- 您現在的位置：買賣IC網 > PDF目錄8669 > AD5439YRU (Analog Devices Inc)IC DAC DUAL 10BIT MULT 16-TSSOP PDF資料下載
參數資料
| 型號： | AD5439YRU |
| 廠商： | Analog Devices Inc |
| 文件頁數： | 15/29頁 |
| 文件大?。?/td> | 0K |
| 描述： | IC DAC DUAL 10BIT MULT 16-TSSOP |
| 產品培訓模塊： | Data Converter Fundamentals DAC Architectures |
| 標準包裝： | 96 |
| 設置時間： | 35ns |
| 位數： | 10 |
| 數據接口： | 串行 |
| 轉換器數目： | 2 |
| 電壓電源： | 單電源 |
| 功率耗散（最大）： | 3.5µW |
| 工作溫度： | -40°C ~ 125°C |
| 安裝類型： | 表面貼裝 |
| 封裝/外殼： | 16-TSSOP（0.173"，4.40mm 寬） |
| 供應商設備封裝： | 16-TSSOP |
| 包裝： | 管件 |
| 輸出數目和類型： | 4 電流，單極；4 電流，雙極 |
| 采樣率（每秒）： | 2.47M |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁當前第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁
Data Sheet
AD5429/AD5439/AD5449
Rev. E | Page 21 of 28
SYNC Function
SYNC is an edge-triggered input that acts as a frame synchron-
ization signal and chip enable. Data can be transferred into the
device only while SYNC is low. To start the serial data transfer,
SYNC should be taken low, observing the minimum SYNC
falling edge to SCLK falling edge setup time, t4.
Daisy-Chain Mode
Daisy-chain mode is the default power-on mode. To disable the
daisy-chain function, write 1001 to the control word. In daisy-
chain mode, the internal gating on SCLK is disabled. SCLK is
continuously applied to the input shift register when SYNC is
low. If more than 16 clock pulses are applied, the data ripples
out of the shift register and appears on the SDO line. This data
is clocked out on the rising edge of SCLK (this is the default; use
the control word to change the active edge) and is valid for the
next device on the falling edge of SCLK (default). By connecting
this line to the SDIN input on the next device in the chain,
a multidevice interface is constructed. For each device in the
system, 16 clock pulses are required. Therefore, the total number
of clock cycles must equal 16n, where n is the total number of
devices in the chain. See Figure 4.
When the serial transfer to all devices is complete, SYNC should
be taken high. This prevents additional data from being clocked
into the input shift register. A burst clock containing the exact
number of clock cycles can be used, after which SYNC can be
taken high. After the rising edge of SYNC, data is automatically
transferred from the input shift register of each device to the
addressed DAC.
When control bits = 0000, the device is in no operation mode.
This may be useful in daisy-chain applications in which the user
does not want to change the settings of a particular DAC in the
chain. Write 0000 to the control bits for that DAC; subsequent
data bits are ignored.
Standalone Mode
After power-on, write 1001 to the control word to disable daisy-
chain mode. The first falling edge of SYNC resets the serial
clock counter to ensure that the correct number of bits are
shifted in and out of the serial shift registers. A SYNC edge
during the 16-bit write cycle causes the device to abort the
current write cycle.
After the falling edge of the 16th SCLK pulse, data is automat-
ically transferred from the input shift register to the DAC. For
another serial transfer to take place, the counter must be reset
by the falling edge of SYNC.
LDAC Function
The LDAC function allows asynchronous and synchronous
updates to the DAC output. The DAC is asynchronously updated
when this signal goes low. Alternatively, if this line is held perma-
nently low, an automatic or synchronous update mode is selected,
whereby the DAC is updated on the 16th clock falling edge when
the device is in standalone mode, or on the rising edge of SYNC
when the device is in daisy-chain mode.
Software LDAC Function
Load-and-update mode can also serve as a software update func-
tion, irrespective of the voltage level on the LDAC pin.
