- 您現在的位置：買賣IC網 > PDF目錄9285 > AD5292BRUZ-20-RL7 (Analog Devices Inc)IC POT DIG 1024P SPI 20K 14TSSOP PDF資料下載
參數資料
| 型號： | AD5292BRUZ-20-RL7 |
| 廠商： | Analog Devices Inc |
| 文件頁數： | 27/32頁 |
| 文件大小： | 0K |
| 描述： | IC POT DIG 1024P SPI 20K 14TSSOP |
| 設計資源： | 30 V Low Cost DAC Using AD5292 Digital Potentiometer (CN0111) Variable Gain Noninverting Amplifier Using AD5292 and OP184 (CN0112) Variable Gain Inverting Amplifier Using AD5292 and OP184 (CN0113) Low Cost, High Voltage, Programmable Gain Instrumentation Amplifier Using AD5292 and AD8221 (CN0114) Programmable High Voltage Source with Boosted Output Current Using AD5292, OP184, and MOSFETs (CN0115) Programmable Bidirectional Current Source Using AD5292 and ADA4091-4 (CN0117) Logarithmic Audio Volume Control with Glitch Reduction Using AD5292 (CN0120) |
| 標準包裝： | 1,000 |
| 接片： | 1024 |
| 電阻（歐姆）： | 20k |
| 電路數： | 1 |
| 溫度系數： | 標準值 35 ppm/°C |
| 存儲器類型： | 非易失 |
| 接口： | 4 線串行 |
| 電源電壓： | 9 V ~ 33 V，±9 V ~ 16.5 V |
| 工作溫度： | -40°C ~ 105°C |
| 安裝類型： | 表面貼裝 |
| 封裝/外殼： | 14-TSSOP（0.173"，4.40mm 寬） |
| 供應商設備封裝： | 14-TSSOP |
| 包裝： | 帶卷 (TR) |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁當前第27頁第28頁第29頁第30頁第31頁第32頁
AD5291/AD5292
Rev. D | Page 4 of 32
Parameter
Symbol
Conditions
Min
Max
Unit
DYNAMIC CHARACTERISTICS5, 10
Bandwidth
BW
3 dB, code = half-scale
kHz
RAB = 20 kΩ
520
RAB = 50 kΩ
210
RAB = 100 kΩ
105
Total Harmonic Distortion
THDW
VA = 1 V rms, VB = 0 V, f = 1 kHz
dB
RAB = 20 kΩ
93
RAB = 50 kΩ
101
RAB = 100 kΩ
106
VW Settling Time
tS
VA = 30 V, VB = 0 V, ±0.5 LSB error
band, initial code = zero scale,
board capacitance = 170 pF
Code = full-scale, normal mode
750
ns
Code = full-scale, R-Perf mode
2.5
μs
Code = half-scale, normal mode
μs
RAB = 20 kΩ
2.5
RAB = 50 kΩ
7
RAB = 100 kΩ
14
Code = half-scale, R-Perf mode
μs
RAB = 20 kΩ
5
RAB = 50 kΩ
9
RAB = 100 kΩ
16
Resistor Noise Density
eN_WB
Code = half-scale, TA = 25°C, 0 kHz
to 200 kHz
nV/√Hz
RAB = 20 kΩ
10
RAB = 50 kΩ
18
RAB = 100 kΩ
27
1 Typical values represent average readings at 25°C, VDD = 15 V, VSS = 15 V, and VLOGIC = 5 V.
2 Resistor position nonlinearity error. R-INL is the deviation from an ideal value measured between the RWB at code 0x02 to code 0xFF or between RWA at code 0xFD to
code 0x00. R-DNL measures the relative step change from ideal between successive tap positions. The specification is guaranteed in resistor performance mode, with
a wiper current of 1 mA for VA < 12 V and 1.2 mA for VA ≥ 12 V.
3 Resistor performance mode (see the Resistor Performance Mode section). The terms resistor performance mode and R-Perf mode are used interchangeably.
4 Guaranteed by design and characterization, not subject to production test.
5 INL and DNL are measured at VWB with the RDAC configured as a potentiometer divider similar to a voltage output DAC. VA = VDD and VB = 0 V. DNL specification limits
of ±1 LSB maximum are guaranteed monotonic operating conditions.
6 Resistor Terminal A, Resistor Terminal B, and Resistor Terminal W have no limitations on polarity with respect to each other. Dual-supply operation enables ground-
referenced bipolar signal adjustment.
