- 您現在的位置：買賣IC網 > PDF目錄9435 > AD5228BUJZ10-RL7 (Analog Devices Inc)IC DGTL POT UP/DN 10K TSOT23-8 PDF資料下載
參數資料
| 型號： | AD5228BUJZ10-RL7 |
| 廠商： | Analog Devices Inc |
| 文件頁數： | 4/20頁 |
| 文件大?。?/td> | 0K |
| 描述： | IC DGTL POT UP/DN 10K TSOT23-8 |
| 標準包裝： | 1 |
| 接片： | 32 |
| 電阻（歐姆）： | 10k |
| 電路數： | 1 |
| 溫度系數： | 標準值 35 ppm/°C |
| 存儲器類型： | 易失 |
| 接口： | 2 線按鈕 |
| 電源電壓： | 2.7 V ~ 5.5 V |
| 工作溫度： | -40°C ~ 105°C |
| 安裝類型： | 表面貼裝 |
| 封裝/外殼： | SOT-23-8 薄型，TSOT-23-8 |
| 供應商設備封裝： | TSOT-23-8 |
| 包裝： | 標準包裝 |
| 產品目錄頁面： | 786 (CN2011-ZH PDF) |
| 配用： | EVAL-AD5228EBZ-ND - BOARD EVAL FOR AD5228 DGTL POT |
| 其它名稱： | AD5228BUJZ10RL7DKR |
AD5228
Rev. A | Page 12 of 20
If the PU button is held for longer than 1 second, continuously
holding it activates autoscan mode such that the AD5228
increments by four RWB steps per second (see
).
Whenever the maximum RWB (= RAB) is reached, RWB stops
incrementing regardless of the state of the PU pin. Any continu-
ous holding of the PU pin to logic-low simply elevates the supply
current.
When both PU and PD buttons are pressed, RWB decrements
until it stops at zero scale.
All the preceding descriptions apply to PD operation. Due to
the tolerance of the internal RC oscillator, all the timing
information given previously is based on the typical values,
which can vary ±30%.
The AD5228 debouncer is carefully designed to handle common
pushbutton tactile switches. Other switches that have excessive
bounces and duration are not suitable to use in conjunction
with the AD5228.
04422-0-035
B
W
A
D0
D2
D1
D4
D3
RS
RS = RAB/32
RW
RS
RDAC
UP/DOWN
CTRL AND
DECODE
Figure 34. AD5228 Equivalent RDAC Circuit
PROGRAMMING THE DIGITAL POTENTIOMETERS
Rheostat Operation
If only the W-to-B or W-to-A terminals are used as variable
resistors, the unused terminal can be opened or shorted with W.
Such operation is called rheostat mode and is shown in Figure 35.
04422-0-036
A
W
B
A
W
B
A
W
B
Figure 35. Rheostat Mode Configuration
The end-to-end resistance, RAB, has 32 contact points accessed
by the wiper terminal, plus the B terminal contact if RWB is used.
Pushing the PU pin discretely increments RWB by one step. The
total resistance becomes RS + RW as shown in
. The
change of RWB can be determined by the number of discrete
PU
executions provided that its maximum setting is not reached
during operation. RWB can, therefore, be approximated as
+
=
Δ
W
AB
WB
R
PU
R
32
(1)
+
=
Δ
W
AB
WB
R
PD
R
32
(2)
where:
PU is the number of push-up executions.
PD is the number of push-down executions.
RAB is the end-to-end resistance.
RW is the wiper resistance contributed by the on-resistance of
the internal switch.
Similar to the mechanical potentiometer, the resistance of the
RDAC between the Wiper W and Terminal A also produces a
complementary resistance, RWA. When these terminals are used,
the B terminal can be opened or shorted to W. RWA can also be
approximated if its maximum and minimum settings are not
reached.
(
)
+
=
Δ
W
AB
WA
R
PU
R
32
3)
(
)
+
+
=
Δ
W
AB
WA
R
PD
R
32
(4)
Note that Equations 1 to 4 do not apply when PU and PD = 0
execution.
Because in the lowest end of the resistor string, a finite wiper
resistance is present, care should be taken to limit the current
flow between W and B in this state to a maximum pulse current
of no more than 20 mA. Otherwise, degradation or possible
destruction of the internal switches can occur.
The typical distribution of the resistance tolerance from device
to device is process lot dependent, and ±20% tolerance is possible.
相關PDF資料 |
PDF描述 |
|---|---|
| D38999/20JE8PN | CONN RCPT 8POS WALL MNT W/PINS |
| MS27466P23F55P | CONN RCPT 55POS WALL MT W/PINS |
| MS27497E20F41SD | CONN RCPT 41POS WALL MNT W/SCKT |
| D38999/26WC4PD | CONN PLUG 4POS STRAIGHT W/PINS |
| VI-BTW-MX-B1 | CONVERTER MOD DC/DC 5.5V 75W |
相關代理商/技術參數 |
參數描述 |
|---|---|
| AD5228BUJZ50 | 制造商:Analog Devices 功能描述:DGTL POTENTIOMETER 32POS 50KOHM SGL 8PIN TSOT - Bulk |
| AD5228BUJZ502-R2 | 制造商:AD 制造商全稱:Analog Devices 功能描述:32-Position Manual Up/Down Control Potentiometer |
| AD5228BUJZ502-RL7 | 制造商:AD 制造商全稱:Analog Devices 功能描述:32-Position Manual Up/Down Control Potentiometer |
| AD5228BUJZ50-R2 | 功能描述:IC DGTL POT 50K UP/DN TSOT23-8 RoHS:是 類別:集成電路 (IC) >> 數據采集 - 數字電位器 系列:- 標準包裝:2,500 系列:XDCP™ 接片:256 電阻（歐姆）:100k 電路數:1 溫度系數:標準值 ±300 ppm/°C 存儲器類型:非易失 接口:I²C（設備位址） 電源電壓:2.7 V ~ 5.5 V 工作溫度:0°C ~ 70°C 安裝類型:表面貼裝 封裝/外殼:14-TSSOP（0.173"，4.40mm 寬） 供應商設備封裝:14-TSSOP 包裝:帶卷 (TR) |
| AD5228BUJZ50-R2 | 制造商:Analog Devices 功能描述:DIGIPOT 5BIT UP/DOWN 50K, SMD, 5228 |
發布緊急采購，3分鐘左右您將得到回復。