- 您現在的位置：買賣IC網 > PDF目錄6041 > AD622ANZ (Analog Devices Inc)IC AMP INST LP 18MA 8DIP PDF資料下載
參數資料
| 型號： | AD622ANZ |
| 廠商： | Analog Devices Inc |
| 文件頁數： | 5/17頁 |
| 文件大小： | 0K |
| 描述： | IC AMP INST LP 18MA 8DIP |
| 產品培訓模塊： | Instrumentation Amplifiers Performance |
| 標準包裝： | 50 |
| 放大器類型： | 儀表 |
| 電路數： | 1 |
| 轉換速率： | 1.2 V/µs |
| -3db帶寬： | 1MHz |
| 電流 - 輸入偏壓： | 2nA |
| 電壓 - 輸入偏移： | 60µV |
| 電流 - 電源： | 900µA |
| 電流 - 輸出 / 通道： | 18mA |
| 電壓 - 電源，單路/雙路(±)： | ±2.6 V ~ 18 V |
| 工作溫度： | -40°C ~ 85°C |
| 安裝類型： | 通孔 |
| 封裝/外殼： | 8-DIP（0.300"，7.62mm） |
| 供應商設備封裝： | 8-PDIP |
| 包裝： | 管件 |
| 產品目錄頁面： | 770 (CN2011-ZH PDF) |
AD622
Data Sheet
Rev. E | Page 12 of 16
RF INTERFERENCE
RF rectification is often a problem when amplifiers are used in
applications where there are strong RF signals. The disturbance
may appear as a small dc offset voltage. High frequency signals
can be filtered with a low-pass, RC network placed at the input
of the instrumentation amplifier, as shown in Figure 19. In
addition, this RC input network also provides additional input
overload protection (see the Input Protection section).
RG
REF
VOUT
+IN
–IN
AD622
+
0.1F
10F
+
0.1F
10F
+VS
–VS
CC
1nF
CD
47nF
CC
1nF
R
4.02k
R
4.02k
00777-
017
Figure 19. RFI Suppression Circuit for AD622 Series In-Amps
The filter limits the input signal bandwidth to the following
cutoff frequencies:
)
(2
2
1
C
D
DIFF
C
R
FilterFreq
+
π
=
C
CM
RC
FilterFreq
π
=
2
1
where CD ≥ 10CC.
Figure 19 shows an example where the differential filter
frequency is approximately 400 Hz, and the common-mode
filter frequency is approximately 40 kHz. With this differential
filter in place and operating at gain of 1000, the typical dc offset
shift over a frequency range of 1 Hz to 20 MHz is less than 1.5 V
RTI, and the RF signal rejection of the circuit is better than
71 dB. At a gain of 100, the dc offset shift is well below 1 mV
RTI, and RF rejection is greater than 70 dB.
The input resistors should be selected to be high enough to
isolate the sensor from the CC and C D capacitors but low
enough not to influence system noise. Mismatch between
R × CC at the positive input and R × CC at the negative input
degrades the CMRR of the AD622. Therefore, the CC capacitors
should be high precision types such as NPO/COG ceramics.
The tolerance of the CD capacitor is less critical.
GROUND RETURNS FOR INPUT BIAS CURRENTS
Input bias currents are those currents necessary to bias the
input transistors of an amplifier. There must be a direct return
path for these currents; therefore, when amplifying floating
input sources such as transformers or ac-coupled sources, there
must be a dc path from each input to ground as shown in
Guide to Instrumentation Amplifiers (free from Analog Devices,
Inc.) for more information regarding in-amp applications.