Table 11. DAC Control Bits
C3
C2
C1
C0
DAC
Function Implemented
0
A and B
No operation (power-on default)
0
1
A
Load and update
0
1
0
A
Initiate readback
0
1
A
Load input register
0
1
0
B
Load and update
0
1
0
1
B
Initiate readback
0
1
0
B
Load input register
0
1
A and B
Update DAC outputs
1
0
A and B
Load input registers
1
0
1
N/A
Disable daisy-chain
1
0
1
0
N/A
Clock data to shift register on rising edge
1
0
1
N/A
Clear DAC output to zero scale
1
0
N/A
Clear DAC output to midscale
1
0
1
N/A
Control word
1
0
N/A
Reserved
1
N/A
No operation
相關PDF資料 |
PDF描述 |
|---|---|
| SY89834UMI | IC CLK BUF MUX TRNSLA 2:4 16-MLF |
| AD5060ARJZ-2REEL7 | IC DAC 16BIT SPI/SRL SOT23-8 |
| VI-J0V-MY | CONVERTER MOD DC/DC 5.8V 50W |
| VE-JTK-MX-B1 | CONVERTER MOD DC/DC 40V 75W |
| VI-J0T-MY | CONVERTER MOD DC/DC 6.5V 50W |
相關代理商/技術參數 |
參數描述 |
|---|---|
| AD5439YRU-REEL | 制造商:Analog Devices 功能描述:DAC 2-CH R-2R 10-bit 16-Pin TSSOP T/R 制造商:Analog Devices 功能描述:DAC 2CH R-2R 10-BIT 16TSSOP - Tape and Reel |
| AD5439YRU-REEL7 | 制造商:Analog Devices 功能描述:DAC 2-CH R-2R 10-bit 16-Pin TSSOP T/R 制造商:Analog Devices 功能描述:DAC 2CH R-2R 10-BIT 16TSSOP - Tape and Reel |
| AD5439YRUZ | 功能描述:IC DAC DUAL 10BIT MULT 16-TSSOP RoHS:是 類別:集成電路 (IC) >> 數據采集 - 數模轉換器 系列:- 產品培訓模塊:Lead (SnPb) Finish for COTS Obsolescence Mitigation Program 標準包裝:50 系列:- 設置時間:4µs 位數:12 數據接口:串行 轉換器數目:2 電壓電源:單電源 功率耗散（最大）:- 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:8-TSSOP，8-MSOP（0.118"，3.00mm 寬） 供應商設備封裝:8-uMAX 包裝:管件 輸出數目和類型:2 電壓，單極 采樣率（每秒）:* 產品目錄頁面:1398 (CN2011-ZH PDF) |
| AD5439YRUZ-REEL | 功能描述:IC DAC DUAL 10BIT MULT 16TSSOP RoHS:是 類別:集成電路 (IC) >> 數據采集 - 數模轉換器 系列:- 產品培訓模塊:LTC263x 12-, 10-, and 8-Bit VOUT DAC Family 特色產品:LTC2636 - Octal 12-/10-/8-Bit SPI VOUT DACs with 10ppm/°C Reference 標準包裝:91 系列:- 設置時間:4µs 位數:10 數據接口:MICROWIRE?，串行，SPI? 轉換器數目:8 電壓電源:單電源 功率耗散（最大）:2.7mW 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:14-WFDFN 裸露焊盤 供應商設備封裝:14-DFN-EP（4x3） 包裝:管件 輸出數目和類型:8 電壓，單極 采樣率（每秒）:* |
| AD5439YRUZ-REEL7 | 功能描述:IC DAC DUAL 10BIT MULT 16TSSOP RoHS:是 類別:集成電路 (IC) >> 數據采集 - 數模轉換器 系列:- 產品培訓模塊:LTC263x 12-, 10-, and 8-Bit VOUT DAC Family 特色產品:LTC2636 - Octal 12-/10-/8-Bit SPI VOUT DACs with 10ppm/°C Reference 標準包裝:91 系列:- 設置時間:4µs 位數:10 數據接口:MICROWIRE?，串行，SPI? 轉換器數目:8 電壓電源:單電源 功率耗散（最大）:2.7mW 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:14-WFDFN 裸露焊盤 供應商設備封裝:14-DFN-EP（4x3） 包裝:管件 輸出數目和類型:8 電壓，單極 采樣率（每秒）:* |
發布緊急采購，3分鐘左右您將得到回復。