7 Different from operating current; supply current for fuse program lasts approximately 550 μs.
8 Different from operating current; supply current for fuse read lasts approximately 550 μs.
9 PDISS is calculated from (IDD × VDD) + (ISS × VSS) + (ILOGIC × VLOGIC).
10 All dynamic characteristics use VDD = 15 V, VSS = 15 V, and VLOGIC = 5 V.
RESISTOR PERFORMANCE MODE CODE RANGE
Table 2.
RAB = 20 kΩ
|VDD VSS| = 30 V to 33 V
|VDD VSS| = 26 V to 30 V
|VDD VSS| = 22 V to 26 V
|VDD VSS| = 21 V to 22 V
Resistor
Tolerance per
Code
RWB
RWA
RWB
RWA
RWB
RWA
RWB
RWA
1% R-Tolerance
From 0x5A
to 0xFF
From 0x00
to 0xA5
From 0x7D
to 0xFF
From 0x00
to 0x82
From 0x7D
to 0xFF
From 0x00
to 0x82
N/A
2% R-Tolerance
From 0x23
to 0xFF
From 0x00
to 0xDC
From 0x2D
to 0xFF
From 0x00
to 0xD2
From 0x23
to 0xFF
From 0x00
to 0xDC
From 0x23
to 0xFF
From 0x00
to 0xDC
3% R-Tolerance
From 0x1E
to 0xFF
From 0x00
to 0xE1
From 0x19
to 0xFF
From 0x00
to 0xE6
From 0x17
to 0xFF
From 0x00
to 0xE8
From 0x17
to 0xFF
From 0x00
to 0xE8
相關PDF資料 |
PDF描述 |
|---|---|
| DS1100U-200/T&R | IC DELAY LINE 5TAP 200NS 8-USOP |
| VI-274-MW | CONVERTER MOD DC/DC 48V 100W |
| AD7376ARWZ10-RL | IC POT DIGITAL 10K 16-SOIC |
| DS1100U-30/T&R | IC DELAY LINE 5TAP 30NS 8-USOP |
| AD5232BRUZ10-REEL7 | IC POT DGTL DUAL 256POS 16TSSOP |
相關代理商/技術參數 |
參數描述 |
|---|---|
| AD5292BRUZ-50 | 功能描述:IC DGTL POT 1024POS 20K 14TSSOP RoHS:是 類別:集成電路 (IC) >> 數據采集 - 數字電位器 系列:- 產品培訓模塊:Lead (SnPb) Finish for COTS Obsolescence Mitigation Program 標準包裝:1 系列:- 接片:256 電阻（歐姆）:100k 電路數:1 溫度系數:標準值 35 ppm/°C 存儲器類型:非易失 接口:3 線串口 電源電壓:2.7 V ~ 5.25 V 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:8-WDFN 裸露焊盤 供應商設備封裝:8-TDFN-EP（3x3） 包裝:剪切帶 (CT) 產品目錄頁面:1399 (CN2011-ZH PDF) 其它名稱:MAX5423ETA+TCT |
| AD5292BRUZ-50-RL7 | 功能描述:IC DGTL POT 1024POS 20K 14TSSOP RoHS:是 類別:集成電路 (IC) >> 數據采集 - 數字電位器 系列:- 標準包裝:3,000 系列:DPP 接片:32 電阻（歐姆）:10k 電路數:1 溫度系數:標準值 300 ppm/°C 存儲器類型:非易失 接口:3 線串行（芯片選擇，遞增，增/減） 電源電壓:2.5 V ~ 6 V 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:8-WFDFN 裸露焊盤 供應商設備封裝:8-TDFN（2x3） 包裝:帶卷 (TR) |
| AD5292SRU-20-EP | 制造商:Analog Devices 功能描述:1024 TAP, 1% DIGIPOT WITH SPI INTERFACE - Rail/Tube 制造商:Analog Devices 功能描述:IC DGTL POT 1024POS 20K 14TSSOP 制造商:Analog Devices 功能描述:1024 tap 1% digiPOT with SPI interface |
| AD5292SRUZ-20-EP | 功能描述:IC DGTL POT 1024POS 20K 14TSSOP 制造商:analog devices inc. 系列:* 零件狀態(tài):在售 標準包裝:96 |
| AD5293 | 制造商:AD 制造商全稱:Analog Devices 功能描述:Single-Channel, 1024-Position, 1% R-Tolerance Digital Potentiometer |
發(fā)布緊急采購，3分鐘左右您將得到回復。