- 您現在的位置：買賣IC網 > PDF目錄1979 > AD5760BCPZ (Analog Devices Inc)IC DAC VOLT OUT 16BIT 24LFCSP PDF資料下載
參數資料
| 型號： | AD5760BCPZ |
| 廠商： | Analog Devices Inc |
| 文件頁數： | 15/28頁 |
| 文件大小： | 0K |
| 描述： | IC DAC VOLT OUT 16BIT 24LFCSP |
| 標準包裝： | 1 |
| 設置時間： | 2.5µs |
| 位數： | 16 |
| 數據接口： | DSP，MICROWIRE?，QSPI?，串行，SPI? |
| 轉換器數目： | 1 |
| 電壓電源： | 模擬和數字，雙 ± |
| 工作溫度： | -40°C ~ 125°C |
| 安裝類型： | 表面貼裝 |
| 封裝/外殼： | 24-VFQFN 裸露焊盤，CSP |
| 供應商設備封裝： | 24-LFCSP-VQ EP（4x5） |
| 包裝： | 托盤 |
| 輸出數目和類型： | 1 電壓，雙極 |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁當前第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁
AD5760
Data Sheet
Rev. D | Page 22 of 28
Control Register
The control register controls the mode of operation of the
Clearcode Register
The clearcode register sets the value to which the DAC output is
set when the CLR pin or CLR bit in the software control register
is asserted. The output value depends on the DAC coding that is
being used, either binary or twos complement. The default
register value is 0.
Table 10. Control Register
MSB
LSB
DB23
DB22
DB21
DB20
DB19 to DB11
DB10
DB9
DB8
DB7
DB6
DB5
DB4
DB3
DB2
DB1
DB0
R/
W
Register address
Control register data
R/
W
0
1
0
Reserved
0000
SDODIS
BIN/2sC
DACTRI
OPGND
RBUF
Reserved
Table 11. Control Register Functions
Bit Name
Description
Reserved
These bits are reserved and should be programmed to zero.
RBUF
Output amplifier configuration control.
0: the internal amplifier, A1, is powered up and Resistors RFB and R1 are connected in series, as shown in Figure 52. This allows
an external amplifier to be connected in a gain of two configuration. See the AD5760 Features section for further details.
1: (default) the internal amplifier, A1, is powered down and Resistors RFB and R1 are connected in parallel, as shown in
Figure 51, so that the resistance between the RFB and INV pins is 3.4 k, equal to the resistance of the DAC. This allows the RFB
and INV pins to be used for input bias current compensation for an external unity-gain amplifier. See the AD5760 Features
section for further details.
OPGND
Output ground clamp control.
0: the DAC output clamp to ground is removed, and the DAC is placed in normal mode.
1: (default) the DAC output is clamped to ground through a ~6 k resistance, and the DAC is placed in tristate mode.
Resetting the part puts the DAC in OPGND mode, where the output ground clamp is enabled and the DAC is tristated.
Setting the OPGND bit to 1 in the control register overrules any write to the DACTRI bit.
DACTRI
DAC tristate control.
0: the DAC is in normal operating mode.
1: (default) the DAC is in tristate mode.
BIN/2sC
DAC register coding selection.
0: (default) the DAC register uses twos complement coding.
1: the DAC register uses offset binary coding.
SDODIS
SDO pin enable/disable control.
0: (default) the SDO pin is enabled.
1: the SDO pin is disabled (tristate).
R/W
Read/write select bit.
0: AD5760 is addressed for a write operation.
1: AD5760 is addressed for a read operation.
Table 12. Clearcode Register
MSB
LSB
DB23
DB22
DB21
DB20
DB19 to DB4
DB3
DB2
DB1
DB0
R/W
Register address
Clearcode register data
R/W
0
1
16 bits of data
1
X is don’t care.
