- 您現在的位置：買賣IC網 > PDF目錄373874 > AD5253 (Analog Devices, Inc.) Dual, 256-Tap, Nonvolatile, I2C-Interface, Digital Potentiometers PDF資料下載
參數資料
| 型號： | AD5253 |
| 廠商： | Analog Devices, Inc. |
| 元件分類： | 通用總線功能 |
| 英文描述： | Dual, 256-Tap, Nonvolatile, I2C-Interface, Digital Potentiometers |
| 中文描述： | 雙路、256抽頭、非易失、I2C接口、數字電位器 |
| 文件頁數： | 21/28頁 |
| 文件大小： | 834K |
| 代理商： | AD5253 |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁當前第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁
AD5253/AD5254
DIGITAL INPUT/OUTPUT CONFIGURATION
SDA is a digital input/output with an open-drain MOSFET that
requires a pull-up resistor for proper communication. On the
other hand, SCL and WP are digital inputs with pull-up
resistors recommended to minimize the MOSFET cross-
conduction when the driving signals are lower than V
DD
. SCL
and WP have ESD protection diodes, as shown in Figure 35 and
Figure 36.
Rev. 0 | Page 21 of 28
WP can be permanently tied to V
DD
without a pull-up resistor if
the write-protect feature is not used. If WP is left floating, an
internal current source will pull it low to enable write-protect.
In applications where the device is not being programmed on a
frequent basis, this allows the part to default to write-protect
after any one-time factory programming or field calibration
without using an on-board pull-down resistor. Since there are
protection diodes on all these inputs, their signal levels must not
be greater than V
DD
to prevent forward biasing of the diodes.
0
GND
SCL
V
DD
Figure 35. SCL Digital Input
0
GND
INPUTS
WP
V
DD
Figure 36. Equivalent WP Digital Input
MULTIPLE DEVICES ON ONE BUS
AD5253/AD5254 are equipped with two addressing pins, AD1
and AD0, that allow up to four AD5253/AD5254s to be
operated on one I
2
C bus. To achieve this result, the states of
AD1 and AD0 on each device must first be defined. An example
is shown in Table 12 and Figure 37. In I
2
C programming, each
device is issued a different slave address—01011(AD1)(AD0)—
to complete the addressing.
Table 12. Multiple Devices Addressing
AD1
AD0
Device Addressed
0
0
U1
0
1
U2
1
0
U3
1
1
U4
0
V
DD
R
P
R
P
+5V
V
DD
V
DD
U1
AD0
AD1
SDA SCL
MASTER
U2
AD0
AD1
SDA SCL
U3
AD0
AD1
SDA SCL
U4
AD0
AD1
SDA
SDA
SCL
SCL
Figure 37. Multiple AD5253/AD5254s on a Single Bus
In wireless base station smart antenna systems where arrays of
digital potentiometers may be needed to bias the power
amplifiers, large numbers of AD5253/AD5254s can be
addressed by using extra decoders, switches, and I/O buses, as
shown in Figure 38. For example, to communicate to a total of
16 devices, four decoders and 16 sets of combinational switches
(four sets shown in Figure 36) are needed. Two I/O buses serve
as the common inputs of the four 2 × 4 decoders and select four
sets of outputs at each combination. Because the four sets of
combination switch outputs are unique, as shown in Figure 38, a
specific device is addressed by proper I
2
C programming with
the slave address defined as 01011(AD1)(AD0). This operation
allows one out of 16 devices to be addressed, provided the
inputs of the two decoders do not change states. The decoders’
inputs are allowed to change once the operation of the specified
device is completed.
相關PDF資料 |
PDF描述 |
|---|---|
| AD5253BRU1 | Dual, 256-Tap, Nonvolatile, I2C-Interface, Digital Potentiometers |
| AD5253BRU1-RL7 | Dual, 256-Tap, Nonvolatile, I2C-Interface, Digital Potentiometers |
| AD5253BRU10 | Dual, 256-Tap, Nonvolatile, I2C-Interface, Digital Potentiometers |
| AD5253BRU10-RL7 | Dual, 256-Tap, Nonvolatile, I2C-Interface, Digital Potentiometers |
| AD5253BRU100 | Dual, 256-Tap, Nonvolatile, I2C-Interface, Digital Potentiometers |
相關代理商/技術參數 |
參數描述 |
|---|---|
| AD5253_12 | 制造商:AD 制造商全稱:Analog Devices 功能描述:Quad 64-/256-Position I2C Nonvolatile Memory Digital Potentiometers |
| AD5253BRU1 | 功能描述:IC DGTL POT QUAD 1K I2C 20-TSSOP RoHS:否 類別:集成電路 (IC) >> 數據采集 - 數字電位器 系列:- 標準包裝:3,000 系列:DPP 接片:32 電阻（歐姆）:10k 電路數:1 溫度系數:標準值 300 ppm/°C 存儲器類型:非易失 接口:3 線串行（芯片選擇，遞增，增/減） 電源電壓:2.5 V ~ 6 V 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:8-WFDFN 裸露焊盤 供應商設備封裝:8-TDFN（2x3） 包裝:帶卷 (TR) |
| AD5253BRU10 | 功能描述:IC DGTL POT QUAD 10K I2C 20TSSOP RoHS:否 類別:集成電路 (IC) >> 數據采集 - 數字電位器 系列:- 標準包裝:3,000 系列:DPP 接片:32 電阻（歐姆）:10k 電路數:1 溫度系數:標準值 300 ppm/°C 存儲器類型:非易失 接口:3 線串行（芯片選擇，遞增，增/減） 電源電壓:2.5 V ~ 6 V 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:8-WFDFN 裸露焊盤 供應商設備封裝:8-TDFN（2x3） 包裝:帶卷 (TR) |
| AD5253BRU100 | 功能描述:IC DGTL POT QUAD 100K 20-TSSOP RoHS:否 類別:集成電路 (IC) >> 數據采集 - 數字電位器 系列:- 標準包裝:3,000 系列:DPP 接片:32 電阻（歐姆）:10k 電路數:1 溫度系數:標準值 300 ppm/°C 存儲器類型:非易失 接口:3 線串行（芯片選擇，遞增，增/減） 電源電壓:2.5 V ~ 6 V 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:8-WFDFN 裸露焊盤 供應商設備封裝:8-TDFN（2x3） 包裝:帶卷 (TR) |
| AD5253BRU100-RL7 | 制造商:Analog Devices 功能描述:Digital Potentiometer 64POS 100KOhm Quad 20-Pin TSSOP T/R 制造商:Analog Devices 功能描述:DGTL POTENTIOMETER 64POS 100KOHM QUAD 20TSSOP - Tape and Reel |
發布緊急采購，3分鐘左右您將得到回復。