fast
response for high frequency transients and a larger supply of
current for extended spikes. Typically, C1
minimizes any
transient disturbances and low frequency ripple, while C2
reduces high frequency noise.
Figure 44. Isolate 6 V OTP Supply from 2.7 V Normal Operating Supply.
The 6 V supply must be removed once OTP is completed.
LAYOUT CONSIDERATIONS
It is a good practice to employ compact, minimum lead length
layout design. The leads to the inputs should be as direct as
possible with a minimum conductor length. Ground paths
should have low resistance and low inductance.
For users who operate their systems at 2.7 V, use of the
bidirectional low threshold P-Ch MOSFETs is recommended
for the supply’s isolation. As shown in Figure 44, this assumes
that the 2.7 V system voltage is applied first, and that the P1 and
P2 gates are pulled to ground, thus turning on P1 and
subsequently P2. As a result, V
DD
of the AD5172/AD5173
approaches 2.7 V. When the AD5172/AD5173 setting is found,
the factory tester applies the 6 V to V
DD
; the 6 V is also applied
to the gates of P1 and P2 to turn them off. The OTP command
is executed at this time to program the AD5172/AD5173; the
2.7 V source is therefore protected. Once the OTP is completed,
the tester withdraws the 6 V and the AD5172/AD5173’s setting
is fixed permanently.
Note that the digital ground should also be joined remotely to
the analog ground at one point to minimize the ground bounce.
V
DD
GND
V
DD
C1
1
μ
F
C2
1nF
AD5172
+
0
AD5172/AD5173 achieves the OTP function through blowing
internal fuses. Users should always apply the 6 V one-time
program voltage requirement at the first program command.
Failure to comply with this requirement may lead to the change
of fuse structures, rendering programming inoperable.
Figure 45. Power Supply Bypassing
相關PDF資料 |
PDF描述 |
|---|---|
| AD5172BRM50-RL7 | Dual, 256-Tap, Nonvolatile, I2C-Interface, Digital Potentiometers |
| AD5172EVAL1 | Dual, 256-Tap, Nonvolatile, I2C-Interface, Digital Potentiometers |
| AD517 | Low Cost, Laser Trimmed, Precision IC Op Amp |
| AD517J | Low Cost, Laser Trimmed, Precision IC Op Amp |
| AD517JH | Low Cost, Laser Trimmed, Precision IC Op Amp |
相關代理商/技術參數 |
參數描述 |
|---|---|
| AD5172BRM50-RL7 | 制造商:Analog Devices 功能描述:Digital Potentiometer 256POS 50KOhm Dual 10-Pin MSOP T/R 制造商:Analog Devices 功能描述:DGTL POTENTIOMETER 256POS 50KOHM DUAL 10MSOP - Tape and Reel |
| AD5172BRMZ10 | 功能描述:IC POT DUAL 10K 256POS 10MSOP RoHS:是 類別:集成電路 (IC) >> 數據采集 - 數字電位器 系列:- 標準包裝:3,000 系列:DPP 接片:32 電阻（歐姆）:10k 電路數:1 溫度系數:標準值 300 ppm/°C 存儲器類型:非易失 接口:3 線串行（芯片選擇，遞增，增/減） 電源電壓:2.5 V ~ 6 V 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:8-WFDFN 裸露焊盤 供應商設備封裝:8-TDFN（2x3） 包裝:帶卷 (TR) |
| AD5172BRMZ100 | 功能描述:IC DGTL POT DUAL 100K I2C 10MSOP RoHS:是 類別:集成電路 (IC) >> 數據采集 - 數字電位器 系列:- 產品培訓模塊:Lead (SnPb) Finish for COTS Obsolescence Mitigation Program 標準包裝:1 系列:- 接片:256 電阻（歐姆）:100k 電路數:1 溫度系數:標準值 35 ppm/°C 存儲器類型:非易失 接口:3 線串口 電源電壓:2.7 V ~ 5.25 V 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:8-WDFN 裸露焊盤 供應商設備封裝:8-TDFN-EP（3x3） 包裝:剪切帶 (CT) 產品目錄頁面:1399 (CN2011-ZH PDF) 其它名稱:MAX5423ETA+TCT |
| AD5172BRMZ100100 | 制造商:Analog Devices 功能描述:AD5172BRM100 256-step dual pot, 100K |
| AD5172BRMZ1002 | 制造商:AD 制造商全稱:Analog Devices 功能描述:256-Position, One-Time Programmable, Dual-Channel, I2C Digital Potentiometers |
發布緊急采購，3分鐘左右您將得到回復。