相關PDF資料 |
PDF描述 |
|---|---|
| AD5762RCSUZ-REEL7 | IC DAC 16BIT QUAD VOUT 32-TQFP |
| AD5763CSUZ-REEL7 | DAC 16BIT DUAL 5V 2LSB 32-TQFP |
| AD5764CSUZ | IC DAC 16BIT QUAD VOUT 32TQFP |
| AD5764RBSUZ | IC DAC 16BIT QUAD VOUT 32-TQFP |
| AD5781BRUZ-REEL7 | IC DAC 18BIT SRL 20TSSOP |
相關代理商/技術參數 |
參數描述 |
|---|---|
| AD5760BCPZ-REEL7 | 功能描述:數模轉換器- DAC 16B +/-0.5 LSB INL VOut RoHS:否 制造商:Analog Devices 轉換器數量:4 DAC 輸出端數量:4 轉換速率: 分辨率:12 bit 接口類型:Serial (I2C) 穩定時間: 最大工作溫度:+ 105 C 安裝風格: 封裝 / 箱體:TSSOP 封裝:Reel |
| AD5761ACPZ-RL7 | 功能描述:IC DAC 16BIT 1CH 8LSB 16LFCSP 制造商:analog devices inc. 系列:- 零件狀態:在售 位數:16 數模轉換器數:1 建立時間:12.5μs 輸出類型:Voltage - Buffered 差分輸出:無 數據接口:SPI 參考類型:外部 電壓 - 電源，模擬:4.5 V ~ 30 V， -16.5V 電壓 - 電源，數字:1.7 V ~ 5.5 V INL/DNL（LSB）:±8（最大），±1（最大） 架構:R-2R 工作溫度:-40°C ~ 125°C 標準包裝:1 |
| AD5761ARUZ | 功能描述:16 Bit Digital to Analog Converter 1 16-TSSOP 制造商:analog devices inc. 系列:- 包裝:管件 零件狀態:有效 位數:16 數模轉換器數:1 建立時間:12.5μs 輸出類型:Voltage - Buffered 差分輸出:無 數據接口:SPI 參考類型:外部 電壓 - 電源，模擬:4.5 V ~ 30 V， -16.5V 電壓 - 電源，數字:1.7 V ~ 5.5 V INL/DNL（LSB）:±8（最大），±1（最大） 架構:R-2R 工作溫度:-40°C ~ 125°C 封裝/外殼:16-TSSOP（0.173"，4.40mm 寬） 供應商器件封裝:16-TSSOP 標準包裝:96 |
| AD5761ARUZ-RL7 | 功能描述:16 Bit Digital to Analog Converter 1 16-TSSOP 制造商:analog devices inc. 系列:- 包裝:帶卷（TR） 零件狀態:有效 位數:16 數模轉換器數:1 建立時間:12.5μs 輸出類型:Voltage - Buffered 差分輸出:無 數據接口:SPI 參考類型:外部 電壓 - 電源，模擬:4.5 V ~ 30 V， -16.5V 電壓 - 電源，數字:1.7 V ~ 5.5 V INL/DNL（LSB）:±8（最大），±1（最大） 架構:R-2R 工作溫度:-40°C ~ 125°C 封裝/外殼:16-TSSOP（0.173"，4.40mm 寬） 供應商器件封裝:16-TSSOP 標準包裝:1,000 |
| AD5761BCPZ-RL7 | 功能描述:16 Bit Digital to Analog Converter 1 16-LFCSP-WQ (3x3) 制造商:analog devices inc. 系列:- 包裝:帶卷（TR） 零件狀態:有效 位數:16 數模轉換器數:1 建立時間:12.5μs 輸出類型:Voltage - Buffered 差分輸出:無 數據接口:SPI 參考類型:外部 電壓 - 電源，模擬:4.5 V ~ 30 V， -16.5V 電壓 - 電源，數字:1.7 V ~ 5.5 V INL/DNL（LSB）:±2（最大），±1（最大） 架構:R-2R 工作溫度:-40°C ~ 125°C 封裝/外殼:16-WFQFN 裸露焊盤，CSP 供應商器件封裝:16-LFCSP-WQ（3x3） 標準包裝:1,500 |
發布緊急采購，3分鐘左右您將得到回復。