AD622
2
1
8
3
4
5
6
7
+VS
–VS
RG
VOUT
LOAD
–IN
+IN
REF
TO POWER
SUPPLY
GROUND
00777-
018
Figure 20. Ground Returns for Bias Currents with Transformer Coupled Inputs
AD622
2
1
8
3
4
5
6
7
+VS
–VS
RG
VOUT
LOAD
–IN
+IN
REF
TO POWER
SUPPLY
GROUND
00777-
019
Figure 21. Ground Returns for Bias Currents with Thermocouple Inputs
AD622
2
1
8
3
4
5
6
7
+VS
–VS
RG
VOUT
LOAD
–IN
+IN
REF
TO POWER
SUPPLY
GROUND
100k
00777-
020
Figure 22. Ground Returns for Bias Currents with AC-Coupled Inputs
相關PDF資料 |
PDF描述 |
|---|---|
| AD822ARZ | IC OPAMP GP R-R 1.9MHZ LP 8SOIC |
| 1N6373RL4G | TVS ZENER UNIDIR 1500W 6V AXIAL |
| AD8277BRZ | IC AMP GP UNITY GAIN DIFF 14SOIC |
| AD8022ARMZ-REEL7 | IC OPAMP VF DUAL LN LP 8MSOP |
| EHF-125-01-L-D-RA | CONN HEADER .05" 50POS DUAL R/A |
相關代理商/技術參數 |
參數描述 |
|---|---|
| AD622AR | 功能描述:IC AMP INST LP 18MA 8SOIC RoHS:否 類別:集成電路 (IC) >> Linear - Amplifiers - Instrumentation 系列:- 標準包裝:150 系列:- 放大器類型:音頻 電路數:2 輸出類型:- 轉換速率:5 V/µs 增益帶寬積:12MHz -3db帶寬:- 電流 - 輸入偏壓:100nA 電壓 - 輸入偏移:500µV 電流 - 電源:6mA 電流 - 輸出 / 通道:50mA 電壓 - 電源，單路/雙路(±):4 V ~ 32 V，±2 V ~ 16 V 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:8-TSSOP（0.173"，4.40mm 寬） 供應商設備封裝:8-TSSOP 包裝:管件 |
| AD622AR-REEL | 功能描述:IC AMP INST LP 18MA 8SOIC RoHS:否 類別:集成電路 (IC) >> Linear - Amplifiers - Instrumentation 系列:- 標準包裝:2,500 系列:- 放大器類型:通用 電路數:1 輸出類型:滿擺幅 轉換速率:0.11 V/µs 增益帶寬積:350kHz -3db帶寬:- 電流 - 輸入偏壓:4nA 電壓 - 輸入偏移:20µV 電流 - 電源:260µA 電流 - 輸出 / 通道:20mA 電壓 - 電源，單路/雙路(±):2.7 V ~ 36 V，±1.35 V ~ 18 V 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:8-SOIC（0.154"，3.90mm 寬） 供應商設備封裝:8-SO 包裝:帶卷 (TR) |
| AD622AR-REEL7 | 功能描述:IC AMP INST LP 18MA 8SOIC RoHS:否 類別:集成電路 (IC) >> Linear - Amplifiers - Instrumentation 系列:- 標準包裝:1 系列:- 放大器類型:通用 電路數:4 輸出類型:滿擺幅 轉換速率:0.028 V/µs 增益帶寬積:105kHz -3db帶寬:- 電流 - 輸入偏壓:3nA 電壓 - 輸入偏移:100µV 電流 - 電源:3.3µA 電流 - 輸出 / 通道:12mA 電壓 - 電源，單路/雙路(±):2.7 V ~ 12 V，±1.35 V ~ 6 V 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:14-TSSOP（0.173"，4.40mm 寬） 供應商設備封裝:14-TSSOP 包裝:剪切帶 (CT) 其它名稱:OP481GRUZ-REELCT |
| AD622ARZ | 功能描述:IC AMP INST LP 18MA 8SOIC RoHS:是 類別:集成電路 (IC) >> Linear - Amplifiers - Instrumentation 系列:- 標準包裝:2,500 系列:- 放大器類型:通用 電路數:4 輸出類型:- 轉換速率:0.6 V/µs 增益帶寬積:1MHz -3db帶寬:- 電流 - 輸入偏壓:45nA 電壓 - 輸入偏移:2000µV 電流 - 電源:1.4mA 電流 - 輸出 / 通道:40mA 電壓 - 電源，單路/雙路(±):3 V ~ 32 V，±1.5 V ~ 16 V 工作溫度:0°C ~ 70°C 安裝類型:表面貼裝 封裝/外殼:14-TSSOP（0.173"，4.40mm 寬） 供應商設備封裝:14-TSSOP 包裝:帶卷 (TR) 其它名稱:LM324ADTBR2G-NDLM324ADTBR2GOSTR |
| AD622ARZ-R7 | 功能描述:IC AMP INST LP 18MA 8SOIC RoHS:是 類別:集成電路 (IC) >> Linear - Amplifiers - Instrumentation 系列:- 標準包裝:1 系列:- 放大器類型:通用 電路數:4 輸出類型:滿擺幅 轉換速率:0.028 V/µs 增益帶寬積:105kHz -3db帶寬:- 電流 - 輸入偏壓:3nA 電壓 - 輸入偏移:100µV 電流 - 電源:3.3µA 電流 - 輸出 / 通道:12mA 電壓 - 電源，單路/雙路(±):2.7 V ~ 12 V，±1.35 V ~ 6 V 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:14-TSSOP（0.173"，4.40mm 寬） 供應商設備封裝:14-TSSOP 包裝:剪切帶 (CT) 其它名稱:OP481GRUZ-REELCT |
發布緊急采購，3分鐘左右您將得到回復。