- 您現在的位置：買賣IC網 > PDF目錄8997 > AD5445YRUZ (Analog Devices Inc)IC DAC 12BIT PARALL IOUT 20TSSOP PDF資料下載
參數資料
| 型號： | AD5445YRUZ |
| 廠商： | Analog Devices Inc |
| 文件頁數： | 15/29頁 |
| 文件大?。?/td> | 0K |
| 描述： | IC DAC 12BIT PARALL IOUT 20TSSOP |
| 產品培訓模塊： | Data Converter Fundamentals DAC Architectures |
| 標準包裝： | 75 |
| 設置時間： | 80ns |
| 位數： | 12 |
| 數據接口： | 并聯 |
| 轉換器數目： | 1 |
| 電壓電源： | 單電源 |
| 工作溫度： | -40°C ~ 125°C |
| 安裝類型： | 表面貼裝 |
| 封裝/外殼： | 20-TSSOP（0.173"，4.40mm 寬） |
| 供應商設備封裝： | 20-TSSOP |
| 包裝： | 管件 |
| 輸出數目和類型： | 2 電流，單極；2 電流，雙極 |
| 采樣率（每秒）： | 20.4M |
| 產品目錄頁面： | 782 (CN2011-ZH PDF) |
| 配用： | EVAL-AD5445EBZ-ND - BOARD EVALUATION FOR AD5445 |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁當前第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁
Data Sheet
AD5424/AD5433/AD5445
Rev. D | Page 21 of 28
ADDING GAIN
In applications where the output voltage is required to be
greater than VIN, gain can be added with an additional external
amplifier or it can be achieved in a single stage. It is important
to consider the effect of the temperature coefficients of the thin
film resistors of the DAC. Simply placing a resistor in series with
the RFB resistor causes mismatches in the temperature coefficients
and results in larger gain temperature coefficient errors. Instead,
the circuit shown in Figure 54 is a recommended method of
increasing the gain of the circuit. R1, R2, and R3 should have
similar temperature coefficients, but they need not match
the temperature coefficients of the DAC. This approach is
recommended in circuits where gains greater than 1 are
required.
03160-
054
8-/10-/12-BIT
DAC
GND
VDD
RFB
VDD
VOUT
VREF
VIN
ADDITIONAL PINS OMITTED FOR CLARITY
C1 PHASE COMPENSATION (1pF TO 2pF) MAY BE
REQUIRED IF A1 IS A HIGH SPEED AMPLIFIER.
NOTES:
1.
2.
C1
R1
IOUT1
IOUT2
R1 =
GAIN =
R2 + R3
R2
R3
R2
R2R3
R2 + R3
Figure 54. Increasing the Gain of the Current Output DAC
DACS USED AS A DIVIDER OR PROGRAMMABLE
GAIN ELEMENT
Current steering DACs are very flexible and lend themselves to
many different applications. If this type of DAC is connected as
the feedback element of an op amp and RFB is used as the input
resistor, as shown in Figure 55, then the output voltage is
inversely proportional to the digital input fraction, D.
For D = 1 – 2–n the output voltage is
VOUT = –VIN/D = –VIN/(1 2–n)
As D is reduced, the output voltage increases. For small values
of D, it is important to ensure that the amplifier does not saturate
and that the required accuracy is met.
For example, in the circuit shown in Figure 55, an 8-bit DAC
driven with the binary code 0x10 (00010000), that is, 16 decimal,
should cause the output voltage to be 16 × VIN. However, if the
DAC has a linearity specification of ±0.5 LSB, then D can in fact
have a weight anywhere in the range 15.5/256 to 16.5/256 so
that the possible output voltage falls in the range 15.5 VIN to
16.5 VIN—an error of 3% even though the DAC itself has a
maximum error of 0.2%.
03160-055
GND
RFB
VDD
VOUT
VREF
VIN
NOTE:
ADDITIONAL PINS OMITTED FOR CLARITY
IOUT1
IOUT2
Figure 55. Current-Steering DAC Used as a Divider or
Programmable Gain Element
DAC leakage current is also a potential error source in divider
circuits. The leakage current must be counterbalanced by an
opposite current supplied from the op amp through the DAC.
Since only a fraction, D, of the current into the VREF terminal is
routed to the IOUT1 terminal, the output voltage has to change
as follows:
Output Error Voltage due to DAC Leakage = (Leakage × R)/D
where R is the DAC resistance at the VREF terminal.
For a DAC leakage current of 10 nA, R = 10 kΩ, and a gain
(that is, 1/D) of 16, the error voltage is 1.6 mV.
相關PDF資料 |
PDF描述 |
|---|---|
| VI-JTL-MZ-F4 | CONVERTER MOD DC/DC 28V 25W |
| AD7628KNZ | IC DAC 8BIT DUAL MULTIPLY 20-DIP |
| ICS84330CM-01LFT | IC FREQ SYNTHESIZER 28SOIC |
| VI-JTL-MZ-F3 | CONVERTER MOD DC/DC 28V 25W |
| AD7628KPZ | IC DAC 8BIT DUAL MULTIPLY 20PLCC |
相關代理商/技術參數 |
參數描述 |
|---|---|
| AD5445YRUZ | 制造商:Analog Devices 功能描述:12BIT DAC PARALLEL I/F SMD 5445 |
| AD5445YRUZ-REEL | 功能描述:IC DAC 12BIT PARALL IOUT 20TSSOP RoHS:是 類別:集成電路 (IC) >> 數據采集 - 數模轉換器 系列:- 產品培訓模塊:LTC263x 12-, 10-, and 8-Bit VOUT DAC Family 特色產品:LTC2636 - Octal 12-/10-/8-Bit SPI VOUT DACs with 10ppm/°C Reference 標準包裝:91 系列:- 設置時間:4µs 位數:10 數據接口:MICROWIRE?，串行，SPI? 轉換器數目:8 電壓電源:單電源 功率耗散（最大）:2.7mW 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:14-WFDFN 裸露焊盤 供應商設備封裝:14-DFN-EP（4x3） 包裝:管件 輸出數目和類型:8 電壓，單極 采樣率（每秒）:* |
| AD5445YRUZ-REEL7 | 功能描述:IC DAC 12BIT PARALL IOUT 20TSSOP RoHS:是 類別:集成電路 (IC) >> 數據采集 - 數模轉換器 系列:- 產品培訓模塊:LTC263x 12-, 10-, and 8-Bit VOUT DAC Family 特色產品:LTC2636 - Octal 12-/10-/8-Bit SPI VOUT DACs with 10ppm/°C Reference 標準包裝:91 系列:- 設置時間:4µs 位數:10 數據接口:MICROWIRE?，串行，SPI? 轉換器數目:8 電壓電源:單電源 功率耗散（最大）:2.7mW 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:14-WFDFN 裸露焊盤 供應商設備封裝:14-DFN-EP（4x3） 包裝:管件 輸出數目和類型:8 電壓，單極 采樣率（每秒）:* |
| AD5445YRUZRUZ | 制造商:Analog Devices 功能描述:DAC,AD5445Y 12bit mult current TSSOP |
| AD5446 | 制造商:AD 制造商全稱:Analog Devices 功能描述:Dual 8-,10-,12-Bit High Bandwidth Multiplying DACs with Serial Interface |
發布緊急采購，3分鐘左右您將得到回復。