![](http://datasheet.mmic.net.cn/Analog-Devices-Inc/AD5700-1BCPZ-RL7_datasheet_95832/AD5700-1BCPZ-RL7_13.png)
Data Sheet
AD5700/AD5700-1
Rev. F | Page 13 of 24
THEORY OF OPERATION
Highway Addressable Remote Transducer (HART) Communica-
tion is the global standard for sending and receiving digital
information across analog wires between smart field devices
and control systems. This is a digital two-way communication
system, in which a 1 mA p-p frequency shift keyed (FSK) signal
is modulated on top of a 4 mA to 20 mA analog current signal.
as a single-chip, low power, HART FSK half-duplex modem,
complying with the HART physical layer requirements
(Revision 8.1).
grate the modulation and demodulation functions, but also
contain an internal reference, an integrated receive band-pass
filter (which has the flexibility of being bypassed if required),
and an internally buffered HART output, giving a high output
drive capability and removing the need for external buffering.
illustration of how these circuit blocks are connected together.
As a result of such extensive integration options, minimal
are suitable for use in both HART field instrument and master
configurations.
2.2 kHz carrier signals. A 1.2 kHz signal represents a digital 1,
or mark, whereas a 2.2 kHz signal represents a 0, or space.
There are three main clocking configurations supported by
these parts, two of which are available on the
AD5700 option,
whereas all three are available on the
AD5700-1 device:
External crystal
CMOS clock input
The device is controlled via a standard UART interface. The
relevant signals are RTS, CD, TXD, and RXD (see
Table 6 for
more detail on individual pin descriptions).
FSK MODULATOR
The modulator converts a bit stream of UART-encoded HART
data at the TXD input to a sequence of 1200 Hz and 2200 Hz
tones (se
e Figure 19). This sinusoidal signal is internally buff-
ered and output on the HART_OUT pin. The modulator is
enabled by bringing the RTS signal low.
The modulator block contains a DDS engine that produces a
1.2 kHz or 2.2 kHz sine wave in digital form and then performs
a digital-to-analog conversion. This DDS engine inherently
generates continuous phase signals, thus avoiding any output
discontinuity when switching between frequencies. For more
information on DDS fundamentals, se
e MT-085, Fundamentals
of Direct Digital Synthesizers (DDS)
. Figure 20 demonstrates a
simple implementation of this FSK encoding.
Figure 20. DDS-Based FSK Encoder
10435-
016
STOP
START
8-BIT DATA + PARITY
TXD
HART_OUT
"1" = MARK
1.2kHz
"0" = SPACE
2.2kHz
10435-
017
1.2kHz
WORD
2.2kHz
WORD
MU
X
DDS
DAC
FSK
0
DATA
1
CLOCK