參數資料
型號: AD5201
廠商: Analog Devices, Inc.
元件分類: 數字電位計
英文描述: 2-Channel, 256-Position Digital Potentiometer
中文描述: 2通道,256位數字電位器
文件頁數: 10/16頁
文件大小: 664K
代理商: AD5201
REV. 0
AD5207
–10–
The data setup and data hold times in the specification table
determine the data valid time requirements. The last ten bits of
the data word entered into the serial register are held when
CS
returns high and any extra bits are ignored. At the same time, when
CS
goes high, it gates the address decoder enabling one of two
positive edge-triggered AD5207 RDAC latches; see Figure 5 detail.
SDI
CLK
CS
CK RS
D
Q
SERIAL
REGISTER
SDO
SHDN
INTERNAL
RS
Figure 4. Detail SDO Output Schematic of the AD5207
The target RDAC latch is loaded with the last eight bits of the
data word to complete one RDAC update. For AD5207, it
cannot update both channels simultaneously and therefore, two
separate 10-bit data words must be clocked in to change both
VR settings.
RDAC1
RDAC2
ADDR
DECODE
SERIAL
REGISTER
AD5207
SDI
CLK
CS
Figure 5. Equivalent Input Control Logic
All digital inputs are protected with a series input resistor and
parallel Zener ESD structure shown in Figures 6 and 7. Applies
to digital input pins
CS
, SDI, SDO,
SHDN
, and CLK. Digital
input level for Logic 1 can be anywhere from 2.4 V to 5 V
regardless of whether it is in single or dual supplies.
340
V
SS
LOGIC
DIGITAL PIN
Figure 6. ESD Protection of Digital Pins
A,B,W
V
SS
Figure 7. ESD Protection of Resistor Terminals
D7
D6
D5
D4
D3
D2
D1
D0
RDAC
LATCH
AND
DECODER
R
S
R
S
R
S
R
S
SHDN
Ax
Wx
Bx
Figure 8. Equivalent RDAC Circuit
PROGRAMMING THE VARIABLE RESISTOR
Rheostat Operation
The nominal resistance of the RDAC between Terminals A and
B is available with values of 10 k
, 50 k
, and 100 k
. The last
few digits of the part number determine the nominal resistance
value, e.g., 10 k
= 10; 50 k
= 50; and 100 k
= 100. The
nominal resistance (R
AB
) of the VR has 256 contact points
accessed by the wiper terminal, plus the B Terminal contact.
The 8-bit data in the RDAC latch is decoded to select one of
the 256 possible settings. Assume a 10 k
part is used, the
wiper’s first connection starts at the B Terminal for data 00
H
.
Since there is a 45
wiper contact resistance, such connection
yields a minimum of 45
resistance between Terminals W and
B. The second connection is the first tap point corresponds to
84
(R
WB
= R
AB
/256 + R
W
= 39
+ 45
) for data 01
H
. The
third connection is the next tap point representing 123
(39
×
2 + 45) for data 02
H
and so on. Each LSB value increase moves
the wiper up the resistor ladder until the last tap point is reached at
10006
(R
AB
– 1 LSB + R
W
). Figure 8 shows a simplified dia-
gram of the equivalent RDAC circuit.
The general equation determining the programmable output
resistance between W and B is:
R
D
( )
=
D
R
R
WB
AB
W
×
+
256
(1)
where
D
is the data contained in the 8-bit RDAC latch, and
R
AB
is the nominal end-to-end resistance.
For example, R
AB
=10 k
, A Terminal can be open-circuit or
tied to W. The following output resistance R
WB
will be set for
the following RDAC latch codes.
相關PDF資料
PDF描述
AD5201BRM10-REEL7 Audio digital potentiometers
AD5201BRM50-REEL7 Audio digital potentiometers
AD5207 2-Channel, 256-Position Digital Potentiometer
AD5207BRU10-REEL7 2-Channel, 256-Position Digital Potentiometer
AD5207BRU100-REEL7 2-Channel, 256-Position Digital Potentiometer
相關代理商/技術參數
參數描述
AD5201BD 制造商:Rochester Electronics LLC 功能描述:- Bulk 制造商:Analog Devices 功能描述:
AD5201BRM10-REEL7 制造商:Rochester Electronics LLC 功能描述:5-BIT DIGITAL POT - Tape and Reel 制造商:Analog Devices 功能描述:
AD5201BRM50 制造商:Analog Devices 功能描述:Digital Potentiometer 33POS 50KOhm Single 10-Pin MSOP 制造商:Rochester Electronics LLC 功能描述:5-BIT DIGITAL POT - Bulk
AD5201BRM50-REEL7 制造商:Analog Devices 功能描述:Digital Potentiometer 33POS 50KOhm Single 10-Pin MSOP T/R 制造商:Rochester Electronics LLC 功能描述:5-BIT DIGITAL POT - Tape and Reel
AD5201BRMZ10 功能描述:IC DGTL POT 10K 33POS 10-MSOP RoHS:是 類別:集成電路 (IC) >> 數據采集 - 數字電位器 系列:- 標準包裝:3,300 系列:WiperLock™ 接片:257 電阻(歐姆):100k 電路數:1 溫度系數:標準值 150 ppm/°C 存儲器類型:易失 接口:3 線 SPI(芯片選擇) 電源電壓:1.8 V ~ 5.5 V 工作溫度:-40°C ~ 125°C 安裝類型:表面貼裝 封裝/外殼:8-VDFN 裸露焊盤 供應商設備封裝:8-DFN-EP(3x3) 包裝:帶卷 (TR)